- 您现在的位置：买卖IC网 > PDF目录98153 > TA2160FNG 0.012 W, 2 CHANNEL, AUDIO AMPLIFIER, PDSO30 PDF资料下载
参数资料
| 型号： | TA2160FNG |
| 元件分类： | 音频／视频放大 |
| 英文描述： | 0.012 W, 2 CHANNEL, AUDIO AMPLIFIER, PDSO30 |
| 封装： | 0.300 INCH, 0.65 MM PITCH, PLASTIC, SSOP-30 |
| 文件页数： | 14/17页 |
| 文件大小： | 275K |
| 代理商： | TA2160FNG |
TA2160FNG
2004-05-11
6
Application Note
1.
Preamplifier Stage
Output DC voltage of preamplifier
Output DC voltage of preamplifier is determined by external resistors R1 and R2 as shown in
Figure 1.
VO (PRE) = VREF V × (R2/R1 + 1)
VREF = 0.73 V (typ.)
VREF is changed when resistance is connected between RF OUT terminal and VREF IN terminal
(Refer to application note 3 (1)).
V is an offset voltage which is designed to 28.6 mV.
It is as follows in case that the DC voltage is calculated by the constant of a test circuit.
VO (PRE) = 0.73 V 28.6 mV (200 k/22 k + 1)
= 0.44 V
Output DC voltage of preamplifier should be fixed about VCC/2, because preamplifier get a enough
dynamic range.
2.
Power Amplifier Stage
(1)
Input of power amplifier
Each input signal should be applied through a capacitor. In case that DC current or DC voltage is
applied to each amplifier, the internal circuit has unbalance and the each amplifier doesn’t operate
normally.
It is advised that input signal refer to VREF voltage, in order to reduce a pop noise or low frequency
leak.
(2)
Bass boost function
(a)
System
This IC has the bass boost function in power amplifier stage. After this system adds the low
frequency ingredient of side amplifier, it is applied into the center amplifier. And the bass boost
level is controlled by the variable impedance circuit (Figure 2)
Flow of the bass boost signal
Variable impedance circuit → Boost amplifier → Center amplifier
Flow of the bass boost level
Output of center amplifier → AGC DET (level detection) → Variable impedance
circuit operation
The system of treble boost function is realized by frequency characteristic adjustment of the
side amplifier.
VREF
R1
R2
V = 28.6 mV
Figure 1
Output DC Voltage of Preamplifier
相关PDF资料 |
PDF描述 |
|---|---|
| TA2160FN | 0.012 W, 2 CHANNEL, AUDIO AMPLIFIER, PDSO30 |
| TA2170FLG | 0.02 W, 2 CHANNEL, AUDIO AMPLIFIER, PQCC24 |
| TA31138FN(ELP) | SPECIALTY CONSUMER CIRCUIT, PDSO24 |
| TA31138FN-TP1 | SPECIALTY CONSUMER CIRCUIT, PDSO24 |
| TA31138FN-TP2 | SPECIALTY CONSUMER CIRCUIT, PDSO24 |
相关代理商/技术参数 |
参数描述 |
|---|---|
| TA2170FLG | 制造商:TOSHIBA 制造商全称:Toshiba Semiconductor 功能描述:Low Current Consumption Headphone Amplifier (Built-in Input Selector) |
| TA2170FTG | 制造商:TOSHIBA 制造商全称:Toshiba Semiconductor 功能描述:Low Current Consumption Headphone Amplifier (Built-in input selector) |
| TA2181AFNG(EL) | 功能描述:射频识别变换器工具 2CH IR TRANSMITTER ANALOG IC RoHS:否 制造商:Olimex Ltd. 产品:RFID Readers 用于:ISO15693 |
| TA22 | 制造商:VISHAY 制造商全称:Vishay Siliconix 功能描述:Single Value Chip Resistor |
| TA-22.1184MBD-T | 功能描述:标准时钟振荡器 22.1184MHz 3.3V 25 ppm -40C to 85C RoHS:否 制造商:AVX 产品:Standard Clock Oscillators 封装 / 箱体:7 mm x 5 mm 频率:75 MHz 频率稳定性:50 PPM 电源电压:2.5 V 负载电容: 端接类型:SMD/SMT 最小工作温度:0 C 最大工作温度:+ 70 C 输出格式:LVDS 尺寸: 封装:Reel 系列: |
发布紧急采购，3分钟左右您将得到回复。