参数资料
| 型号： | SPX2945M3-L-5-0/TR |
| 厂商： | Exar Corporation |
| 文件页数： | 5/12页 |
| 文件大小： | 0K |
| 描述： | IC REG LDO 5V .4A SOT223-3 |
| 标准包装： | 2,500 |
| 稳压器拓扑结构： | 正，固定式 |
| 输出电压： | 5V |
| 输入电压： | 最高 26V |
| 电压 - 压降（标准）： | 0.36V @ 400mA |
| 稳压器数量： | 1 |
| 电流 - 输出： | 400mA |
| 工作温度： | -40°C ~ 85°C |
| 安装类型： | 表面贴装 |
| 封装/外壳： | TO-261-4，TO-261AA |
| 供应商设备封装： | SOT-223 |
| 包装： | 带卷 (TR) |
Error Detection Comparator Output
The Comparator produces a logic low output
whenever the SPX2945 output falls out of regu-
lation by more than around 5%. This is around
60mV offset divided by the 1.235 reference
voltage. This trip level remains 5% below
normal regardless of the programmed output
voltage of the regulator. Figure 1 shows the
timing diagram depicting the ERROR signal
and the regulator output voltage as the SPX2945
input is ramped up and down. The ERROR
signal becomes low at around 1.3V input, and
goes high around 5V input (input voltage at
which V OUT = 4.75). Since the SPX2945’s
dropout voltage is load dependent, the input
voltage trip point (around 5V) will vary with the
load current. The output voltage trip point
(approx. 4.75V) does not vary with load.
The error comparator has an open-collector out-
put, which requires an external pull-up resistor.
Depending on the system requirements the re-
sistor may be returned to 5V output or other
supply voltage. In determining the value of this
resistor, note that the output is rated to sink
400 μ A; this value adds to battery drain in a low
battery condition. Suggested values range from
100K to 1M ? . If the output is unused this
resistor is not required.
Programming the Output Voltage of
SPX2945
The SPX2945 may be pin-strapped for 5V or
3.3V using its internal voltage divider by tying
Pin 1 (output) to Pin 2 (sense) and Pin 7 (feed-
back) to Pin 6 (5V/3.3V Tap).
Also, it may be programmed for any output
voltage between its 1.235V reference and its
20V maximum rating. As seen in Figure 2, an
external pair of resistors is required.
Refer to the below equation for the program-
ming of the output voltage::
V OUT = V REF x ( 1 + R 1 / R 2 )+ I FB R 1
2% in V OUT , which may be eliminated at room
temperature by trimming R 1 . To improve the
accuracy choose the value of R 2 = 100k; this
reduces the error by 0.17% and increases the
resistor program current by 12 μ A. Since the
SPX2945 typically draws 60 μ A at no load with
Pin 2 open-circuited this is a small price to pay.
Reducing Output Noise
It may be an advantage to reduce the AC noise
present at the output. One way is to reduce the
regulator bandwidth by increasing the size of
the output capacitor. This is the only way that
noise can be reduced on the 3 lead SPX2945 but
is relatively inefficient, as increasing the ca-
pacitor from 1 μ F to 220 μ F only decreases the
noise from 430 μ V to 160 μ V Vrms for a 100kHz
bandwidth at 5V output. Noise could also be
reduced fourfold by a bypass capacitor across
R 1 , since it reduces the high frequency gain from
4 to unity. Pick
C BYPASS ? 1 / 2 π R 1 x 200 Hz
or choose 0.01 μ F. When doing this, the output
capacitor must be increased to 3.3 μ F to main-
tain stability. These changes reduce the output
noise from 430 μ V to 100 μ V Vrms for a 100kHz
bandwidth at 5V output. With the bypass ca-
pacitor added, noise no longer scales with out-
put voltage so that improvements are more dra-
matic at higher output voltages.
4.75V
OUTPUT
VOLTAGE
_______
ERROR*
The V REF is 1.235 and I FB is the feedback bias
current, nominally -20nA. The minimum rec-
ommended load current of 1 μ A forces an upper
INPUT
VOLTAGE
+ 1.3V
+ 5.0V
+
+
limit of 1.2 M ? on value of R 2 . If no load is
presented the I FB produces an error of typically
* See Application Info.
Figure 1. ERROR Output Timing
Date: 3/14/06
SPX2945 400mA Low Dropout Voltage Regulator with Shutdown
5
?Copyright 2006 Sipex Corporation
相关PDF资料 |
PDF描述 |
|---|---|
| MIC5320-NDYMT TR | IC REG LDO 2.85V/1.85V 6-TMLF |
| MIC5320-LLYMT TR | IC REG LDO 2.7V .15A 6-TMLF |
| BA09CC0WFP-E2 | IC REG LDO 9V 1A TO252-5 |
| BA08CC0WFP-E2 | IC REG LDO 8V 1A TO252-5 |
| FSM10DSES-S243 | CONN EDGECARD 20POS .156 EYELET |
相关代理商/技术参数 |
参数描述 |
|---|---|
| SPX2945R | 制造商:SIPEX 制造商全称:Sipex Corporation 功能描述:500mA Low Drop Out Voltage Regulator with Shutdown |
| SPX2945R-3.3 | 制造商:SIPEX 制造商全称:Sipex Corporation 功能描述:500mA Low Drop Out Voltage Regulator with Shutdown |
| SPX2945R-3-3 | 制造商:SIPEX 制造商全称:Sipex Corporation 功能描述:400mA Low Dropout Voltage Regulator with Shutdown |
| SPX2945R-3-3TR | 制造商:SIPEX 制造商全称:Sipex Corporation 功能描述:400mA Low Dropout Voltage Regulator with Shutdown |
| SPX2945R-5.0 | 制造商:SIPEX 制造商全称:Sipex Corporation 功能描述:500mA Low Drop Out Voltage Regulator with Shutdown |
发布紧急采购，3分钟左右您将得到回复。