- 您现在的位置：买卖IC网 > PDF目录98161 > TAS5112ADCARG4 (TEXAS INSTRUMENTS INC) 62 W, 2 CHANNEL, AUDIO AMPLIFIER, PDSO56 PDF资料下载
参数资料
| 型号： | TAS5112ADCARG4 |
| 厂商： | TEXAS INSTRUMENTS INC |
| 元件分类： | 音频／视频放大 |
| 英文描述： | 62 W, 2 CHANNEL, AUDIO AMPLIFIER, PDSO56 |
| 封装： | GREEN, PLASTIC, HTSSOP-56 |
| 文件页数： | 14/29页 |
| 文件大小： | 762K |
| 代理商： | TAS5112ADCARG4 |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页当前第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页
TAS5112A
SLES094B - OCTOBER 2003 - REVISED JUNE 2008
www.ti.com
21
LAND PATTERN
PCB THERMAL
RESISTANCE
7
× 13 vias (5 × 10 mm)
2.2
°C/W
5
× 11 vias (4 × 8 mm)
3.6
°C/W
Thermal
Pad
8,20 mm
7,20 mm
3,90 mm
2,98 mm
Figure 17. Thermal Pad Dimensions for DCA
Package
CLICK AND POP REDUCTION
TI modulators feature a pop and click reduction system
that controls the timing when switching starts and stops.
Going from nonswitching to switching operation causes a
spectral energy burst to occur within the audio bandwidth,
which is heard in the speaker as an audible click, for
instance, after having asserted RESET LH during a
system start-up.
To make this system work properly, the following design
rules must be followed when using the TAS5112A back
end:
D The relative timing between the PWM_AP/M_x
signals and their corresponding VALID_x signal
should not be skewed by inserting delays,
because this increases the audible amplitude
level of the click.
D The output stage must start switching from a
fully discharged output filter capacitor. Because
the output stage prior to operation is in the
high-impedance state, this is done by having a
passive pulldown resistor on each speaker
output to GND (see System Configuration Used
for Characterization).
Other things that can affect the audible click level:
D The spectrum of the click seems to follow the
speaker impedance vs. frequency curve—the
higher the impedance, the higher the click
energy.
D Crossover filters used between woofer and
tweeter in a speaker can have high impedance
in the audio band, which should be avoided if
possible.
Another way to look at it is that the speaker impulse
response is a major contributor to how the click energy is
shaped in the audio band and how audible the click will be.
The following mode transitions feature click and pop
reduction.
STATE
CLICK AND
POP REDUCED
Normal(1)
→ Mute
Yes
Mute
→ Normal(1)
Yes
Normal(1)
→
Error recovery
(ERRCVY)
Yes
Error recovery
→ Normal(1)
Yes
Normal(1)
→ Hard reset
No
Hard reset
→ Normal(1)
Yes
(1) Normal = switching
相关PDF资料 |
PDF描述 |
|---|---|
| TAS5112ADCAR | 62 W, 2 CHANNEL, AUDIO AMPLIFIER, PDSO56 |
| TAS5112ADCA | 62 W, 2 CHANNEL, AUDIO AMPLIFIER, PDSO56 |
| TAS5112ADFDRG4 | 62 W, 2 CHANNEL, AUDIO AMPLIFIER, PDSO56 |
| TAS5112ADFDR | 62 W, 2 CHANNEL, AUDIO AMPLIFIER, PDSO56 |
| TAS5112ADFDG4 | 62 W, 2 CHANNEL, AUDIO AMPLIFIER, PDSO56 |
相关代理商/技术参数 |
参数描述 |
|---|---|
| TAS5112ADFD | 功能描述:音频放大器 Digital Amp Power Stage RoHS:否 制造商:STMicroelectronics 产品:General Purpose Audio Amplifiers 输出类型:Digital 输出功率: THD + 噪声: 工作电源电压:3.3 V 电源电流: 最大功率耗散: 最大工作温度: 安装风格:SMD/SMT 封装 / 箱体:TQFP-64 封装:Reel |
| TAS5112ADFDG4 | 功能描述:音频放大器 Digital Amp Power Stage RoHS:否 制造商:STMicroelectronics 产品:General Purpose Audio Amplifiers 输出类型:Digital 输出功率: THD + 噪声: 工作电源电压:3.3 V 电源电流: 最大功率耗散: 最大工作温度: 安装风格:SMD/SMT 封装 / 箱体:TQFP-64 封装:Reel |
| TAS5112ADFDR | 功能描述:音频放大器 Digital Amp Power Stage RoHS:否 制造商:STMicroelectronics 产品:General Purpose Audio Amplifiers 输出类型:Digital 输出功率: THD + 噪声: 工作电源电压:3.3 V 电源电流: 最大功率耗散: 最大工作温度: 安装风格:SMD/SMT 封装 / 箱体:TQFP-64 封装:Reel |
| TAS5112ADFDRG4 | 功能描述:音频放大器 Digital Amp Power Stage RoHS:否 制造商:STMicroelectronics 产品:General Purpose Audio Amplifiers 输出类型:Digital 输出功率: THD + 噪声: 工作电源电压:3.3 V 电源电流: 最大功率耗散: 最大工作温度: 安装风格:SMD/SMT 封装 / 箱体:TQFP-64 封装:Reel |
| TAS5112DFD | 功能描述:音频放大器 Dig Amp Stereo Power Stage RoHS:否 制造商:STMicroelectronics 产品:General Purpose Audio Amplifiers 输出类型:Digital 输出功率: THD + 噪声: 工作电源电压:3.3 V 电源电流: 最大功率耗散: 最大工作温度: 安装风格:SMD/SMT 封装 / 箱体:TQFP-64 封装:Reel |
发布紧急采购，3分钟左右您将得到回复。