- 您现在的位置：买卖IC网 > PDF目录98142 > SST55LD017D-40-C-TQWE (SILICON STORAGE TECHNOLOGY INC) FLASH MEMORY DRIVE CONTROLLER, PQFP100 PDF资料下载
参数资料
| 型号： | SST55LD017D-40-C-TQWE |
| 厂商： | SILICON STORAGE TECHNOLOGY INC |
| 元件分类： | 存储控制器/管理单元 |
| 英文描述： | FLASH MEMORY DRIVE CONTROLLER, PQFP100 |
| 封装： | TQFP-100 |
| 文件页数： | 26/59页 |
| 文件大小： | 702K |
| 代理商： | SST55LD017D-40-C-TQWE |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页当前第26页第27页第28页第29页第30页第31页第32页第33页第34页第35页第36页第37页第38页第39页第40页第41页第42页第43页第44页第45页第46页第47页第48页第49页第50页第51页第52页第53页第54页第55页第56页第57页第58页第59页
32
EOL Product Document
ATA Flash Disk Controller
SST55LD017D
2006 Silicon Storage Technology, Inc.
S71225-01-EOL
4/06
11.2.1.15 Set-Features - EFH
This command is used by the host to establish or select certain features. Table 11-5 defines all features
that are supported.
Features 01H and 81H are used to enable and clear 8-bit data transfer mode. If the 01H feature
command is issued all data transfers will occur on the low order D7-D0 data bus and the IOCS16#
signal will not be asserted for data register accesses.
Features 55H and BBH are the default features for the ATA Flash Disk Controller; thus, the host does
not have to issue this command with these features unless it is necessary for compatibility reasons.
Features 66H and CCH can be used to enable and disable whether the Power On Reset (POR)
Defaults will be set when a software Reset occurs.
Bit ->
76543210
Command (7)
EFH
C/D/H (6)
XDrive
X
Cyl High (5)
X
Cyl Low (4)
X
Sec Num (3)
X
Sec Cnt (2)
X
Feature (1)
Feature
TABLE 11-5: FEATURES SUPPORTED
Feature
Operation
01H
Enable 8-bit data transfers.
03H
Set transfer mode based on value in Sector Count register. Table 11-6 defines the values.
55H
Disable Read Look Ahead.
66H
Disable Power on Reset (POR) establishment of defaults at software Reset.
69H
NOP - Accepted for backward compatibility.
81H
Disable 8-bit data transfer.
96H
NOP - Accepted for backward compatibility.
97H
Accepted for backward compatibility. Use of this Feature is not recommended.
9AH
NOP - accepted for compatibility.
BBH
4 Bytes of data apply on Read/Write-Long-Sector commands.
CCH
Enable Power on Reset (POR) establishment of defaults at software Reset.
T11-5.0 1225
TABLE 11-6: TRANSFER MODE VALUES
Mode
Bits [7:3]
Bits [2:0]
PIO default mode
00000b
000b
PIO default mode, disable IORDY
00000b
001b
PIO flow control transfer mode
00001b
mode1
1. Mode = transfer mode number, all other values are not valid
Reserved
Other
N/A
T11-6.0 1225
相关PDF资料 |
PDF描述 |
|---|---|
| SST55LD017D-40-I-TQW | FLASH MEMORY DRIVE CONTROLLER, PQFP100 |
| SST55LD019A-45-C-TQPE | FLASH MEMORY DRIVE CONTROLLER, PQFP64 |
| SST55LD019C-45-I-BWE | FLASH MEMORY DRIVE CONTROLLER, PBGA84 |
| SST55LD019B-45-C-TQW | FLASH MEMORY DRIVE CONTROLLER, PQFP100 |
| SST55LD019C-45-C-BWE | FLASH MEMORY DRIVE CONTROLLER, PBGA84 |
相关代理商/技术参数 |
参数描述 |
|---|---|
| SST55LD019 | 制造商:SST 制造商全称:Silicon Storage Technology, Inc 功能描述:ATA Flash Disk Controller |
| SST55LD019A | 制造商:SST 制造商全称:Silicon Storage Technology, Inc 功能描述:ATA Flash Disk Controller |
| SST55LD019A-45-C-BWE | 功能描述:总线收发器 ATA Media 45MHz 3.3V Commercial RoHS:否 制造商:Fairchild Semiconductor 逻辑类型:CMOS 逻辑系列:74VCX 每芯片的通道数量:16 输入电平:CMOS 输出电平:CMOS 输出类型:3-State 高电平输出电流:- 24 mA 低电平输出电流:24 mA 传播延迟时间:6.2 ns 电源电压-最大:2.7 V, 3.6 V 电源电压-最小:1.65 V, 2.3 V 最大工作温度:+ 85 C 封装 / 箱体:TSSOP-48 封装:Reel |
| SST55LD019A-45-C-MVWE | 制造商:SST 制造商全称:Silicon Storage Technology, Inc 功能描述:ATA Flash Disk Controller |
| SST55LD019A-45-C-TQWE | 功能描述:总线收发器 ATA Media 45MHz 3.3V Commercial RoHS:否 制造商:Fairchild Semiconductor 逻辑类型:CMOS 逻辑系列:74VCX 每芯片的通道数量:16 输入电平:CMOS 输出电平:CMOS 输出类型:3-State 高电平输出电流:- 24 mA 低电平输出电流:24 mA 传播延迟时间:6.2 ns 电源电压-最大:2.7 V, 3.6 V 电源电压-最小:1.65 V, 2.3 V 最大工作温度:+ 85 C 封装 / 箱体:TSSOP-48 封装:Reel |
发布紧急采购，3分钟左右您将得到回复。