参数资料
| 型号： | SY87701VHH TR |
| 厂商： | Micrel Inc |
| 文件页数： | 7/15页 |
| 文件大小： | 0K |
| 描述： | IC CLOCK/DATA RECOVERY 32-TQFP |
| 标准包装： | 1,000 |
| 系列： | AnyRate® |
| 类型： | 时钟和数据恢复（CDR），多路复用器 |
| PLL： | 是 |
| 主要目的： | 以太网，SONET/SDH，ATM 应用 |
| 输入： | PECL |
| 输出： | PECL |
| 电路数： | 1 |
| 比率 - 输入:输出： | 1:3 |
| 差分 - 输入:输出： | 是/是 |
| 频率 - 最大： | 1.25Gbps |
| 电源电压： | 3.15 V ~ 5.25 V |
| 工作温度： | 0°C ~ 85°C |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 32-TQFP 裸露焊盘 |
| 供应商设备封装： | 32-EPAD-TQFP |
| 包装： | 带卷 (TR) |
| 其它名称： | SY87701VHHTR SY87701VHHTR-ND |
2010-2011 Microchip Technology Inc.
DS22266D-page 15
MCP7941X
ALMxC2:0: These Configuration bits determine
the alarm match. The logic will trigger the alarm
based on one of the following match conditions:
0x18h-0x1Bh are used for the timesaver function.
These registers are loaded at the time when VCC falls
and the RTCC operates on the VBAT. The VBAT bit is
also set at this time. These registers are cleared when
the VBAT bit is cleared in software.
0x1Ch-0x1Fh are used for the timesaver function. Reg-
isters 0x18-0x1A are loaded when VCC falls and the
device switches over to VBAT. Registers 0x1B-0x1F are
loaded when VCC is available and the device switches
Power-Fail Time-Stamp for more information.
5.2
FEATURES
5.2.1
STATUS REGISTER
The STATUS register is in the nonvolatile EEPROM
array. To access the STATUS register, the address of
0xFFh is written to and read from. ACK polling may be
used to determine if the write is complete. The bits in
this register are defined as:
Bit 3:2 are the EEPROM array block protection
bits. These bits are in the nonvolatile EEPROM
array. This allows protection of the following
areas:
- 00 – None of the array is protected.
- 01 – The upper 1/4 of the array 0x60h-0x7fh
is protected.
- 10 – The upper 1/2 of the array 0x40h-0x7fh
is protected.
- 11 – All of the array 0x00-0x7fh is protected.
The unused bits are reserved at this time and
read as ‘0’.
With the current address read operation, the
address is not incremented. Consequently, the
subsequent reads are done from the same
location.
If multiple bytes are loaded to the STATUS register,
only the last byte is written.
5.2.2
UNLOCK SEQUENCE
The unique ID location is user accessible by using the
unlock ID sequence.
The unique ID location is 64-bits (8 bytes) and is
stored in EEPROM locations 0xF0 to 0xF7. This
location can be read at any time, however, a write is
inhibited until unlocked.
To unlock the write access to this location the following
sequence must be completed:
A single write of 0x55h to address 0x09. Stop
A single write of 0xAAh to address 0x09. Stop
This will allow the unique EEPROM locations to be
written.
After the byte or page write to these locations, the
write sequence is initiated by the Stop condition. At
this time, the ID locations are locked and no further
writes are possible to this location unless a complete
unlock sequence is repeated.
000 – Seconds match
001 – Minutes match
010 – Hours match (takes into account 12/24
hour)
011 – Matches the current day, interrupt at
12.00.00 a.m. Example: 12 midnight on
100
–Date
101
– RESERVED
110
– RESERVED
111
– Seconds, Minutes, Hour, Day, Date,
Month
Note:
It is strongly recommended that the
timesaver function only be used when the
oscillator is running. This will ensure
accurate functionality.
相关PDF资料 |
PDF描述 |
|---|---|
| SY87701LZG TR | IC CLOCK/DATA RECOVERY 28-SOIC |
| VE-J6V-MW-B1 | CONVERTER MOD DC/DC 5.8V 100W |
| SY87701LHG TR | IC CLOCK/DATA RECOVERY 32-TQFP |
| SY87813LHG TR | IC CLOCK/DATA RECOVERY 32-TQFP |
| VE-J5X-MW-B1 | CONVERTER MOD DC/DC 5.2V 100W |
相关代理商/技术参数 |
参数描述 |
|---|---|
| SY87701VSC | 功能描述:IC CLOCK/DATA RECOVERY 32-TQFP RoHS:否 类别:集成电路 (IC) >> 时钟/计时 - 专用 系列:AnyRate® 标准包装:1,500 系列:- 类型:时钟缓冲器/驱动器 PLL:是 主要目的:- 输入:- 输出:- 电路数:- 比率 - 输入:输出:- 差分 - 输入:输出:- 频率 - 最大:- 电源电压:3.3V 工作温度:0°C ~ 70°C 安装类型:表面贴装 封装/外壳:28-SSOP（0.209"，5.30mm 宽） 供应商设备封装:28-SSOP 包装:带卷 (TR) 其它名称:93786AFT |
| SY87701VZC | 功能描述:IC CLOCK/DATA RECOVERY 28-SOIC RoHS:否 类别:集成电路 (IC) >> 时钟/计时 - 专用 系列:AnyRate® 标准包装:1,500 系列:- 类型:时钟缓冲器/驱动器 PLL:是 主要目的:- 输入:- 输出:- 电路数:- 比率 - 输入:输出:- 差分 - 输入:输出:- 频率 - 最大:- 电源电压:3.3V 工作温度:0°C ~ 70°C 安装类型:表面贴装 封装/外壳:28-SSOP（0.209"，5.30mm 宽） 供应商设备封装:28-SSOP 包装:带卷 (TR) 其它名称:93786AFT |
| SY87701VZCTR | 制造商:MICREL 制造商全称:Micrel Semiconductor 功能描述:5V/3.3V 32-1250Mbps AnyRate CLOCK AND DATA RECOVERY |
| SY87701VZH | 功能描述:计时器和支持产品 5V/3.3V 32-1250Mbps AnyRate Clock and Data Recovery RoHS:否 制造商:Micrel 类型:Standard 封装 / 箱体:SOT-23 内部定时器数量:1 电源电压-最大:18 V 电源电压-最小:2.7 V 最大功率耗散: 最大工作温度:+ 85 C 最小工作温度:- 40 C 封装:Reel |
| SY87701VZH TR | 功能描述:计时器和支持产品 5V/3.3V 32-1250Mbps AnyRate Clock and Data Recovery RoHS:否 制造商:Micrel 类型:Standard 封装 / 箱体:SOT-23 内部定时器数量:1 电源电压-最大:18 V 电源电压-最小:2.7 V 最大功率耗散: 最大工作温度:+ 85 C 最小工作温度:- 40 C 封装:Reel |
发布紧急采购，3分钟左右您将得到回复。