参数资料
| 型号： | ST16C2450CQ48-F |
| 厂商： | Exar Corporation |
| 文件页数： | 5/30页 |
| 文件大小： | 0K |
| 描述： | IC UART FIFO DUAL 48TQFP |
| 标准包装： | 250 |
| 特点： | * |
| 通道数： | 2，DUART |
| FIFO's： | 1 字节 |
| 规程： | RS232 |
| 电源电压： | 2.97 V ~ 5.5 V |
| 带故障启动位检测功能： | 是 |
| 带调制解调器控制功能： | 是 |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 48-TQFP |
| 供应商设备封装： | 48-TQFP（7x7） |
| 包装： | 托盘 |
第1页第2页第3页第4页当前第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页
xr
ST16C2450
REV. 4.0.1
2.97V TO 5.5V DUART
13
4.3.1
Interrupt Mode Operation
When the receive interrupt (IER BIT-0 = 1) is enabled, the RHR interrupt (see ISR bit-2) status will reflect the
following:
A. The receive data available interrupts are issued to the host when there is a character in the RHR. It will be
cleared when the character has been read out of the RHR.
B. The receive data ready bit (LSR BIT-0) is set as soon as a character is transferred from the shift register to
the receive FIFO. It is reset when the RHR is empty.
4.3.2
Polled Mode Operation
Since the receiver and transmitter have separate bits in the LSR either or both can be used in the polled mode
by selecting respective transmit or receive control bit(s).
A. LSR BIT-0 indicates there is data in the RHR.
B. LSR BIT-1 indicates an overrun error has occurred and that data in the RHR may not be valid.
C. LSR BIT 2-4 provides the type of receive data errors encountered for the data byte in RHR, if any.
D. LSR BIT-5 indicates THR is empty.
E. LSR BIT-6 indicates when both the THR and TSR are empty.
IER[0]: RHR Interrupt Enable
The receive data ready interrupt will be issued when RHR has a data character.
Logic 0 = Disable the receive data ready interrupt (default).
Logic 1 = Enable the receiver data ready interrupt.
IER[1]: THR Interrupt Enable
This bit enables the Transmit Ready interrupt which is issued whenever the Transmit FIFO becomes empty. If
the Transmit FIFO is empty when this bit is enabled, an interrupt will be generated.
Logic 0 = Disable Transmit Ready interrupt (default).
Logic 1 = Enable Transmit Ready interrupt.
IER[2]: Receive Line Status Interrupt Enable
If any of the LSR register bits 1, 2, 3 or 4 is a logic 1, it will generate an interrupt to inform the host controller
about the error status of the current data byte in FIFO.
Logic 0 = Disable the receiver line status interrupt (default).
Logic 1 = Enable the receiver line status interrupt.
IER[3]: Modem Status Interrupt Enable
Logic 0 = Disable the modem status register interrupt (default).
Logic 1 = Enable the modem status register interrupt.
IER[7:4]: Reserved
4.4
Interrupt Status Register (ISR) - Read-Only
The UART provides multiple levels of prioritized interrupts to minimize external software interaction. The
Interrupt Status Register (ISR) provides the user with four interrupt status bits. Performing a read cycle on the
ISR will give the user the current highest pending interrupt level to be serviced, others are queued up to be
serviced next. No other interrupts are acknowledged until the pending interrupt is serviced. The Interrupt
Source Table, Table 6, shows the data values (bits 0-3) for the interrupt priority levels and the interrupt sources
associated with each of these interrupt levels.
相关PDF资料 |
PDF描述 |
|---|---|
| XR16C2550IM-F | IC UART FIFO 16B DUAL 48TQFP |
| XR88C92IJTR-F | IC UART FIFO DUAL 44PLCC |
| XR16V2652IL-F | IC UART FIFO 32B DUAL 32QFN |
| XR16V2650IL-F | IC UART FIFO 32B DUAL 32QFN |
| ATMEGA324A-MCHR | IC MCU AVR 32K 20MHZ 44QFN |
相关代理商/技术参数 |
参数描述 |
|---|---|
| ST16C2450CQ48TR-F | 制造商:Exar Corporation 功能描述:UART 2-CH 1Byte FIFO 3.3V/5V 48-Pin TQFP T/R 制造商:Exar Corporation 功能描述:ST16C2450CQ48TR-F |
| ST16C2450IJ44 | 制造商:Rochester Electronics LLC 功能描述: 制造商:Exar Corporation 功能描述: |
| ST16C2450IJ44-F | 功能描述:UART 接口集成电路 DUAL UART RoHS:否 制造商:Texas Instruments 通道数量:2 数据速率:3 Mbps 电源电压-最大:3.6 V 电源电压-最小:2.7 V 电源电流:20 mA 最大工作温度:+ 85 C 最小工作温度:- 40 C 封装 / 箱体:LQFP-48 封装:Reel |
| ST16C2450IJ44TR-F | 制造商:Exar Corporation 功能描述:UART 2-CH 1Byte FIFO 3.3V/5V 44-Pin PLCC T/R 制造商:Exar Corporation 功能描述:ST16C2450 Series 1.5 Mbps 5.5 V Dual Surface Mount UART - PLCC-44 制造商:Exar Corporation 功能描述:ST16C2450IJ44TR-F |
| ST16C2450IP40 | 功能描述:UART 接口集成电路 DUAL UART RoHS:否 制造商:Texas Instruments 通道数量:2 数据速率:3 Mbps 电源电压-最大:3.6 V 电源电压-最小:2.7 V 电源电流:20 mA 最大工作温度:+ 85 C 最小工作温度:- 40 C 封装 / 箱体:LQFP-48 封装:Reel |
发布紧急采购，3分钟左右您将得到回复。