参数资料
型号: SX1223SK433
厂商: Semtech
文件页数: 10/25页
文件大小: 0K
描述: KIT STARTER FOR XE1223 433MHZ
产品培训模块: SX1223 ISM Transmitter
标准包装: 1
类型: 发射器,UHF
频率: 433MHz
适用于相关产品: XE1223(433MHz)
已供物品: 2 个板,2 个模块,2 根天线,线缆,文档
产品目录页面: 584 (CN2011-ZH PDF)
SX1223
4.1.4
Charge Pump
The charge pump current can be set to either 125 or 500 μ A by the CP_HI bit. The default value at power-up is 125
μ A (CP_HI = ‘0’). The choice of this current affects the loop filter component values (see section 4.1.5). For most
applications the lowest current mode is recommended. For those applications using a high phase detector
frequency and a high PLL bandwidth, 500 μ A may provide a better solution.
4.1.5 Loop Filter
The design of the PLL filter will strongly affect the performance of the frequency synthesizer. The PLL filter is kept
external for flexibility. The parameters to be considered when designing the loop filter for the SX1223 are primarily
the modulation mode and bit rate. These will also affect the switching time and phase noise.
The frequency modulation can be done in three different ways with the SX1223, either by closed-, open loop VCO
modulation or by modulation with the internal dividers, see Table 3 and modulation selection guide in Table 35.
Modulation1 Modulation0
0 0
0 1
1 0
1 1
State
Closed loop VCO-modulation (mw1)
Open loop VCO-modulation (mw2)
Modulation by A,M and N (mw3)
Not used
Table 3 : Modulation modes
Comments
VCO is phase-locked
VCO is free-running
Modulation inside PLL
R1
C3
R1
C1
C3
R1
C1
C3
C2
C2
C2
R2
PCB
20
21
PCB
20
21
PCB
20
21
SX1223
SX1223
SX1223
XCO
÷ M
PFD
VCO
XCO
÷ M
PFD
VCO
XCO
÷ M
PFD
VCO
OL opamp
MOD
MOD
MOD
÷ N,A
÷ 2
÷ N,A
÷ 2
÷ N,A
÷ 2
Modulation mw1
Modulation mw2
Modulation mw3
Figure 4 : Modulation modes
In closed loop VCO modulation (mw1), the PLL bandwidth needs to be sufficiently low ( ≈ Bit Rate / 20), so as to
prevent the VCO tracking the modulation and cancelling the modulation.
Using the dividers in mw3 mode, the PLL needs to lock on a new carrier frequency for every new data bit. Now the
PLL bandwidth needs to be sufficiently high ( ≈ Bit Rate / 2). It may be necessary to implement a third order filter to
futher suppress the phase detector frequency spurs,
For the open loop VCO modulation case (mw2), the PLL bandwidth can be large, as the PLL is deactivated during
the transmission burst and there is no requirement to supress the phase detector frequency
To increase the transmission time in the open loop case, a capacitor of 47 nF can be connected on pin VARIN to
ground (NPO type is advised if the transmission duration is critical). The internal opamp must be enabled to drive
this capacitor, by setting the bit OL_opamp_en to 1.
A schematic for a third order loop filter is shown in Figure 5a. For a second order filter, C3 is not connected and R2
is set to 0 ? . When designing a third order loop filter, the internal capacitance on the VARIN pin of approximately 6
pF must be taken into consideration. Figure 5b shows the loop filter configuration for the open loop VCO modulation
case.
? Semtech 2007
10
www.semtech.com
相关PDF资料
PDF描述
SX1223SK915 KIT STARTER FOR XE1223 915MHZ
TC50V6A32K7680 OSCILLATOR 32.7680 KHZ 1.5V SMD
TC70V3A32K7680 OSCILLATOR 32.7680 KHZ 1.5V SMD
3341-07 PROGRAMMING BOARD FOR PE3341
3342-07 PROGRAMMING BOARD FOR PE3342
相关代理商/技术参数
参数描述
SX1223SK868 功能描述:KIT STARTER FOR XE1223 868MHZ RoHS:是 类别:RF/IF 和 RFID >> RF 评估和开发套件,板 系列:- 标准包装:1 系列:- 类型:GPS 接收器 频率:1575MHz 适用于相关产品:- 已供物品:模块 其它名称:SER3796
SX1223SK915 功能描述:KIT STARTER FOR XE1223 915MHZ RoHS:是 类别:RF/IF 和 RFID >> RF 评估和开发套件,板 系列:- 标准包装:1 系列:- 类型:GPS 接收器 频率:1575MHz 适用于相关产品:- 已供物品:模块 其它名称:SER3796
SX1230 制造商:SEMTECH 制造商全称:Semtech Corporation 功能描述:Integrated Transmitter IC Narrow/wideband 315 MHz, 434 MHz 868 MHz and 915 MHz band Transmitter
SX1230-11SKA433 制造商:Semtech Corporation 功能描述:Evaluation Kit For SX1230-11SKA 433 mHz (SX1230SKA /SX1211SKA board) Transmitter
SX1230-11SKA868 制造商:Semtech Corporation 功能描述:NARROW/WIDEBAND RF TRANSMITTER 868MHZ