参数资料
型号: STM32F101R8T6AXX
厂商: STMICROELECTRONICS
元件分类: 微控制器/微处理器
英文描述: 32-BIT, FLASH, 36 MHz, RISC MICROCONTROLLER, PQFP64
封装: 10 X 10 MM, 0.50 MM PITCH, ROHS COMPLIANT, LQFP-64
文件页数: 4/75页
文件大小: 1552K
代理商: STM32F101R8T6AXX
Description
STM32F101x6, STM32F101x8, STM32F101xB
interrupt service routine can then generate a warning message and/or put the MCU into a
safe state. The PVD is enabled by software.
VPOR/PDR and VPVD.
Voltage regulator
The regulator has three operation modes: main (MR), low power (LPR) and power down.
MR is used in the nominal regulation mode (Run)
LPR is used in the Stop mode
Power down is used in Standby mode: the regulator output is in high impedance: the
kernel circuitry is powered down, inducing zero consumption (but the contents of the
registers and SRAM are lost)
This regulator is always enabled after reset. It is disabled in Standby mode, providing high
impedance output.
Low-power modes
The STM32F101xx Medium-density access line supports three low-power modes to achieve
the best compromise between low power consumption, short startup time and available
wakeup sources:
Sleep mode
In Sleep mode, only the CPU is stopped. All peripherals continue to operate and can
wake up the CPU when an interrupt/event occurs.
Stop mode
Stop mode achieves the lowest power consumption while retaining the content of
SRAM and registers. All clocks in the 1.8 V domain are stopped, the PLL, the HSI RC
and the HSE crystal oscillators are disabled. The voltage regulator can also be put
either in normal or in low power mode.
The device can be woken up from Stop mode by any of the EXTI line. The EXTI line
source can be one of the 16 external lines, the PVD output or the RTC alarm.
Standby mode
The Standby mode is used to achieve the lowest power consumption. The internal
voltage regulator is switched off so that the entire 1.8 V domain is powered off. The
PLL, the HSI RC and the HSE crystal oscillators are also switched off. After entering
Standby mode, SRAM and register contents are lost except for registers in the Backup
domain and Standby circuitry.
The device exits Standby mode when an external reset (NRST pin), a IWDG reset, a
rising edge on the WKUP pin, or an RTC alarm occurs.
Note:
The RTC, the IWDG, and the corresponding clock sources are not stopped by entering Stop
or Standby mode.
DMA
The flexible 7-channel general-purpose DMA is able to manage memory-to-memory,
peripheral-to-memory and memory-to-peripheral transfers. The DMA controller supports
circular buffer management avoiding the generation of interrupts when the controller
reaches the end of the buffer.
相关PDF资料
PDF描述
STM32F101V8T6AXX 32-BIT, FLASH, 36 MHz, RISC MICROCONTROLLER, PQFP100
STM32F101VBT6AXX 32-BIT, FLASH, 36 MHz, RISC MICROCONTROLLER, PQFP100
STM32F101R8T6XXX 32-BIT, FLASH, 36 MHz, RISC MICROCONTROLLER, PQFP64
STM32F101R8T6TR 32-BIT, FLASH, 36 MHz, RISC MICROCONTROLLER, PQFP64
STM32F101RBT6TR 32-BIT, FLASH, 36 MHz, RISC MICROCONTROLLER, PQFP64
相关代理商/技术参数
参数描述
STM32F101R8T6TR 功能描述:ARM微控制器 - MCU 32BIT Cortex M3 Access Line RoHS:否 制造商:STMicroelectronics 核心:ARM Cortex M4F 处理器系列:STM32F373xx 数据总线宽度:32 bit 最大时钟频率:72 MHz 程序存储器大小:256 KB 数据 RAM 大小:32 KB 片上 ADC:Yes 工作电源电压:1.65 V to 3.6 V, 2 V to 3.6 V, 2.2 V to 3.6 V 工作温度范围:- 40 C to + 85 C 封装 / 箱体:LQFP-48 安装风格:SMD/SMT
STM32F101R8T6XXX 制造商:STMICROELECTRONICS 制造商全称:STMicroelectronics 功能描述:Medium-density access line, ARM-based 32-bit MCU with 64 or 128 KB Flash, 6 timers, ADC and 7 communication interfaces
STM32F101R8U6TR 制造商:STMICROELECTRONICS 制造商全称:STMicroelectronics 功能描述:Medium-density access line, ARM-based 32-bit MCU with 64 or 128 KB Flash, 6 timers, ADC and 7 communication interfaces
STM32F101R8U6XXX 制造商:STMICROELECTRONICS 制造商全称:STMicroelectronics 功能描述:Medium-density access line, ARM-based 32-bit MCU with 64 or 128 KB Flash, 6 timers, ADC and 7 communication interfaces
STM32F101RB 制造商:STMICROELECTRONICS 制造商全称:STMicroelectronics 功能描述:Medium-density access line, ARM-based 32-bit MCU with 64 or 128 KB Flash, 6 timers, ADC and 7 communication interfaces