- 您现在的位置：买卖IC网 > Datasheet目录705 > SZNUF8152MUT2G (ON Semiconductor)IC EMI FILTER 8LINE ESD 16-UDFN Datasheet资料下载
参数资料
| 型号： | SZNUF8152MUT2G |
| 厂商： | ON Semiconductor |
| 文件页数： | 4/6页 |
| 文件大小： | 0K |
| 描述： | IC EMI FILTER 8LINE ESD 16-UDFN |
| 产品变化通告： | 1Q2012 Discontinuation 30/Mar/2012 |
| 标准包装： | 3,000 |
| 类型： | 低通 |
| 技术： | RC（Pi） |
| 通道数： | 8 |
| 中心 / 截止频率： | 125MHz（截止值） |
| 衰减值： | 25dB @ 800MHz ~ 3GHz |
| 电阻 - 通道 (Ohms)： | 28 |
| 值： | R = 28 欧姆，C = 17pF，L = 1nH |
| ESD 保护： | 是 |
| 滤波器阶数： | 3rd |
| 应用： | 自动 |
| 封装/外壳： | 16-UFDFN 裸露焊盘 |
| 尺寸/尺寸： | 0.138" L x 0.047" W（3.50mm x 1.20mm） |
| 高度： | 0.022"（0.55mm） |
| 包装： | 带卷 (TR) |
| 工作温度： | -40°C ~ 85°C |
NUF8152, SZNUF8152
Theory of Operation
The NUF8152MU combines ESD protection and EMI
filtering conveniently into a small package for today’s size
constrained applications. The capacitance inherent to a
typical protection diode is utilized to provide the
capacitance value necessary to create the desired frequency
response based upon the series resistance in the filter. By
combining this functionality into one device, a large number
of discrete components are integrated into one small
package saving valuable board space and reducing BOM
count and cost in the application.
Application Example
The accepted practice for specifying bandwidth in a filter
is to use the 3 dB cutoff frequency. Utilizing points such as
the 6 dB or 9 dB cutoff frequencies results in signal
degradation in an application. This can be illustrated in an
application example. A typical application would include
EMI filtering of data lines in a camera or display interface.
approximation of a square wave, shown below in
Equations 1 and 2 in the Fourier series approximation.
From this it can be seen that a square wave consists of odd
order harmonics and to fully construct a square wave n must
go to infinity. However, to retain an acceptable portion of the
waveform, the first two terms are generally sufficient. These
two terms contain about 85% of the signal amplitude and
allow a reasonable square wave to be reconstructed.
Therefore, to reasonably pass a square wave of frequency x
the minimum filter bandwidth necessary is 3x . All
ON Semiconductor EMI filters are rated according to this
principle. Attempting to violate this principle will result in
significant rounding of the waveform and cause problems in
transmitting the correct data. For example, take the filter
with the response shown in Figure 5 and apply three
different data waveforms. To calculate these three different
frequencies, the 3 dB, 6 dB, and 9 dB bandwidths will be
used.
S
In such an example it is important to first understand the
signal and its spectral content. By understanding these
things, an appropriate filter can be selected for the desired
application. A typical data signal is pattern of 1’s and 0’s
transmitted over a line in a form similar to a square wave.
Equation 1:
2 2
x(t) + 1 ) p
a
1
n + 1 2n * 1
sin((2n * 1) w 0 t)
(eq. 1)
The maximum frequency of such a signal would be the
Equation 2 (simplified form of Equation 1):
pattern 1-0-1-0 such that for a signal with a data rate of
100 Mbps, the maximum frequency component would be
50 MHz. The next item to consider is the spectral content of
2 2
x(t) + 1 ) p
sin( w 0 t)
1
)
sin(3 w 0 t)
3
)
sin(5 w 0 t)
5
) AAA (eq. 2)
the signal, which can be understood with the Fourier series
? 3 dB
? 6 dB
? 9 dB
f 1
f 2
f 3
100k
1M
10M
100M
1G
10G
Frequency (Hz)
Figure 5. Filter Bandwidth
From the above paragraphs it is shown that the maximum
supported frequency of a waveform that can be passed
through the filter can be found by dividing the bandwidth by
multiply the result by two). The following table gives the
bandwidth values and the corresponding maximum
supported frequencies and the third harmonic frequencies.
a factor of three (to obtain the corresponding data rate
http://onsemi.com
4
相关PDF资料 |
PDF描述 |
|---|---|
| TC25V6A32K7680 | OSCILLATOR 32.7680 KHZ 1.5V SMD |
| TC32N6A32K7680 | OSCILLATOR 32.7680 KHZ 2.5V SMD |
| TC50M6A32K7680 | OSCILLATOR 32.7680 KHZ 1.8V SMD |
| TC70L6A32K7680 | OSCILLATOR 32.7680 KHZ 3.3V SMD |
| TCM0806S-350-2P | CHOKE COMMON MODE 35 OHM SMD |
相关代理商/技术参数 |
参数描述 |
|---|---|
| SZNUP1105LT1G | 功能描述:TVS 二极管 - 瞬态电压抑制器 LESHAN ZR LIN BUS PROT RoHS:否 制造商:Vishay Semiconductors 极性:Bidirectional 工作电压: 击穿电压:58.9 V 钳位电压:77.4 V 峰值浪涌电流:38.8 A 系列: 封装 / 箱体:DO-214AB 最小工作温度:- 55 C 最大工作温度:+ 150 C |
| SZNUP1301ML3T1G | 功能描述:ESD 抑制器 LOW CAP DIEOD ARRAY 70V RoHS:否 制造商:STMicroelectronics 通道:8 Channels 击穿电压:8 V 电容:45 pF 端接类型:SMD/SMT 封装 / 箱体:uQFN-16 功率耗散 Pd: 工作温度范围:- 40 C to + 85 C |
| SZNUP2105LT1 | 制造商:Rochester Electronics LLC 功能描述: 制造商:ON Semiconductor 功能描述: |
| SZNUP2105LT1G | 功能描述:ESD 抑制器 SOT-23 27 CAN BUS RoHS:否 制造商:STMicroelectronics 通道:8 Channels 击穿电压:8 V 电容:45 pF 端接类型:SMD/SMT 封装 / 箱体:uQFN-16 功率耗散 Pd: 工作温度范围:- 40 C to + 85 C |
| SZNUP2105LT3G | 功能描述:ESD 抑制器 SOT-23 27 CAN BUS RoHS:否 制造商:STMicroelectronics 通道:8 Channels 击穿电压:8 V 电容:45 pF 端接类型:SMD/SMT 封装 / 箱体:uQFN-16 功率耗散 Pd: 工作温度范围:- 40 C to + 85 C |
发布紧急采购，3分钟左右您将得到回复。