- 您现在的位置：买卖IC网 > PDF目录10943 > SPC5514EBMLQ66 (Freescale Semiconductor)MCU POWERPC AN15 FIXED 144-LQFP PDF资料下载
参数资料
| 型号： | SPC5514EBMLQ66 |
| 厂商： | Freescale Semiconductor |
| 文件页数： | 27/54页 |
| 文件大小： | 0K |
| 描述： | MCU POWERPC AN15 FIXED 144-LQFP |
| 标准包装： | 60 |
| 系列： | MPC55xx Qorivva |
| 核心处理器： | e200z1 |
| 芯体尺寸： | 32-位 |
| 速度： | 66MHz |
| 连通性： | CAN，EBI/EMI，I²C，SCI，SPI |
| 外围设备： | DMA，POR，PWM，WDT |
| 输入/输出数： | 111 |
| 程序存储器容量： | 512KB（512K x 8） |
| 程序存储器类型： | 闪存 |
| RAM 容量： | 32K x 8 |
| 电压 - 电源 (Vcc/Vdd)： | 4.5 V ~ 5.25 V |
| 数据转换器： | A/D 40x12b |
| 振荡器型： | 内部 |
| 工作温度： | -40°C ~ 125°C |
| 封装/外壳： | 144-LQFP |
| 包装： | 托盘 |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页当前第27页第28页第29页第30页第31页第32页第33页第34页第35页第36页第37页第38页第39页第40页第41页第42页第43页第44页第45页第46页第47页第48页第49页第50页第51页第52页第53页第54页
Electrical Characteristics
MPC5510 Microcontroller Family Data Sheet, Rev. 3
Freescale Semiconductor
33
2.9
FMPLL Electrical Characteristics
Table 14. FMPLL Electrical Specifications 1
1 V
DDSYN = 3.0V to 3.6 V, VSSSYN = 0 V, TA = TL to TH
Num
Characteristic
Symbol
Min.
Value
Max.
Value
Unit
1
System frequency2
-40 oC
≤ T
J ≤ 120
oC
-40 oC
≤ T
J ≤ 145
oC
2 The maximum value is without frequency modulation turned on. If frequency modulation is turned on, the maximum value
(average frequency) must be de-rated by the percentage of modulation enabled.
fsys
375
80000 3
66000
3 80 MHz is only available in the 208 pin package.
kHz
2
PLL Reference Frequency (output of predivider)
fpllref
410
MHz
3
VCO Frequency4
4 Optimum performance is achieved with the highest VCO frequency feasible based on the highest ERFD that results in the desired
PLL frequency.
fvco
192
500
MHz
4
PLL Frequency 5
-40 oC
≤ T
J ≤ 120
oC
-40 oC
≤ T
J ≤ 145
oC
5 The VCO frequency range is higher than the maximum allowable PLL frequency. The synthesizer control register 2’s enchanced
reduced frequency divider (FMPLL_SYNCR2[ERFD]) in enhanced operation mode must be programmed to divide the VCO
frequency within the PLL frequency range.
fpll
3
80 3
66
MHz
5
Loss of Reference Frequency 6
6 Loss of reference frequency is the reference frequency detected by the PLL which then transitions into self clocked mode.
fLOR
100
1000
kHz
6
Self Clocked Mode Frequency 7
7 Self clocked mode frequency is the frequency that the PLL operates at when the reference frequency falls below f
LOR.
fSCM
13
35
MHz
7
PLL Lock Time 8
8 This specification applies to the period required for the PLL to relock after changing the enhanced multiplication factor divider
(EMFD) bits in the synthesizer control register 1 (SYNCR1) in enhanced operation mode.
tlpll
—750
μs
8
Frequency un-LOCK Range
fUL
– 4.0
4.0
% fsys
9
Frequency LOCK Range
fLCK
– 2.0
2.0
% fsys
10
CLKOUT Cycle-to-cycle Jitter,9, 10
9 Jitter is the average deviation from the programmed frequency measured over the specified interval at maximum f
sys.
Measurements are made with the device powered by filtered supplies and clocked by a stable external clock signal. Noise
injected into the PLL circuitry via VDDSYN and VSSSYN and variation in crystal oscillator frequency increase the jitter percentage
for a given interval. CLKOUT divider set to divide-by-2.
10 Values are with frequency modulation disabled. If frequency modulation is enabled, jitter is the sum of C
jitter + Cmod.
Cjitter
– 5
5
% fclkout
10a
CLKOUT Jitter at 10 s period 9,10, 11
11 The PLL % jitter reduces with more cycles. 10 s was picked for a reference point for LIN (100 Kbits), slower speeds will have
even less % jitter.
Cjitter
– 0.05
0.05
% fclkout
11
Frequency Modulation Depth 1% Setting 12,13
(fsysMax must not be exceeded)
12 Modulation depth selected must not result in f
sys value greater than the fsys maximum specified value.
13 These depth ranges are obtained by filtering the raw cycle-to-cycle clock frequency data to eliminate the presence of the the
normal clock jitter riding on top of the FM waveform. The allowable modulation rates are 400 kHz to 1 MHz.
Cmod
0.5
2
%fsys
12
Frequency Modulation Depth 2% Setting 12,13
(fsysMax must not be exceeded)
Cmod
13
%fsys
相关PDF资料 |
PDF描述 |
|---|---|
| VI-BNL-IY-F2 | CONVERTER MOD DC/DC 28V 50W |
| MC908MR32CBE | IC MCU 32K FLASH 8.2MHZ 56-SDIP |
| VI-BNK-IY-F3 | CONVERTER MOD DC/DC 40V 50W |
| VI-BNJ-IY-F3 | CONVERTER MOD DC/DC 36V 50W |
| MCIMX355AVM5BR2 | IC MPU I.MX35 400MAPBGA |
相关代理商/技术参数 |
参数描述 |
|---|---|
| SPC5514EBVLQ48 | 制造商:Freescale Semiconductor 功能描述: |
| SPC5514EBVLQ66 | 制造商:Freescale Semiconductor 功能描述:MPC5514E AN15 FIXED - Bulk |
| SPC5514GAMLQ66 | 制造商:Freescale Semiconductor 功能描述:MPC5514E AN15 FIXED - Bulk |
| SPC5514GBMLQ66 | 功能描述:32位微控制器 - MCU AN15 FIXED RoHS:否 制造商:Texas Instruments 核心:C28x 处理器系列:TMS320F28x 数据总线宽度:32 bit 最大时钟频率:90 MHz 程序存储器大小:64 KB 数据 RAM 大小:26 KB 片上 ADC:Yes 工作电源电压:2.97 V to 3.63 V 工作温度范围:- 40 C to + 105 C 封装 / 箱体:LQFP-80 安装风格:SMD/SMT |
| SPC5515SAMLU66 | 功能描述:32位微控制器 - MCU 768KB FLASH 125C RoHS:否 制造商:Texas Instruments 核心:C28x 处理器系列:TMS320F28x 数据总线宽度:32 bit 最大时钟频率:90 MHz 程序存储器大小:64 KB 数据 RAM 大小:26 KB 片上 ADC:Yes 工作电源电压:2.97 V to 3.63 V 工作温度范围:- 40 C to + 105 C 封装 / 箱体:LQFP-80 安装风格:SMD/SMT |
发布紧急采购，3分钟左右您将得到回复。