- 您现在的位置：买卖IC网 > PDF目录98167 > TB6560AHQ STEPPER MOTOR CONTROLLER, 3.5 A, PZFM25 PDF资料下载
参数资料
| 型号： | TB6560AHQ |
| 元件分类： | 运动控制电子 |
| 英文描述： | STEPPER MOTOR CONTROLLER, 3.5 A, PZFM25 |
| 封装： | 1.27 MM PITH, PLASTIC, ZIP-25 |
| 文件页数： | 27/34页 |
| 文件大小： | 481K |
| 代理商： | TB6560AHQ |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页当前第27页第28页第29页第30页第31页第32页第33页第34页
TB6560AHQ/AFG
2009-07-10
33
Points to Remember on Handling of ICs
(1)
Thermal Shutdown Circuit
Thermal shutdown circuits do not necessarily protect ICs under all circumstances. If the thermal
shutdown circuits operate against the over temperature, clear the heat generation status
immediately.
Depending on the method of use and usage conditions, such as exceeding absolute maximum ratings
can cause the thermal shutdown circuit to not operate properly or IC breakdown before operation.
(2)
Heat Radiation Design
In using an IC with large current flow such as power amp, regulator or driver, please design the
device so that heat is appropriately radiated, not to exceed the specified junction temperature (TJ) at
any time and condition. These ICs generate heat even during normal use. An inadequate IC heat
radiation design can lead to decrease in IC life, deterioration of IC characteristics or IC breakdown. In
addition, please design the device taking into considerate the effect of IC heat radiation with
peripheral components.
(3)
Back-EMF
When a motor rotates in the reverse direction, stops or slows down abruptly, a current flow back to
the motor’s power supply due to the effect of back-EMF. If the current sink capability of the power
supply is small, the device’s motor power supply and output pins might be exposed to conditions
beyond maximum ratings. To avoid this problem, take the effect of back-EMF into consideration in
system design.
(4)
Short-Circuits
The IC may be permanently damaged in case of a short-circuit across its outputs, a short-circuit to
power supply or a short-circuit to ground. These possibilities should be fully considered in the design
of the output, VDD, VM and ground lines.
(5)
Short-Circuits between Adjacent Pins in the TB6560AHQ
In the TB6560AHQ, the term “adjacent pin” includes a pin diagonally closest to a given pin. For
example, pin 3 has four adjacent pins: 1, 2, 4 and 5.
Depending on the specified voltage and current, a large current might abruptly flow through the
TB6560AHQ in case of a short-circuit between any adjacent pins that are listed below. If the large
current persists, it may lead to a smoke emission.
1) Pins 7 and 8
2) Pins 7 and 9
3) Pins 8 and 9
4) Pins 9 and 10
5) Pins 9 and 11
6) Pins 10 and 12
7) Pins 11 and 12
8) Pins 11 and 13
9) Pins 12 and 13
10) Pins 12 and 14
11) Pins 13 and 14
12) Pins 13 and 15
13) Pins 14 and 16
14) Pins 15 and 16
15) Pins 16 and 17
16) Pins 16 and 18
17) Pins 17 and 18
18) Pins 18 and 19
19) Pins 18 and 20
Therefore, to avoid a continuous overcurrent due to the above-described short-circuit and allow the
TB6560AHQ/AFG to be fail-safe, an appropriate fuse should be added at the right place, or
overcurrent shutdown circuitry should be added to the power supply. The rated current of a fuse may
vary depending on actual applications and its characteristics. Thus, an appropriate fuse must be
selected experimentally.
相关PDF资料 |
PDF描述 |
|---|---|
| TB6561NG | BRUSH DC MOTOR CONTROLLER, 1.5 A, PDIP24 |
| TB6581HG | BRUSHLESS DC MOTOR CONTROLLER, 2 A, PZIP25 |
| TB6582FG | BRUSHLESS DC MOTOR CONTROLLER, 0.002 A, PQFP52 |
| TB6592FLG | BRUSH DC MOTOR CONTROLLER, 0.8 A, PQCC24 |
| TB6595FL | BRUSH DC MOTOR CONTROLLER, 0.8 A, PQCC36 |
相关代理商/技术参数 |
参数描述 |
|---|---|
| TB6560AHQ(O) | 功能描述:马达/运动/点火控制器和驱动器 Stepping Motor Drivr RoHS:否 制造商:STMicroelectronics 产品:Stepper Motor Controllers / Drivers 类型:2 Phase Stepper Motor Driver 工作电源电压:8 V to 45 V 电源电流:0.5 mA 工作温度:- 25 C to + 125 C 安装风格:SMD/SMT 封装 / 箱体:HTSSOP-28 封装:Tube |
| TB6560AHQ(O,8) | 功能描述:马达/运动/点火控制器和驱动器 PWM Choppertype 40V 3.5A 100kOhm RoHS:否 制造商:STMicroelectronics 产品:Stepper Motor Controllers / Drivers 类型:2 Phase Stepper Motor Driver 工作电源电压:8 V to 45 V 电源电流:0.5 mA 工作温度:- 25 C to + 125 C 安装风格:SMD/SMT 封装 / 箱体:HTSSOP-28 封装:Tube |
| TB6560FG | 功能描述:马达/运动/点火控制器和驱动器 STEPPER MOTOR DRIVER 2-PHASE RoHS:否 制造商:STMicroelectronics 产品:Stepper Motor Controllers / Drivers 类型:2 Phase Stepper Motor Driver 工作电源电压:8 V to 45 V 电源电流:0.5 mA 工作温度:- 25 C to + 125 C 安装风格:SMD/SMT 封装 / 箱体:HTSSOP-28 封装:Tube |
| TB6560FG(O) | 制造商:Toshiba America Electronic Components 功能描述:DRIVER FULL BRIDGE SMD HQFP64 |
| TB6560HQ | 制造商:TOSHIBA 制造商全称:Toshiba Semiconductor 功能描述:PWM Chopper-Type bipolar Stepping Motor Driver IC |
发布紧急采购，3分钟左右您将得到回复。