参数资料
| 型号： | SY89429AJC TR |
| 厂商： | Micrel Inc |
| 文件页数： | 5/9页 |
| 文件大小： | 0K |
| 描述： | IC SYNTHESIZER FREQ PROGR 28PLCC |
| 标准包装： | 750 |
| 系列： | Precision Edge® |
| 类型： | 频率合成器 |
| PLL： | 是 |
| 输入： | PECL，晶体 |
| 输出： | PECL |
| 电路数： | 1 |
| 比率 - 输入:输出： | 1:1 |
| 差分 - 输入:输出： | 无/是 |
| 频率 - 最大： | 800MHz |
| 除法器/乘法器： | 是/无 |
| 电源电压： | 3.135 V ~ 5.25 V |
| 工作温度： | 0°C ~ 85°C |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 28-LCC（J 形引线） |
| 供应商设备封装： | 28-PLCC |
| 包装： | 带卷 (TR) |
| 其它名称： | SY89429AJCTR SY89429AJCTR-ND |
5
Precision Edge
SY89429A
Micrel, Inc.
M,N
S_CLOCK
S_DATA
S_LOAD
P_LOAD
M[ 8 :0 ]
N[1 :0 ]
T 2 T 1 T 0 N1 N0 M8 M7 M6 M5 M4 M3 M2 M1 M0
PROGRAMMING INTERFACE
Programming the device is accomplished by properly
configuring the internal dividers to produce the desired
frequency at the outputs. The output frequency can be
represented by this formula:
Where FXTAL is the crystal frequency, M is the loop divider
modulus, and N is the output divider modulus. Note that it is
possible to select values of M such that the PLL is unable to
achieve loop lock. To avoid this, always make sure that M is
selected to be 200 M 400 for a 16MHz input reference.
M[8:0] and N[1:0] are normally specified once at power-on,
through the parallel interface, and then possibly again through
the serial interface. This approach allows the designer to
bring up the application at one frequency and then change or
fine-tune the clock, as the ability to control the serial interface
becomes available. To minimize transients in the frequency
domain, the output should be varied in the smallest step size
possible.
The TEST output provides visibility for one of several
internal nodes (as determined by the T[1:0] bits in the serial
configuration stream). It is not configurable through the
parallel interface. Although it is possible to select the node
that represents FOUT, the TTL output may not be able to
toggle fast enough for some of the higher output frequencies.
The T2, T1, T0 configuration latches are preset to 000 when
P_LOAD is low, so that the FOUT outputs are as jitter-free as
possible. The serial configuration port can be used to select
one of the alternate functions for this pin.
The Test register is loaded with the first three bits, the N
register with the next two and the M register with the final eight
bits of the data stream on the S_DATA input. For each register
the most significant bit is loaded first (T2, N1 and M8).
When T[2:0] is set to 100 the SY89429A is placed in PLL
bypass mode. In this mode the S_CLOCK input is fed directly
into the M and N dividers. The N divider drives the FOUT
differential pair and the M counter drives the TEST output
pin. In this mode the S_CLOCK input could be used for low
speed board level functional test or debug. Bypassing the
PLL and driving FOUT directly gives the user more control
on the test clocks sent through the clock tree (See detailed
Block Diagram). Because the S_CLOCK is a TTLlevel the input
frequency is limited to 250MHz or less. This means the fastest
the FOUT pin can be toggled via the S_CLOCK is 125MHz as
the minimum divide ratio of the N counter is 2. Note that the
M counter output on the TEST output will not be a 50% duty
cycle due to the way the divider is implemented.
Input S_DATA to M0 then M1, then M2, etc., as indicated above.
First
Bit
Last
Bit
T2
T1
T0
TEST
FOUT/FOUT
0
Data Out – Last Bit SR
FVCO ÷ N
0
1
HIGH
FVCO ÷ N
0
1
0
FREF
FVCO ÷ N
0
1
M Counter Output
FVCO ÷ N
1
0
FOUT
FVCO ÷ N
1
0
1
LOW
FVCO ÷ N
1
0
S_CLOCK ÷ M
S_CLOCK ÷ N
1
FOUT ÷ 4
FVCO ÷ N
相关PDF资料 |
PDF描述 |
|---|---|
| SY89429AJC | IC SYNTHESIZER FREQ PROGR 28PLCC |
| SY89426JC | IC SYNTHESIZER CLK SONET 28-PLCC |
| VI-J3R-MZ-F1 | CONVERTER MOD DC/DC 7.5V 25W |
| MS27499E10B99B | CONN HSG RCPT 7POS BOX MNT SCKT |
| VI-B1Y-MX-F3 | CONVERTER MOD DC/DC 3.3V 49.5W |
相关代理商/技术参数 |
参数描述 |
|---|---|
| SY89429AJZ | 功能描述:时钟合成器/抖动清除器 Programmable Frequency Synthesizer (25-400MHz) (Lead Free) RoHS:否 制造商:Skyworks Solutions, Inc. 输出端数量: 输出电平: 最大输出频率: 输入电平: 最大输入频率:6.1 GHz 电源电压-最大:3.3 V 电源电压-最小:2.7 V 封装 / 箱体:TSSOP-28 封装:Reel |
| SY89429AJZ TR | 功能描述:时钟合成器/抖动清除器 Programmable Frequency Synthesizer (25-400MHz) (Lead Free) RoHS:否 制造商:Skyworks Solutions, Inc. 输出端数量: 输出电平: 最大输出频率: 输入电平: 最大输入频率:6.1 GHz 电源电压-最大:3.3 V 电源电压-最小:2.7 V 封装 / 箱体:TSSOP-28 封装:Reel |
| SY89429AJZTR | 制造商:MICREL 制造商全称:Micrel Semiconductor 功能描述:PROGRAMMABLE FREQUENCY SYNTHESIZER (25MHz to 400MHz) |
| SY89429AZC | 功能描述:IC SYNTHESIZER FREQ PROGR 28SOIC RoHS:否 类别:集成电路 (IC) >> 时钟/计时 - 时钟发生器，PLL，频率合成器 系列:Precision Edge® 标准包装:27 系列:Precision Edge® 类型:频率合成器 PLL:是 输入:PECL，晶体 输出:PECL 电路数:1 比率 - 输入:输出:1:1 差分 - 输入:输出:无/是 频率 - 最大:800MHz 除法器/乘法器:是/无 电源电压:3.135 V ~ 5.25 V 工作温度:0°C ~ 85°C 安装类型:表面贴装 封装/外壳:28-SOIC（0.295"，7.50mm 宽） 供应商设备封装:28-SOIC 包装:管件 |
| SY89429AZC TR | 功能描述:IC SYNTHESIZER FREQ PROGR 28SOIC RoHS:否 类别:集成电路 (IC) >> 时钟/计时 - 时钟发生器，PLL，频率合成器 系列:Precision Edge® 产品变化通告:Product Discontinuation 04/May/2011 标准包装:96 系列:- 类型:时钟倍频器，零延迟缓冲器 PLL:带旁路 输入:LVTTL 输出:LVTTL 电路数:1 比率 - 输入:输出:1:8 差分 - 输入:输出:无/无 频率 - 最大:133.3MHz 除法器/乘法器:是/无 电源电压:3 V ~ 3.6 V 工作温度:0°C ~ 70°C 安装类型:表面贴装 封装/外壳:16-TSSOP（0.173"，4.40mm 宽） 供应商设备封装:16-TSSOP 包装:管件 其它名称:23S08-5HPGG |
发布紧急采购，3分钟左右您将得到回复。