- 您现在的位置：买卖IC网 > PDF目录98171 > TC7106RCPLIJL 1-CH DUAL-SLOPE ADC, ACCESS, PDIP40 PDF资料下载
参数资料
| 型号： | TC7106RCPLIJL |
| 元件分类： | ADC |
| 英文描述： | 1-CH DUAL-SLOPE ADC, ACCESS, PDIP40 |
| 封装： | CERDIP-40 |
| 文件页数： | 6/21页 |
| 文件大小： | 269K |
| 代理商： | TC7106RCPLIJL |
14
TC7106
TC7106A
TC7107
TC7107A
3-1/2 DIGIT A/D CONVERTERS
POWER SUPPLIES
The TC7107A is designed to work from
±5V supplies.
However, if a negative supply is not available, it can be
generated from the clock output with two diodes, two capaci-
tors, and an inexpensive IC. (Figure 12)
In selected applications a negative supply is not re-
quired. The conditions to use a single +5V supply are:
The input signal can be referenced to the center of the
common-mode range of the converter.
The signal is less than
±1.5V.
An external reference is used.
The TSC7660 DC to DC converter may be used to
generate – 5 V from +5 V (Figure 13).
TC7107A
V
+
OSC1
OSC2
OSC3
GND
V
–
V
+
CD4009
0.047
F
1N914
10
F
–
+
V
–
= –3.3V
Figure 12. Generating Negative Supply From +5 V
GND
VIN
–
VIN
+
VREF
+
VREF
–
COM
+5 V
LED
DRIVE
36
1
35
32
31
30
26
V
+
V
–
21
TC7660
3
10F
+
10F
+
2
8
5
*3-1/2 DIGIT ADC
(–5 V)
TC7107A
4
VIN
Figure 13. Negative Power Supply Generation with TC7660
TC7107 Power Dissipation Reduction
The TC7107A sinks the LED display current and this
causes heat to build up in the IC package. If the internal
voltage reference is used, the changing chip temperature
can cause the display to change reading. By reducing the
LED common anode voltage the TC7107A package power
dissipation is reduced.
Figure 14 is a photograph of a curve-tracer display
showing the relationship between output current and output
voltage for a typical TC7107CPL. Since a typical LED has
1.8 volts across it at 7mA, and its common anode is con-
nected to +5V, the TC7107A output is at 3.2V (point A on
Figure 13). Maximum power dissipation is 8.1mA x 3.2V x
24 segments = 622mW.
Notice, however, that once the TC7107A output voltage
is above two volts, the LED current is essentially constant as
output voltage increases. Reducing the output voltage by
0.7V (point B in Figure 14) results in 7.7mA of LED current,
only a 5 percent reduction. Maximum power dissipation is
only 7.7mA x 2.5 V x 24 = 462mW, a reduction of 26%. An
output voltage reduction of 1 volt (point C) reduces LED
current by 10% (7.3mA) but power dissipation by 38%!
(7.3mA x 2.2V x 24 = 385mW).
Reduced power dissipation is very easy to obtain.
Figure 15 shows two ways: either a 5.1 ohm, 1/4 watt resistor
or a 1 Amp diode placed in series with the display (but not in
series with the TC7107A). The resistor will reduce the
TC7107A output voltage, when all 24 segments are “ON,” to
point “C” of Figure 14. When segments turn off, the output
voltage will increase. The diode, on the other hand, will result
in a relatively steady output voltage, around point “B.”
Figure 14. TC7107A Output Current vs Output Voltage
相关PDF资料 |
PDF描述 |
|---|---|
| TC7107ACPLIJL | 1-CH DUAL-SLOPE ADC, ACCESS, PDIP40 |
| TC7107ACPLIJL | 1-CH DUAL-SLOPE ADC, PDIP40 |
| TC7106RCPLIJL | 1-CH DUAL-SLOPE ADC, PDIP40 |
| TC7107RCPLIJL | 1-CH DUAL-SLOPE ADC, PDIP40 |
| TC7107AILW713 | 1-CH DUAL-SLOPE ADC, PARALLEL ACCESS, PQCC44 |
相关代理商/技术参数 |
参数描述 |
|---|---|
| TC7107 | 制造商:TELCOM 制造商全称:TelCom Semiconductor, Inc 功能描述:3-1/2 DIGIT A/D CONVERTERS |
| TC7107A | 制造商:MICROCHIP 制造商全称:Microchip Technology 功能描述:3-1/2 Digit Analog-to-Digital Converters |
| TC7107ACKW | 功能描述:LED显示驱动器 w/LED Driver RoHS:否 制造商:Micrel 数位数量:5 片段数量: 安装风格:SMD/SMT 封装 / 箱体:PLCC-44 工作电源电压:4.75 V to 11 V 最大电源电流:10 mA 最大工作温度:+ 85 C 最小工作温度:- 40 C 封装:Tube |
| TC7107ACKW713 | 功能描述:LED显示驱动器 w/LED Driver RoHS:否 制造商:Micrel 数位数量:5 片段数量: 安装风格:SMD/SMT 封装 / 箱体:PLCC-44 工作电源电压:4.75 V to 11 V 最大电源电流:10 mA 最大工作温度:+ 85 C 最小工作温度:- 40 C 封装:Tube |
| TC7107ACLW | 功能描述:LED显示驱动器 w/LED Driver RoHS:否 制造商:Micrel 数位数量:5 片段数量: 安装风格:SMD/SMT 封装 / 箱体:PLCC-44 工作电源电压:4.75 V to 11 V 最大电源电流:10 mA 最大工作温度:+ 85 C 最小工作温度:- 40 C 封装:Tube |
发布紧急采购，3分钟左右您将得到回复。