- 您现在的位置：买卖IC网 > PDF目录19541 > TC650CGVUATR (Microchip Technology)IC TEMP SNSR/DC FAN CNTRLR 8MSOP PDF资料下载
参数资料
| 型号： | TC650CGVUATR |
| 厂商： | Microchip Technology |
| 文件页数： | 7/16页 |
| 文件大小： | 0K |
| 描述： | IC TEMP SNSR/DC FAN CNTRLR 8MSOP |
| 标准包装： | 2,500 |
| 功能： | 风扇控制，温度监控器 |
| 传感器类型： | 内部 |
| 感应温度： | 35°C，55°C 跳闸点 |
| 精确度： | ±2.5°C（最小值） |
| 拓扑： | ADC |
| 输出类型： | 低有效 |
| 输出警报： | 是 |
| 输出风扇： | 是 |
| 电源电压： | 2.8 V ~ 5.5 V |
| 工作温度： | -40°C ~ 125°C |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 8-TSSOP，8-MSOP（0.118"，3.00mm 宽） |
| 供应商设备封装： | 8-MSOP |
| 包装： | 带卷 (TR) |
TC650/TC651
4.0
DETAILED DESCRIPTION
4.2
Start-Up Timer
The TC650/TC651 acquire and convert their junction
temperature (T J ) information from an on-chip, solid-
state sensor with a typical accuracy of ±1°C. The tem-
perature data is digitally stored in an internal register.
To ensure reliable fan start-up, the Start-up Timer turns
PWM high for about 2 seconds whenever the fan is
started from the off state. This occurs at power-up and
when coming out of Shutdown mode.
The register is compared with pre-defined threshold val-
ues. The six threshold values are equally distributed
4.3
Overtemperature Alert (T OVER )
1). The TC650/TC651 control the speed of a DC brush-
less fan using a fractional speed-control scheme. The
output stage requires only a 2N2222-type, small-signal
BJT for fans up to 300 mA. For larger current fans (up
to 1 amp), a logic-level N-channel MOSFET may be
used. In addition to controlling the speed of the fan, the
TC650/TC651 include an on-chip overtemperature
alarm (T OVER ) that gives a low signal when the temper-
ature of the chip exceeds T H by 10°C (typical). This fea-
ture eliminates the need for a separate temperature
shows the block diagram of the device.
This pin goes low when the T H set point is exceeded by
10°C (typical). This indicates that the fan is at
maximum drive and the potential exists for system
overheating; either heat dissipation in the system has
gone beyond the cooling system's design limits or
some fault exists (such as fan bearing failure or an air-
flow obstruction). This output may be treated as a
“System Overheat” warning and be used to either
trigger system shutdown or bring other fans in the
system to full speed. The fan will continue to run at full
speed while T OVER is asserted. Built-in hysteresis
prevents T OVER from “chattering” when the measured
temperature is at or near the T H + 10°C trip point. As
temperature falls through the T H + 10°C trip point, hys-
V DD
T OVER
SHDN
V+
teresis maintains the T OVER output low until the
measured temperature is 5°C above the trip point
Temperature
Set Point and
Trim Range
Duty Cycle
Logic
Control
PWM
setting.
4.4
Shutdown (SHDN)
The fan can be unconditionally shut down by pulling
A/D Converter
Temperature Sensor
Oscillator
the SHDN pin low. During shutdown, the PWM output
is low; ideal for notebook computers and other portable
applications where you need to change batteries and
must not have the fan running at that time. Thermal
monitoring and T OVER are still in operation during
shutdown. I DD shutdown current is around 50 μA.
FIGURE 4-1:
Functional Block Diagram.
4.5
Auto-shutdown Mode
The TC651 features auto-shutdown. When the
4.1 PWM Output
The PWM pin is designed to drive a low-cost transistor
or MOSFET as the low-side, power-switching element
in the system. This output has an asymmetric
complementary drive and is optimized for driving NPN
transistors or N-channel MOSFETs. Since the system
relies on PWM rather than linear power control, the
dissipation in the power switch is kept to a minimum.
Generally, very small devices (TO-92 or SOT
packages) will suffice. The frequency of the PWM is
about 15 Hz. The PWM is also the time base for the
Start-up Timer (see Section 4.2 “Start-Up Timer” ).
The PWM duty cycle has a range of 40% to 100% for
the TC650 and 50% to 100% for the TC651.
? 2004 Microchip Technology Inc.
temperature is below the factory set point at minimum
speed (T L ), PWM is low and the fan is automatically
shut off (Auto-shutdown mode). This feature is ideal for
notebook computers and other portable equipment that
need to conserve as much battery power as possible
and, thus, run a fan when it is only absolutely needed.
The TC651 will continue to be active in order to monitor
temperature for T OVER . The TC651 exits Auto-
shutdown mode when the temperature rises above the
factory set point (T 1 ).
DS21450C-page 7
相关PDF资料 |
PDF描述 |
|---|---|
| EBC08DRXH | CONN EDGECARD 16POS DIP .100 SLD |
| A561K15X7RL5UAA | CAP CER 560PF 500V 10% X7R AXIAL |
| TC651AEVUATR | IC TEMP SNSR/DC FAN CNTRLR 8MSOP |
| TPSB156K010R0450 | CAP TANT 15UF 10V 10% 1210 |
| A561K15X7RL5TAA | CAP CER 560PF 500V 10% X7R AXIAL |
相关代理商/技术参数 |
参数描述 |
|---|---|
| TC650DAVUA | 制造商:MICROCHIP 制造商全称:Microchip Technology 功能描述:Tiny Integrated Temperature Sensor & Brushless DC Fan Controller with Over-Temperature Alert |
| TC650DBVUA | 制造商:MICROCHIP 制造商全称:Microchip Technology 功能描述:Tiny Integrated Temperature Sensor & Brushless DC Fan Controller with Over-Temperature Alert |
| TC650DCVUA | 制造商:MICROCHIP 制造商全称:Microchip Technology 功能描述:Tiny Integrated Temperature Sensor & Brushless DC Fan Controller with Over-Temperature Alert |
| TC650DDVUA | 制造商:MICROCHIP 制造商全称:Microchip Technology 功能描述:Tiny Integrated Temperature Sensor & Brushless DC Fan Controller with Over-Temperature Alert |
| TC650DEMO | 功能描述:温度传感器开发工具 For TC650/651 RoHS:否 制造商:Texas Instruments 产品类型:Temperature Sensors and Control ICs 工具用于评估:MSP430G2553 接口类型:USB 工作电源电压: 工作电源电流: |
发布紧急采购，3分钟左右您将得到回复。