参数资料
型号: STM32F207VET6TR
厂商: STMICROELECTRONICS
元件分类: 微控制器/微处理器
英文描述: 32-BIT, FLASH, 120 MHz, RISC MICROCONTROLLER, PQFP100
封装: 14 X 14 MM, ROHS COMPLIANT, LQFP-100
文件页数: 88/163页
文件大小: 2275K
代理商: STM32F207VET6TR
Description
STM32F205xx, STM32F207xx
Doc ID 15818 Rev 7
2.2.32
Controller area network (CAN)
The two CANs are compliant with the 2.0A and B (active) specifications with a bitrate up to 1
Mbit/s. They can receive and transmit standard frames with 11-bit identifiers as well as
extended frames with 29-bit identifiers. Each CAN has three transmit mailboxes, two receive
FIFOS with 3 stages and 28 shared scalable filter banks (all of them can be used even if one
CAN is used). The 256 bytes of SRAM which are allocated for each CAN are not shared
with any other peripheral.
2.2.33
Universal serial bus on-the-go full-speed (OTG_FS)
The STM32F205xx and STM32F207xx embed an USB OTG full-speed device/host/OTG
peripheral with integrated transceivers. The USB OTG FS peripheral is compliant with the
USB 2.0 specification and with the OTG 1.0 specification. It has software-configurable
endpoint setting and supports suspend/resume. The USB OTG full-speed controller
requires a dedicated 48 MHz clock that is generated by a PLL connected to the HSE
oscillator. The major features are:
Combined Rx and Tx FIFO size of 320 × 35 bits with dynamic FIFO sizing
Supports the session request protocol (SRP) and host negotiation protocol (HNP)
4 bidirectional endpoints
8 host channels with periodic OUT support
HNP/SNP/IP inside (no need for any external resistor)
For OTG/Host modes, a power switch is needed in case bus-powered devices are
connected
Internal FS OTG PHY support
External FS OTG PHY support through an I2C connection
2.2.34
Universal serial bus on-the-go high-speed (OTG_HS)
The STM32F205xx and STM32F207xx devices embed a USB OTG high-speed (up to
480 Mb/s) device/host/OTG peripheral. The USB OTG HS supports both full-speed and
high-speed operations. It integrates the transceivers for full-speed operation (12 MB/s) and
features a UTMI low-pin interface (ULPI) for high-speed operation (480 MB/s). When using
the USB OTG HS in HS mode, an external PHY device connected to the ULPI is required.
The USB OTG HS peripheral is compliant with the USB 2.0 specification and with the OTG
1.0 specification. It has software-configurable endpoint setting and supports
相关PDF资料
PDF描述
STM32F205RBY6TR 32-BIT, FLASH, 120 MHz, RISC MICROCONTROLLER, PBGA66
STM32F205RBY7TR 32-BIT, FLASH, 120 MHz, RISC MICROCONTROLLER, PBGA66
STM32F205RBY7XXX 32-BIT, FLASH, 120 MHz, RISC MICROCONTROLLER, PBGA66
STM32F205RCT6TR 32-BIT, FLASH, 120 MHz, RISC MICROCONTROLLER, PQFP64
STM32F205RCT7XXX 32-BIT, FLASH, 120 MHz, RISC MICROCONTROLLER, PQFP64
相关代理商/技术参数
参数描述
STM32F207VFT6 功能描述:ARM微控制器 - MCU 32BIT ARM Cortex M3 Connectivity 768kB RoHS:否 制造商:STMicroelectronics 核心:ARM Cortex M4F 处理器系列:STM32F373xx 数据总线宽度:32 bit 最大时钟频率:72 MHz 程序存储器大小:256 KB 数据 RAM 大小:32 KB 片上 ADC:Yes 工作电源电压:1.65 V to 3.6 V, 2 V to 3.6 V, 2.2 V to 3.6 V 工作温度范围:- 40 C to + 85 C 封装 / 箱体:LQFP-48 安装风格:SMD/SMT
STM32F207VFT6TR 功能描述:32位微控制器 - MCU High Perf ARM 32Bit 768kB Flash 100-Pin RoHS:否 制造商:Texas Instruments 核心:C28x 处理器系列:TMS320F28x 数据总线宽度:32 bit 最大时钟频率:90 MHz 程序存储器大小:64 KB 数据 RAM 大小:26 KB 片上 ADC:Yes 工作电源电压:2.97 V to 3.63 V 工作温度范围:- 40 C to + 105 C 封装 / 箱体:LQFP-80 安装风格:SMD/SMT
STM32F207VGT6 功能描述:ARM微控制器 - MCU 32BIT ARM Cortex M3 Connectivity 1024kB RoHS:否 制造商:STMicroelectronics 核心:ARM Cortex M4F 处理器系列:STM32F373xx 数据总线宽度:32 bit 最大时钟频率:72 MHz 程序存储器大小:256 KB 数据 RAM 大小:32 KB 片上 ADC:Yes 工作电源电压:1.65 V to 3.6 V, 2 V to 3.6 V, 2.2 V to 3.6 V 工作温度范围:- 40 C to + 85 C 封装 / 箱体:LQFP-48 安装风格:SMD/SMT
STM32F207VGT6J 制造商:STMicroelectronics 功能描述:MCU 32BIT CORTEX-M3 120MHZ LQFP-100 制造商:STMicroelectronics 功能描述:MCU, 32BIT, CORTEX-M3, 120MHZ, LQFP-100 制造商:STMicroelectronics 功能描述:MCU, 32BIT, CORTEX-M3, 120MHZ, LQFP-100, Controller Family/Series:STM32F, Core S
STM32F207VGT7 功能描述:ARM微控制器 - MCU 32-Bit ARM Cortex 1024kb Connectivity RoHS:否 制造商:STMicroelectronics 核心:ARM Cortex M4F 处理器系列:STM32F373xx 数据总线宽度:32 bit 最大时钟频率:72 MHz 程序存储器大小:256 KB 数据 RAM 大小:32 KB 片上 ADC:Yes 工作电源电压:1.65 V to 3.6 V, 2 V to 3.6 V, 2.2 V to 3.6 V 工作温度范围:- 40 C to + 85 C 封装 / 箱体:LQFP-48 安装风格:SMD/SMT