参数资料
型号: SQM48T25010-NDBP
厂商: Power-One
文件页数: 6/30页
文件大小: 0K
描述: DC/DC EIGHTH BRICK
标准包装: 310
系列: *
SQM48 Series Data Sheet
SemiQ
TM
Family 25A DC-DC Converters
The following pages contain specific plots or waveforms as-
sociated with the converter. Additional comments for specific
data are provided below.
Test Conditions
All data presented were taken with the converter soldered to
a test board, specifically a 0.060” thick printed wiring board
(PWB) with four layers. The top and bottom layers were not
metalized. The two inner layers, comprising two-ounce cop-
per, were used to provide traces for connectivity to the con-
verter.
The lack of metalization on the outer layers as well as the
limited thermal connection ensured that heat transfer from
the converter to the PWB was minimized. This provides a
worst-case but consistent scenario for thermal derating pur-
poses.
All measurements requiring airflow were made in vertical
and horizontal wind tunnel facilities using Infrared (IR) ther-
mography and thermocouples for thermometry.
Ensuring components on the converter do not exceed their
ratings is important to maintaining high reliability. If one an-
ticipates operating the converter at or close to the maximum
loads specified in the derating curves, it is prudent to check
actual operating temperatures in the application. Thermo-
graphic imaging is preferable; if this capability is not availa-
ble, then thermocouples may be used. Power-One recom-
mends the use of AWG #40 gauge thermocouples to ensure
measurement accuracy. Careful routing of the thermocouple
leads will further minimize measurement error. Refer to Fig-
ure H for optimum measuring thermocouple location.
Thermal Derating
Load current vs. ambient temperature and airflow rates are
given in Fig. x.1 for through-hole version. Ambient tempera-
ture was varied between 25 °C and 85 °C, with airflow rates
from 30 to 500 LFM (0.15 to 2.5 m/s), and vertical converter
mounting.
For each set of conditions, the maximum load current was
defined as the lowest of:
(i) The output current at which either any FET junction tem-
perature did not exceed a maximum specified temperature
(120°C) as indicated by the thermographic image, or
(ii) The nominal rating of the converter (25 A on 2.5 – 1.2 V).
During normal operation, derating curves with maximum FET
temperature less or equal to 120 °C should not be exceeded.
Temperature on the PCB at the thermocouple location
shown in Fig. H should not exceed 118 °C in order to oper-
ate inside the derating curves.
Efficiency
Efficiency vs. load current plot is shown in Fig. x.2 for am-
bient temperature of 25 oC, airflow rate of 300 LFM (1.5 m/s),
vertical converter mounting, and input voltages of 36 V, 48 V
and 72 V.
Start-up
Output voltage waveforms, during the turn-on transient using
the ON/OFF pin for full rated load currents (resistive load)
are shown without and with external load capacitance in Fig.
x.3 and Fig. x.4, respectively.
Ripple and Noise
Fig. x.7 shows the output voltage ripple waveform, measured
at full rated load current with a 10 μF tantalum and 1 μF ce-
ramic capacitor across the output. Note that all output vol-
tage waveforms are measured across a 1 ? F ceramic capa-
citor.
The input reflected ripple current waveforms are obtained
using the test setup shown in Fig x.8. The corresponding
waveforms are shown in Fig. x.9 and Fig. x.10.
MCD10085 Rev. 1.1, 08-Jul-10
Page 6 of 30
www.power-one.com
相关PDF资料
PDF描述
74LVC1G07GW/DG,125 IC BUFF OPEN DRAIN N-INV 5TSSOP
SQM48T25010-NDC0 DC/DC EIGHTH BRICK
SQM48T25010-NDCP DC/DC EIGHTH BRICK
74LVC1G07GW,125 IC BUFF OPEN DRAIN N-INV 5TSSOP
SQM48T25010-NEC0 DC/DC EIGHTH BRICK
相关代理商/技术参数
参数描述
SQM48T25010-NDBPG 制造商:Power-One 功能描述:DCDC,HAZMAT - Bulk
SQM48T25010-NDC0 功能描述:DC/DC EIGHTH BRICK RoHS:否 类别:电源 - 板载 >> DC DC Converters 系列:* 标准包装:250 系列:*
SQM48T25010-NDCP 功能描述:DC/DC EIGHTH BRICK RoHS:否 类别:电源 - 板载 >> DC DC Converters 系列:* 标准包装:250 系列:*
SQM48T25010-NDCPG 制造商:Power-One 功能描述:DCDC,HAZMAT - Bulk
SQM48T25010-NEC0 功能描述:DC/DC EIGHTH BRICK RoHS:否 类别:电源 - 板载 >> DC DC Converters 系列:* 标准包装:250 系列:*