参数资料
| 型号： | SQ24T10050-NAB0 |
| 厂商： | Power-One |
| 文件页数： | 4/70页 |
| 文件大小： | 0K |
| 描述： | DC/DC EIGHTH BRICK |
| 标准包装： | 100 |
| 系列： | * |
第1页第2页第3页当前第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页第32页第33页第34页第35页第36页第37页第38页第39页第40页第41页第42页第43页第44页第45页第46页第47页第48页第49页第50页第51页第52页第53页第54页第55页第56页第57页第58页第59页第60页第61页第62页第63页第64页第65页第66页第67页第68页第69页第70页
SQ24 Series DC-DC Converter Data Sheet
18-36 VDC Input; Standard Outputs from 1-12 VDC
decrease the maximum current (originally obtained from the
derating curves) by the same percentage to ensure the
converter’s actual output power remains at or below the
maximum allowable output power.
Fig. C: Configuration for increasing output voltage .
To decrease the output voltage (Fig. D), a trim resistor,
R T-DECR , should be connected between the TRIM (Pin 6) and
SENSE(-) (Pin 5), with a value of:
Output Voltage Adjust /TRIM (Pin 6)
R T ? DECR ?
511
| Δ |
? 10.22
[k ? ]
(1.0 – 12V)
The converter’s output voltage can be adjusted up 10% or
down 20% for Vout ≥ 1.5V, and ± 10% for Vout = 1.2V and
1.0 V, relative to the rated output voltage by the addition of
an externally connected resistor. For output voltages 3.3V,
trim up to 10% is guaranteed only at Vin ≥ 20V, and it is
marginal (8% to 10%) at Vin = 18V depending on load
current.
The TRIM pin should be left open if trimming is not being
used. To minimize noise pickup, a 0.1 μF capacitor is
connected internally between the TRIM and SENSE(-) pins.
To increase the output voltage, refer to Fig. C. A trim
resistor, R T-INCR , should be connected between the TRIM
(Pin 6) and SENSE(+) (Pin 7), with a value of:
where,
R T ? DECR ? Required value of trim-down resistor [k ? ]
and Δ is as defined above.
Note: The above equations for calculation of trim resistor
values match those typically used in conventional industry-
standard quarter bricks and one-eighth bricks.
Converters with output voltage 1.2V and 1.0V have specific
trim schematic and equations, to provide the customers with
the flexibility of second sourcing. For these converters, the
last character of part number is “T”. More information about
trim feature, including corresponding schematic portions, can
be found in Application Note 103.
? 10.22 [k ? ] (1.5 –12V)
[k ? ] (1.2V)
Semi Q Family
R T ? INCR ?
R T ? INCR ?
5.11(100 ? Δ )V O ? NOM ? 626
1.225 Δ
485
Δ
Vin
Vin (+)
ON/OFF
Vin (-)
TM
Converter
(Top View)
Vout (+)
SENSE (+)
TRIM
SENSE (-)
Vout (-)
R T-DECR
Rload
R T ? INCR ?
323
Δ
? 2
[k ? ] (1.0V)
Fig. D: Configuration for decreasing output voltage.
where,
R T ? INCR ? Required value of trim-up resistor k ? ]
V O ? NOM ? Nominal value of output voltage [V]
Trimming/sensing beyond 110% of the rated output voltage
is not an acceptable design practice, as this condition could
cause unwanted triggering of the output over-voltage
protection (OVP) circuit. The designer should ensure that the
Δ ?
(V O -REQ ? V O -NOM )
V O - NOM
X 100 [%]
difference between the voltages across the converter’s
output pins and its sense pins does not exceed 10% of
V OUT ( NOM ) , or:
V O ? REQ ? Desired (trimmed) output voltage [V].
When trimming up, care must be taken not to exceed the
converter‘s maximum allowable output power. See previous
section for a complete discussion of this requirement.
[V OUT ( ? ) ? V OUT ( ? )] ? [V SENSE ( ? ) ? V SENSE ( ? )] ? V O - NOM X 10% [V]
This equation is applicable for any condition of output
sensing and/or output trim.
Semi Q Family
Vin (+)
TM
Converter
Vout (+)
(Top View)
SENSE (+)
R T-INCR
Vin
ON/OFF
TRIM
Rload
SENSE (-)
Vin (-)
Vout (-)
MCD10159 Rev. 1.2, 20-Apr-12
Page 4 of 70
www.power-one.com
相关PDF资料 |
PDF描述 |
|---|---|
| SQ24T10050-NEC0 | DC/DC EIGHTH BRICK |
| SQ24T15020-NEC0 | DC/DC EIGHTH BRICK |
| MC14518BDWR2G | IC COUNTER DUAL BCD 16-SOIC |
| 74LVX4245QSCX | IC TXRX DUAL 8BIT 3ST 24-QSOP |
| SQ24T15033-NAB0 | DC/DC EIGHTH BRICK |
相关代理商/技术参数 |
参数描述 |
|---|---|
| SQ24T10050-NAB0G | 制造商:Power-One 功能描述:DC/DC PS SGL-OUT 5V 10A 50W 8PIN QUARTER-BRICK - Bulk |
| SQ24T10050-NABP | 制造商:Power-One 功能描述:DC/DC PS SGL-OUT 5V 10A 50W 8PIN QUARTER-BRICK - Bulk |
| SQ24T10050-NABPG | 制造商:Power-One 功能描述:DC/DC PS SGL-OUT 5V 10A 50W 8PIN QUARTER-BRICK - Bulk |
| SQ24T10050-NAC0 | 制造商:Power-One 功能描述:DC/DC PS SGL-OUT 5V 10A 50W 8PIN QUARTER-BRICK - Bulk |
| SQ24T10050-NAC0G | 制造商:Power-One 功能描述:DC/DC PS SGL-OUT 5V 10A 50W 8PIN QUARTER-BRICK - Bulk 制造商:Power-One 功能描述:Module DC-DC 1-OUT 5V 10A 50W 8-Pin 1/8-Brick |
发布紧急采购，3分钟左右您将得到回复。