参数资料
型号: TC647EOATR
元件分类: 运动控制电子
英文描述: BRUSHLESS DC MOTOR CONTROLLER, PDSO8
封装: 0.150 INCH, PLASTIC, SOIC-8
文件页数: 4/28页
文件大小: 478K
代理商: TC647EOATR
TC647
DS21447C-page 12
2002 Microchip Technology Inc.
FIGURE 5-5:
SENSE Waveforms.
Table 5-1 lists the recommended values of RSENSE
based on the nominal operating current of the fan. Note
that the current draw specified by the fan manufacturer
may be a worst-case rating for near-stall conditions and
not the fan’s nominal operating current. The values in
Table 5-1 refer to actual average operating current. If
the fan current falls between two of the values listed,
use the higher resistor value. The end result of employ-
ing Table 5-1 is that the signal developed across the
sense resistor is approximately 450 mV in amplitude.
TABLE 5-1:
RSENSE VS. FAN CURRENT
5.5
Output Drive Transistor Selection
The TC647 is designed to drive an external transistor
or MOSFET for modulating power to the fan. This is
and 5-9. The VOUT pin has a minimum source current
of 5 mA and a minimum sink current of 1 mA. Bipolar
transistors or MOSFETs may be used as the power
switching element, as shown in Figure 5-7. When high
current gain is needed to drive larger fans, two transis-
tors may be used in a Darlington configuration. These
circuit topologies are shown in Figure 5-7: (a) shows a
single NPN transistor used as the switching element;
(b) illustrates the Darlington pair; and (c) shows an N-
channel MOSFET.
One major advantage of the TC647’s PWM control
scheme versus linear speed control is that the power
dissipation in the pass element is kept very low. Gener-
ally, low cost devices in very small packages, such as
TO-92 or SOT, can be used effectively. For fans with
nominal operating currents of no more than 200 mA, a
single transistor usually suffices. Above 200 mA, the
Darlington or MOSFET solution is recommended. For
the fan sensing function to work correctly, it is impera-
tive that the pass transistor be fully saturated when
“on”.
Table 5-2 gives examples of some commonly available
transistors and MOSFETs. This table should be used
as a guide only since there are many transistors and
MOSFETs which will work just as well as those listed.
The critical issues when choosing a device to use as
Q1 are: (1) the breakdown voltage (V(BR)CEO or
VDS(MOSFET)) must be large enough to withstand the
highest voltage applied to the fan (Note: This will occur
when the fan is off); (2) 5 mA of base drive current must
be enough to saturate the transistor when conducting
the full fan current (transistor must have sufficient
gain); (3) the VOUT voltage must be high enough to suf-
ficiently drive the gate of the MOSFET to minimize the
RDS(on) of the device; (4) rated fan current draw must
be within the transistor's/MOSFET's current handling
capability; and (5) power dissipation must be kept
within the limits of the chosen device.
A base-current limiting resistor is required with bipolar
transistors. This is shown in Figure 5-6.
Nominal Fan Current (mA)
RSENSE ()
50
9.1
100
4.7
150
3.0
200
2.4
250
2.0
300
1.8
350
1.5
400
1.3
450
1.2
500
1.0
1
Ch1
100mV
Tek Run: 10.0kS/s Sample
Ch2
100mV
M5.00ms
Ch1
142mV
GND
[
T
]
T
Waveform @ Sense Resistor
90mV
50mV
GND
Waveform @ Sense Pin
2
相关PDF资料
PDF描述
TC647VUATR BRUSHLESS DC MOTOR CONTROLLER, PDSO8
TC647VOART BRUSHLESS DC MOTOR CONTROLLER, PDSO8
TC648EOA BRUSHLESS DC MOTOR CONTROLLER, PDSO8
TC648VOA BRUSHLESS DC MOTOR CONTROLLER, PDSO8
TC649BEPA BRUSHLESS DC MOTOR CONTROLLER, PDIP8
相关代理商/技术参数
参数描述
TC647EPA 制造商:MICROCHIP 制造商全称:Microchip Technology 功能描述:PWM Fan Speed Controller with FanSense Technology
TC647EUA 功能描述:马达/运动/点火控制器和驱动器 w/Fault Dtct RoHS:否 制造商:STMicroelectronics 产品:Stepper Motor Controllers / Drivers 类型:2 Phase Stepper Motor Driver 工作电源电压:8 V to 45 V 电源电流:0.5 mA 工作温度:- 25 C to + 125 C 安装风格:SMD/SMT 封装 / 箱体:HTSSOP-28 封装:Tube
TC647EUATR 功能描述:马达/运动/点火控制器和驱动器 w/Fault Dtct RoHS:否 制造商:STMicroelectronics 产品:Stepper Motor Controllers / Drivers 类型:2 Phase Stepper Motor Driver 工作电源电压:8 V to 45 V 电源电流:0.5 mA 工作温度:- 25 C to + 125 C 安装风格:SMD/SMT 封装 / 箱体:HTSSOP-28 封装:Tube
TC647VOA 功能描述:马达/运动/点火控制器和驱动器 w/Fault Dtct RoHS:否 制造商:STMicroelectronics 产品:Stepper Motor Controllers / Drivers 类型:2 Phase Stepper Motor Driver 工作电源电压:8 V to 45 V 电源电流:0.5 mA 工作温度:- 25 C to + 125 C 安装风格:SMD/SMT 封装 / 箱体:HTSSOP-28 封装:Tube
TC647VOA 制造商:Microchip Technology Inc 功能描述:Fan Management Controller IC Package/Cas