- 您现在的位置：买卖IC网 > PDF目录1879 > TC105303ECTTR (Microchip Technology)IC REG CTRLR BUCK PWM SOT23A-5 PDF资料下载
参数资料
| 型号： | TC105303ECTTR |
| 厂商： | Microchip Technology |
| 文件页数： | 4/14页 |
| 文件大小： | 0K |
| 描述： | IC REG CTRLR BUCK PWM SOT23A-5 |
| 标准包装： | 3,000 |
| PWM 型： | 控制器 |
| 输出数： | 1 |
| 频率 - 最大： | 345kHz |
| 占空比： | 100% |
| 电源电压： | 2.2 V ~ 10 V |
| 降压： | 是 |
| 升压： | 无 |
| 回扫： | 无 |
| 反相： | 无 |
| 倍增器： | 无 |
| 除法器： | 无 |
| Cuk： | 无 |
| 隔离： | 无 |
| 工作温度： | -40°C ~ 85°C |
| 封装/外壳： | SC-74A，SOT-753 |
| 包装： | 带卷 (TR) |
TC105
3.0
DETAILED DESCRIPTION
3.4
Input Bypass Capacitors
The TC105 is a PFM/PWM step-down DC/DC
controller for use in systems operating from two or
more cells, or in line-powered applications. It uses
PWM as the primary modulation scheme, but automat-
ically converts to PFM at output duty cycles less than
Using an input bypass capacitor reduces peak current
transients drawn from the input supply and reduces the
switching noise generated by the regulator. The source
impedance of the input supply determines the size of
the capacitor that should be used.
approximately 10%. The conversion to PFM provides
reduced supply current, and therefore higher operating
3.5
Output Capacitor
efficiency at low loads. The TC105 uses an external
switching transistor, allowing construction of switching
regulators with output currents of up to 1A.
The TC105 consumes only 102 μ A, max, of supply
current when V IN = 5V and V OUT = 3.3V, and can be
placed in a 0.5 μ A shutdown mode by bringing the
shutdown input (SHDN) low. The regulator remains
disabled while in shutdown mode, and output voltage
discharges to zero through the load. Normal operation
resumes when SHDN is brought high. Other features
include a built-in undervoltage lockout (UVLO) and
externally programmable soft start time.
The effective series resistance of the output capacitor
directly affects the amplitude of the output voltage
ripple. (The product of the peak inductor current and
the ESR determines output ripple amplitude.) There-
fore, a capacitor with the lowest possible ESR should
be selected. Smaller capacitors are acceptable for light
loads or in applications where ripple is not a concern.
The Sprague 595D series of tantalum capacitors are
among the smallest of all low ESR surface mount
capacitors available. Table 4-1 lists suggested
components and suppliers.
3.1
Low Power Shutdown Mode
3.6 Inductor Selection
Selecting the proper inductor value is a trade-off
The TC105 enters a low power shutdown mode when
SHDN is brought low. While in shutdown, the oscillator
is disabled and the output switch is shut off. Normal
regulator operation resumes when SHDN is again
brought high. SHDN may be tied to the input supply if
not used.
between physical size and power conversion require-
ments. Lower value inductors cost less, but result in
higher ripple current and core losses. They are also
more prone to saturate since the coil current ramps
faster and could overshoot the desired peak value. This
not only reduces efficiency, but could also cause the
3.2
Soft Start
current rating of the external components to be
exceeded. Larger inductor values reduce both ripple
Soft start allows the output voltage to gradually ramp
from 0 to rated output value during start-up. This action
minimizes (or eliminates) overshoot, and in general,
reduces stress on circuit components. Figure 4-1
shows the circuit required to implement soft start
(values of 470K and 0.033 μ F for R SS and C SS
respectively, are adequate for most applications).
current and core losses, but are larger in physical size
and tend to increase the start-up time slightly.
A 22 μ H inductor is recommended as the best overall
compromise. For highest efficiency, use inductors with
a low DC resistance (less than 20 m ? ). To minimize
radiated noise, consider using a toroid, pot core or
shielded-bobbin inductor.
3.3
Undervoltage Lockout (UVLO)
3.7
Output Diode
The TC105 is disabled when V IN is below the under-
voltage lockout threshold. This threshold is equal to the
guaranteed minimum operating voltage for the TC105
(i.e., 2.2V). When UVLO is active, the TC105 is
completely disabled.
DS21349B-page 4
The high operating frequency of the TC105 requires a
high-speed diode. Schottky diodes such as the MA737
or 1N5817 through 1N5823 (and the equivalent surface
mount versions) are recommended. Select a diode
whose average current rating is greater than the peak
inductor current and whose voltage rating is higher
than V DD MAX .
2002 Microchip Technology Inc.
相关PDF资料 |
PDF描述 |
|---|---|
| TC110503ECTTR | IC REG CTRLR BST PWM SOT23A-5 |
| TC1121CUA713 | IC REG SWITCHD CAP INV ADJ 8MSOP |
| TC115301EMTTR | IC REG BOOST 3V 0.1A SOT89-5 |
| TC1174VOATR | IC REG LDO ADJ .3A 8SOIC |
| TC1187VCT713 | IC REG LDO ADJ .15A SOT23A-5 |
相关代理商/技术参数 |
参数描述 |
|---|---|
| TC105333ECT | 制造商:MICROCHIP 制造商全称:Microchip Technology 功能描述:PFM/PWM Step-Down DC/DC Controller |
| TC105333ECTTR | 功能描述:开关变换器、稳压器与控制器 PFM/PWM Step-Down RoHS:否 制造商:Texas Instruments 输出电压:1.2 V to 10 V 输出电流:300 mA 输出功率: 输入电压:3 V to 17 V 开关频率:1 MHz 工作温度范围: 安装风格:SMD/SMT 封装 / 箱体:WSON-8 封装:Reel |
| TC1054 | 制造商:MICROCHIP 制造商全称:Microchip Technology 功能描述:50 mA, 100 mA and 150 mA CMOS LDOs with Shutdown and ERROR Output |
| TC1054_07 | 制造商:MICROCHIP 制造商全称:Microchip Technology 功能描述:50 mA, 100 mA and 150 mA CMOS LDOs with Shutdown and ERROR Output |
| TC1054_12 | 制造商:MICROCHIP 制造商全称:Microchip Technology 功能描述:50 mA, 100 mA and 150 mA CMOS LDOs with Shutdown and ERROR Output |
发布紧急采购，3分钟左右您将得到回复。