- 您现在的位置：买卖IC网 > PDF目录14334 > TC115501EMTTR (Microchip Technology)IC REG BOOST 5V 0.1A SOT89-5 PDF资料下载
参数资料
| 型号： | TC115501EMTTR |
| 厂商： | Microchip Technology |
| 文件页数： | 6/14页 |
| 文件大小： | 0K |
| 描述： | IC REG BOOST 5V 0.1A SOT89-5 |
| 标准包装： | 1,000 |
| 类型： | 升压（升压） |
| 输出类型： | 固定 |
| 输出数： | 1 |
| 输出电压： | 5V |
| 输入电压： | 0.9 V ~ 10 V |
| 频率 - 开关： | 100kHz |
| 电流 - 输出： | 100mA |
| 同步整流器： | 无 |
| 工作温度： | -40°C ~ 85°C |
| 安装类型： | 表面贴装 |
| 封装/外壳： | SOT-89-5/6 |
| 包装： | 带卷 (TR) |
| 供应商设备封装： | SOT-89-5 |
TC115
5.0
APPLICATIONS
The inductor value directly affects the output ripple
voltage. Equation 5-3 is derived as shown below, and
5.1 Input Bypass Capacitors
Using an input bypass capacitor reduces peak current
transients drawn from the input supply and reduces the
switching noise generated by the regulator. The source
impedance of the input supply determines the size of
the capacitor that should be used.
can be used to calculate an inductor value, given the
required output ripple voltage (V RIPPLE ) and output
capacitor series resistance:
EQUATION 5-1:
V RIPPLE ≈ ESR ( di )
Where:
C 1
V IN
+
5 4
GND LX
TC115
NC PS SHDN
1 2 3
L 1
D 1
C 2 +
V OUT
ESR: the equivalent series resistance of the
output filter capacitor; V RIPPLE is in
volts.
di: represents the peak to peak ripple
current in the inductor.
Expressing di in terms of switch ON resistance and
time:
[ ( V IN – V SW ) t ON ]
V RIPPLE ≈ --------------------------------------------
FIGURE 5-1:
OFF ON
(Tie to V IN or V OUT
if not used)
TC115 Typical Application.
EQUATION 5-2:
Where:
L
[ ( V IN – V SW ) t ON ]
5.2 Inductor Selection
Selecting the proper inductor value is a trade-off
between physical size and power conversion require-
ments. Lower value inductors cost less, but result in
higher ripple current and core losses. They are also
more prone to saturate since the coil current ramps to
a higher value. Larger inductor values reduce both
ripple current and core losses, but are larger in physical
size and tend to increase the start-up time slightly.
Practical inductor values, therefore, range from 50 μH
to 300 μH. Inductors with a ferrite core (or equivalent)
are recommended. For highest efficiency, use an
inductor with a series resistance less than 0.1 ? ).
DS21361C-page 6
V SW = voltage drop across the switch.
T ON = the amount of time the switch is ON.
Solving for L:
EQUATION 5-3:
L ≈ --------------------------------------------
V RIPPLE
Care must be taken to ensure the inductor can handle
peak switching currents, which can be several times
load currents. Exceeding rated peak current will result
in core saturation and loss of inductance. The inductor
should be selected to withstand currents greater than
I PK (Equation 5-10) without saturating.
Calculating the peak inductor current is straightfor-
ward. Inductor current consists of an AC (sawtooth)
current centered on an average DC current (i.e., input
current). Equation 5-6 calculates the average DC cur-
rent. Note that minimum input voltage and maximum
load current values should be used:
EQUATION 5-4:
Output Power
Input Power = ---------------------------------
Efficiency
? 2003 Microchip Technology Inc.
相关PDF资料 |
PDF描述 |
|---|---|
| ECM06DRST-S664 | CONN EDGECARD 12POS DIP .156 SLD |
| VE-BT0-EX-F3 | CONVERTER MOD DC/DC 5V 75W |
| VE-BT0-EX-F2 | CONVERTER MOD DC/DC 5V 75W |
| RBM44DSEF-S243 | CONN EDGECARD 88POS .156 EYELET |
| EBM08DRST-S664 | CONN EDGECARD 16POS DIP .156 SLD |
相关代理商/技术参数 |
参数描述 |
|---|---|
| TC115A | 制造商:Thomas & Betts 功能描述:1 1/2" Compression Connector, Steel-Zinc Plated, Concrete tight 制造商:Thomas & Betts 功能描述:Fittings Connector 1.5inch Steel |
| TC115A-RT | 制造商:Thomas & Betts 功能描述:Fittings Connector 1.5inch Male Steel |
| TC115EV | 功能描述:电源管理IC开发工具 PFM/PWM Boost Conv EVAL BRD RoHS:否 制造商:Maxim Integrated 产品:Evaluation Kits 类型:Battery Management 工具用于评估:MAX17710GB 输入电压: 输出电压:1.8 V |
| TC115-PB-B | 制造商:Carling Technologies 功能描述:T-SERIES ROCKER SWITCH - Bulk |
| TC115-SC-1 | 制造商:Thomas & Betts 功能描述:1 1/2 CONN,COMP.,EMT,STL,EA |
发布紧急采购，3分钟左右您将得到回复。