参数资料
| 型号： | TC7109IJL |
| 厂商： | Microchip Technology |
| 文件页数： | 9/30页 |
| 文件大小： | 0K |
| 描述： | IC ADC 12BIT HANDSHAKE 40CDIP |
| 标准包装： | 10 |
| 位数： | 12 |
| 数据接口： | 串行，并联 |
| 转换器数目： | 1 |
| 电压电源： | 双 ± |
| 工作温度： | -25°C ~ 85°C |
| 安装类型： | 通孔 |
| 封装/外壳： | 40-CDIP（0.600"，15.24mm） |
| 供应商设备封装： | 40-Cerdip |
| 包装： | 管件 |
| 输入数目和类型： | 1 个差分，单极 |
第1页第2页第3页第4页第5页第6页第7页第8页当前第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页
2006 Microchip Technology Inc.
DS21456C-page 17
TC7109/A
4.0
INTERFACING
4.1
Direct Mode
Combinations of chip enable and byte enable control
signals, which may be used when interfacing the
TC7109A to parallel data lines, are shown in Figure .
The CE/LOAD input may be tied low, allowing either byte
to be controlled by its own enable (see Figure (A)).
Figure (B) shows the HBEN and LBEN as flag inputs,
and CE/LOAD as a master enable, which could be the
READ strobe available from most microprocessors.
Figure (C) shows a configuration where the two byte
enables are connected together. The CE/LOAD is a
chip enable, and the HBEN and LBEN may be used as
a second chip enable, or connected to ground. The 14
data outputs will be enabled at the same time. In the
direct MODE, SEND should be tied to V+.
Figure shows interfacing several TC7109A’s to a bus,
ganging the HBEN and LBEN signals to several
converters together, and using the CE/LOAD input to
select the desired converter.
the parallel three-state output capabilities of the
TC7109A. Figure shows parallel interface to the 8748/
49 systems via an 8255 PPI, where the TC7109A data
outputs are active at all times. This interface can be
used in a read-after-update sequence, as shown in
Figure . The data is accessed by the high-to-low
transition of the Status driving an interrupt to the
microcontroller.
The RUN/HOLD
input is
also used to initiate
conversions under software control.
Direct interfacing to most microcontroller busses is
easily accomplished through the three-state output of
the TC7109A.
Figure 4-8 is a typical connection diagram. To ensure
requirements for setup and hold times, minimum pulse
widths, and the drive limitations on long busses are
met, it is necessary to carefully consider the system
timing in this type of interface. This type of interface is
used when the memory peripheral address density is
low, providing simple address decoding. Interrupt
handling can be simplified by using an interface to
reduce the component count.
FIGURE 4-1:
Direct Mode Chip and Byte Enable Combination
TC7109A
MODE
CE/LOAD
B9 - B12
POL, OR
B1 - B8
LBEN
HBEN
GND
8
Analog In
6
Convert
Control
RUN/HOLD
TC7109A
MODE
CE/LOAD
B1 - B12
POL, OR
LBEN
HBEN
GND
Analog In
Convert
RUN/HOLD
TC7109A
MODE
CE/LOAD
B9 - B12
POL, OR
B1 - B8
LBEN
HBEN
8
Analog In
6
Convert
RUN/HOLD
Chip Select 1
GND or
Chip Select 2
14
Byte Flags
GND
Chip Select
A.B.
C.
相关PDF资料 |
PDF描述 |
|---|---|
| MAX3186EAP+T | IC RS-232 SERIAL 230KBPS 20-SSOP |
| MAX3186EWP+T | IC RS-232 SERIAL 230KBPS 20-SOIC |
| MS27505E11B98PB | CONN RCPT 6POS BOX MNT W/PINS |
| VE-B52-MW-F1 | CONVERTER MOD DC/DC 15V 100W |
| MS27496E9B35S | CONN RCPT 6POS BOX MNT W/SCKT |
相关代理商/技术参数 |
参数描述 |
|---|---|
| TC7-10-C100 | 功能描述:电缆固定件和配件 CBL STRAP W/ TACK NAIL RoHS:否 制造商:Heyco 类型:Cable Grips, Liquid Tight 材料:Nylon 颜色:Black 安装方法:Cable 最大光束直径:11.4 mm 抗拉强度: |
| TC7110A | 制造商:Thomas & Betts 功能描述:Fittings Connector 4inch Steel |
| TC7110A-RT | 制造商:Thomas & Betts 功能描述:4 IN INSL RAINTIGTH COMP FITTING |
| TC7110US | 制造商:Thomas & Betts 功能描述:SG TC7110US 4 IN INS EMT COMPRESSIO |
| TC7116 | 制造商:MICROCHIP 制造商全称:Microchip Technology 功能描述:3-1/2 Digit Analog-to-Digital Converters with Hold |
发布紧急采购，3分钟左右您将得到回复。