参数资料
型号: STM32F101T4U6ATR
厂商: STMICROELECTRONICS
元件分类: 微控制器/微处理器
英文描述: 32-BIT, FLASH, 36 MHz, RISC MICROCONTROLLER, QCC36
封装: 6 X 6 MM, 0.50 MM PITCH, ROHS COMPLIANT, VFQFPN-36
文件页数: 9/77页
文件大小: 1203K
代理商: STM32F101T4U6ATR
STM32F101x4, STM32F101x6
Description
Doc ID 15058 Rev 4
than the VPVD threshold. The interrupt service routine can then generate a warning
message and/or put the MCU into a safe state. The PVD is enabled by software.
VPOR/PDR and VPVD.
2.3.11
Voltage regulator
The regulator has three operation modes: main (MR), low power (LPR) and power down.
MR is used in the nominal regulation mode (Run)
LPR is used in the Stop mode
Power down is used in Standby mode: the regulator output is in high impedance: the
kernel circuitry is powered down, inducing zero consumption (but the contents of the
registers and SRAM are lost)
This regulator is always enabled after reset. It is disabled in Standby mode, providing high
impedance output.
2.3.12
Low-power modes
The STM32F101xx Low-density access line supports three low-power modes to achieve the
best compromise between low power consumption, short startup time and available wakeup
sources:
Sleep mode
In Sleep mode, only the CPU is stopped. All peripherals continue to operate and can
wake up the CPU when an interrupt/event occurs.
Stop mode
Stop mode achieves the lowest power consumption while retaining the content of
SRAM and registers. All clocks in the 1.8 V domain are stopped, the PLL, the HSI RC
and the HSE crystal oscillators are disabled. The voltage regulator can also be put
either in normal or in low power mode.
The device can be woken up from Stop mode by any of the EXTI line. The EXTI line
source can be one of the 16 external lines, the PVD output or the RTC alarm.
Standby mode
The Standby mode is used to achieve the lowest power consumption. The internal
voltage regulator is switched off so that the entire 1.8 V domain is powered off. The
PLL, the HSI RC and the HSE crystal oscillators are also switched off. After entering
Standby mode, SRAM and register contents are lost except for registers in the Backup
domain and Standby circuitry.
The device exits Standby mode when an external reset (NRST pin), a IWDG reset, a
rising edge on the WKUP pin, or an RTC alarm occurs.
Note:
The RTC, the IWDG, and the corresponding clock sources are not stopped by entering Stop
or Standby mode.
2.3.13
DMA
The flexible 7-channel general-purpose DMA is able to manage memory-to-memory,
peripheral-to-memory and memory-to-peripheral transfers. The DMA controller supports
circular buffer management avoiding the generation of interrupts when the controller
reaches the end of the buffer.
相关PDF资料
PDF描述
STM32F101T6U6AXXX 32-BIT, FLASH, 36 MHz, RISC MICROCONTROLLER, QCC36
STM32F101C6U6ATR 32-BIT, FLASH, 36 MHz, RISC MICROCONTROLLER, QCC48
STM32F101C4U6XXX 32-BIT, FLASH, 36 MHz, RISC MICROCONTROLLER, QCC48
STM32F103C6T7ATR 32-BIT, FLASH, 72 MHz, RISC MICROCONTROLLER, PQFP48
STM32F103C4T7XXX 32-BIT, FLASH, 72 MHz, RISC MICROCONTROLLER, PQFP48
相关代理商/技术参数
参数描述
STM32F101T4U6AXXX 制造商:STMICROELECTRONICS 制造商全称:STMicroelectronics 功能描述:Low-density access line, ARM-based 32-bit MCU with 16 or 32 KB Flash, 5 timers, ADC and 4 communication interfaces
STM32F101T4U6TR 制造商:STMICROELECTRONICS 制造商全称:STMicroelectronics 功能描述:Low-density access line, ARM-based 32-bit MCU with 16 or 32 KB Flash, 5 timers, ADC and 4 communication interfaces
STM32F101T4U6XXX 制造商:STMICROELECTRONICS 制造商全称:STMicroelectronics 功能描述:Low-density access line, ARM-based 32-bit MCU with 16 or 32 KB Flash, 5 timers, ADC and 4 communication interfaces
STM32F101T6 制造商:STMICROELECTRONICS 制造商全称:STMicroelectronics 功能描述:Low-density access line, ARM-based 32-bit MCU with 16 or 32 KB Flash, 5 timers, ADC and 4 communication interfaces
STM32F101T6T6ATR 制造商:STMICROELECTRONICS 制造商全称:STMicroelectronics 功能描述:Low-density access line, ARM-based 32-bit MCU with 16 or 32 KB Flash, 5 timers, ADC and 4 communication interfaces