- 您现在的位置：买卖IC网 > PDF目录380730 > ST7FSCR1R4T1 (意法半导体) 8-BIT LOW-POWER, FULL-SPEED USB MCU WITH 16K FLASH, 768 RAM, SMARTCARD I/F, TIMER PDF资料下载
参数资料
| 型号： | ST7FSCR1R4T1 |
| 厂商： | 意法半导体 |
| 英文描述： | 8-BIT LOW-POWER, FULL-SPEED USB MCU WITH 16K FLASH, 768 RAM, SMARTCARD I/F, TIMER |
| 中文描述： | 8位低功耗，全速USB微控制器与16K的闪存，768内存，智能卡的I /楼，计时器 |
| 文件页数： | 28/102页 |
| 文件大小： | 1413K |
| 代理商： | ST7FSCR1R4T1 |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页当前第28页第29页第30页第31页第32页第33页第34页第35页第36页第37页第38页第39页第40页第41页第42页第43页第44页第45页第46页第47页第48页第49页第50页第51页第52页第53页第54页第55页第56页第57页第58页第59页第60页第61页第62页第63页第64页第65页第66页第67页第68页第69页第70页第71页第72页第73页第74页第75页第76页第77页第78页第79页第80页第81页第82页第83页第84页第85页第86页第87页第88页第89页第90页第91页第92页第93页第94页第95页第96页第97页第98页第99页第100页第101页第102页
ST7SCR
28/102
1
8 POWER SAVING MODES
8.1 INTRODUCTION
To give a large measure of flexibility to the applica-
tion in terms of power consumption, two main pow-
er saving modes are implemented in the ST7.
After a RESET the normal operating mode is se-
lected by default (RUN mode). This mode drives
the device (CPU and embedded peripherals) by
means of a master clock which is based on the
main oscillator frequency.
From Run mode, the different power saving
modes may be selected by setting the relevant
register bits or by calling the specific ST7 software
instruction whose action depends on the oscillator
status.
8.2 WAIT MODE
WAIT mode places the MCU in a low power con-
sumption mode by stopping the CPU.
This power saving mode is selected by calling the
“WFI” ST7 software instruction.
All peripherals remain active. During WAIT mode,
the I bit of the CC register is forced to 0, to enable
all interrupts. All other registers and memory re-
main unchanged. The MCU remains in WAIT
mode until an interrupt or Reset occurs, whereup-
on the Program Counter branches to the starting
address of the interrupt or Reset service routine.
The MCU will remain in WAIT mode until a Reset
or an Interrupt occurs, causing it to wake up.
Refer to
Figure 19
.
Figure 19. WAIT Mode Flow Chart
WFI INSTRUCTION
RESET
INTERRUPT
Y
N
N
Y
CPU CLOCK
I-BIT
OSCILLATOR
PERIPH. CLOCK
ON
ON
OFF
CLEARED
CPU CLOCK
I-BIT
OSCILLATOR
PERIPH. CLOCK
ON
ON
ON
SET
FETCH RESET VECTOR
OR SERVICE INTERRUPT
512 CPU CLOCK
CYCLES DELAY
IF RESET
Note:
Before servicing an interrupt, the CC
register is pushed on the stack. The I-Bit is set
during the interrupt routine and cleared when
the CC register is popped.
相关PDF资料 |
PDF描述 |
|---|---|
| ST72SCR1R4T1 | 8-BIT LOW-POWER, FULL-SPEED USB MCU WITH 16K FLASH, 768 RAM, SMARTCARD I/F, TIMER |
| ST72FSCR1R4T1 | 8-BIT LOW-POWER, FULL-SPEED USB MCU WITH 16K FLASH, 768 RAM, SMARTCARD I/F, TIMER |
| ST72PSCR1R4T1 | 8-BIT LOW-POWER, FULL-SPEED USB MCU WITH 16K FLASH, 768 RAM, SMARTCARD I/F, TIMER |
| ST72SCR1x4M1 | CKTBKR |
| ST72FSCR1x4M1 | CKTBKR |
相关代理商/技术参数 |
参数描述 |
|---|---|
| ST7FUS-PRIMER | 功能描述:程序设计器 - 基于处理器 Low-Cost Eval Dev Tool Pack RoHS:否 制造商:Olimex Ltd. 产品:Programmers 工具用于评估:XMEGA, MegaAVR, tinyAVR 核心:AVR 接口类型:USB 工作电源电压:1.8 V to 5.5 V |
| ST7FUS-SK/RAIS | 制造商:STMicroelectronics 功能描述:Evaluation and Application Development with ST7Ultralite |
| ST7GEME4 | 制造商:STMICROELECTRONICS 制造商全称:STMicroelectronics 功能描述:Full-speed USB MCU with smartcard firmware and EMV/non-EMV interface |
| ST7GEME4M1 | 制造商:STMicroelectronics 功能描述: |
| ST7GEME4U1 | 制造商:STMicroelectronics 功能描述: |
发布紧急采购，3分钟左右您将得到回复。