- 您现在的位置：买卖IC网 > PDF目录98183 > TC850CLW713 1-CH 15-BIT MULTI-SLOPE ADC, PARALLEL ACCESS, PQCC44 PDF资料下载
参数资料
| 型号： | TC850CLW713 |
| 元件分类： | ADC |
| 英文描述： | 1-CH 15-BIT MULTI-SLOPE ADC, PARALLEL ACCESS, PQCC44 |
| 封装： | PLASTIC, LCC-44 |
| 文件页数： | 9/26页 |
| 文件大小： | 417K |
| 代理商： | TC850CLW713 |
2006 Microchip Technology Inc.
DS21479C-page 17
TC850
Figure 8-3 shows a typical interface to a
μP I/O port or
single-chip
μC. The TC850 operates in the Continuous
mode and can either interrupt the
μC/μP or be polled
with an input pin.
FIGURE 8-3:
Interface to Typical
μP I/O
Port or Single Chip
μC
Since the PA0-PA7 inputs are dedicated to reading A/D
data, the A/D CS/CE inputs can be enabled continu-
ously. In Continuous mode, data must be read in 3
bytes, as shown in Table 6-1. The required RD pulses
are provided by a
μC/μP output pin.
The circuit of Figure 8-3 can also operate in the
Demand mode, with the start-up conversion strobe
generated by a
μC/μP output pin. In this case, the L/H
and CONT/DEMAND inputs can be controlled by I/O
pins and the RD input connected to digital ground.
8.3
Demand Mode Interface Timing
When CONT/DEMAND input is LOW, the TC850
performs a conversion each time CE and CS are active
and WR is strobed LOW.
The Demand mode conversion timing is shown in
Figure 8-1. BUSY goes LOW and data is valid 1155
clock pulses after WR goes LOW. After BUSY goes
low, 125 additional clock cycles are required before the
next conversion cycle will begin.
Once conversion is started, WR is ignored for 1100
internal clock cycles. After 1100 clock cycles, another
WR pulse is recognized and initiates a new conversion
when the present conversion is complete. A negative
edge on WR is required to begin conversion. If WR is
held LOW, conversions will not occur continuously.
The A/D conversion data is valid on the falling edge of
BUSY and remains valid until one-half internal clock
cycle before BUSY goes HIGH on the succeeding
conversion. BUSY can be monitored with an I/O pin to
determine end of conversion or to generate a
μP
interrupt.
In Demand mode, the three data bytes can be read in
any desired order. The TC850 is simply regarded as
three bytes of memory and accessed accordingly. The
bus output timing is shown in Figure 8-2.
8.4
Continuous Mode Interface Timing
When the CONT/DEMAND input is HIGH, the TC850
performs conversions continuously. Data will be valid
on the falling edge of BUSY and all three bytes must be
read within 443-1/2 internal clock cycles of BUSY going
LOW. The timing diagram is shown in Figure 8-3.
In Continuous mode, OVR/POL and L/H byte-select
inputs are ignored. The TC850 automatically cycles
through three data bytes, as shown in Table 6-1. Bus
output timing in the Continuous mode is shown in
DB0
DB1
DB2
DB3
DB4
DB5
DB6
DB7
BUSY
RD
PB0
CS
NC
CE
WR
+5V
PA0
PA1
PA2
PA3
PA4
PA5
PA6
PA7
INTERRUPT
CONT/DEMAND
mC OR mP
I/O PORT
TC850
相关PDF资料 |
PDF描述 |
|---|---|
| TC850ILW | 1-CH 15-BIT MULTI-SLOPE ADC, PARALLEL ACCESS, PQCC44 |
| TC9028P | INFRARED, TRANSMITTER IC, PDIP20 |
| TC9028F | INFRARED, TRANSMITTER IC, PDSO20 |
| TC9083N | PICTURE-IN-PICTURE IC, PDIP42 |
| TC9090AN | Y/C SEPARATOR IC, PDIP28 |
相关代理商/技术参数 |
参数描述 |
|---|---|
| TC850CPL | 功能描述:模数转换器 - ADC 16 Bit Hi Speed A/D RoHS:否 制造商:Texas Instruments 通道数量:2 结构:Sigma-Delta 转换速率:125 SPs to 8 KSPs 分辨率:24 bit 输入类型:Differential 信噪比:107 dB 接口类型:SPI 工作电源电压:1.7 V to 3.6 V, 2.7 V to 5.25 V 最大工作温度:+ 85 C 安装风格:SMD/SMT 封装 / 箱体:VQFN-32 |
| TC850IJL | 功能描述:模数转换器 - ADC 16 Bit Hi Speed A/D RoHS:否 制造商:Texas Instruments 通道数量:2 结构:Sigma-Delta 转换速率:125 SPs to 8 KSPs 分辨率:24 bit 输入类型:Differential 信噪比:107 dB 接口类型:SPI 工作电源电压:1.7 V to 3.6 V, 2.7 V to 5.25 V 最大工作温度:+ 85 C 安装风格:SMD/SMT 封装 / 箱体:VQFN-32 |
| TC850ILW | 功能描述:模数转换器 - ADC 16 Bit Hi Speed A/D RoHS:否 制造商:Texas Instruments 通道数量:2 结构:Sigma-Delta 转换速率:125 SPs to 8 KSPs 分辨率:24 bit 输入类型:Differential 信噪比:107 dB 接口类型:SPI 工作电源电压:1.7 V to 3.6 V, 2.7 V to 5.25 V 最大工作温度:+ 85 C 安装风格:SMD/SMT 封装 / 箱体:VQFN-32 |
| TC850ILW713 | 功能描述:模数转换器 - ADC 16 Bit Hi Speed A/D RoHS:否 制造商:Texas Instruments 通道数量:2 结构:Sigma-Delta 转换速率:125 SPs to 8 KSPs 分辨率:24 bit 输入类型:Differential 信噪比:107 dB 接口类型:SPI 工作电源电压:1.7 V to 3.6 V, 2.7 V to 5.25 V 最大工作温度:+ 85 C 安装风格:SMD/SMT 封装 / 箱体:VQFN-32 |
| TC8521AM | 制造商:TOSHIBA 制造商全称:Toshiba Semiconductor 功能描述:REAL TIME CLOCK ケ |
发布紧急采购，3分钟左右您将得到回复。