- 您现在的位置：买卖IC网 > PDF目录98184 > TC9400CPD VOLTAGE-FREQUENCY CONVERTER, 0.1 MHz, PDIP14 PDF资料下载
参数资料
| 型号： | TC9400CPD |
| 元件分类： | 模拟专用变换器 |
| 英文描述： | VOLTAGE-FREQUENCY CONVERTER, 0.1 MHz, PDIP14 |
| 封装： | PLASTIC, DIP-14 |
| 文件页数： | 6/28页 |
| 文件大小： | 545K |
| 代理商： | TC9400CPD |
第1页第2页第3页第4页第5页当前第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页
TC9400/9401/9402
DS21483D-page 14
2007 Microchip Technology Inc.
6.0
F/V CONVERTER DESIGN
INFORMATION
6.1
Input/Output Relationships
The output voltage is related to the input frequency
(FIN) by the transfer equation:
EQUATION 6-1:
The response time to a change in FIN is equal to (RINT
CINT). The amount of ripple on VOUT is inversely
proportional to CINT and the input frequency.
CINT can be increased to lower the ripple. Values of
1 F to 100 F are perfectly acceptable for low frequen-
cies.
When the TC9400 is used in the Single Supply mode,
VREF is defined as the voltage difference between Pin 7
and Pin 2.
6.2
Input Voltage Levels
The input frequency is applied to the Threshold
Detector input (Pin 11). As discussed in the V/F circuit
section of this data sheet, the threshold of Pin 11 is
approximately (VDD + VSS)/2 ±400 mV. Pin 11’s input
voltage range extends from VDD to about 2.5V below
the threshold. If the voltage on Pin 11 goes more than
2.5 volts below the threshold, the V/F mode start-up
comparator will turn on and corrupt the output voltage.
The Threshold Detector input has about 200 mV of
hysteresis.
In ±5V applications, the input voltage levels for the
TC9400 are ±400 mV, minimum. If the frequency
source being measured is unipolar, such as TTL or
CMOS operating from a +5V source, then an AC
coupled level shifter should be used. One such circuit
is shown in Figure 6-1(a).
The level shifter circuit in Figure 6-1(b) can be used in
single supply F/V applications. The resistor divider
ensures that the input threshold will track the supply
voltages. The diode clamp prevents the input from
going far enough in the negative direction to turn on the
start-up comparator. The diode’s forward voltage
decreases by 2.1 mV/°C, so for high ambient
temperature operation, two diodes in series are
recommended.
FIGURE 6-1:
Frequency Input Level Shifter.
VOUT = [VREF CREF RINT] FIN
+5V
14
64
+5V
-5V
VDD
1.0
11
33 k
Ω
IN914
VSS
DET
TC9400
(a) ±5V Supply
(b) Single Supply
0.01 F
Frequency
Input
0V
GND
+8V to +15V
14
10 k
Ω
4
+5V
VDD
1.0
11
33 k
Ω
IN914
VSS
DET
TC9400
0.01 F
Frequency
Input
0V
0.1 F 10 kΩ
M
Ω
M
Ω
相关PDF资料 |
PDF描述 |
|---|---|
| TC9400EJDG | VOLTAGE-FREQUENCY CONVERTER, 0.1 MHz, CDIP14 |
| TC9400COD713 | VOLTAGE-FREQUENCY CONVERTER, 0.1 MHz, PDSO14 |
| TC9402EJD | VOLTAGE-FREQUENCY CONVERTER, 0.1 MHz, CDIP14 |
| TC9400EJD | VOLTAGE-FREQUENCY CONVERTER, 0.1 MHz, CDIP14 |
| TC9404FNG | PARALLEL, WORD INPUT LOADING, 1-BIT DAC, PDSO24 |
相关代理商/技术参数 |
参数描述 |
|---|---|
| TC9400CPD | 制造商:Microchip Technology Inc 功能描述:IC F/V-V/F CONVERTER 9400 DIP14 |
| TC9400CPD | 制造商:Microchip Technology Inc 功能描述:IC F/V-V/F CONVERTER 9400 DIP14 |
| TC9400EJD | 功能描述:电压频率转换及频率电压转换 V/F Converter RoHS:否 制造商:Texas Instruments 全标度频率:4000 KHz 线性误差:+/- 1 % FSR 电源电压-最大: 电源电压-最小: 最大工作温度:+ 85 C 最小工作温度:- 25 C 安装风格:Through Hole 封装 / 箱体:PDIP-14 封装:Tube |
| TC9400F | 制造商:TOSHIBA 制造商全称:Toshiba Semiconductor 功能描述:SIGMA-DELTA MODULATION SYSTEM DA CONVERTER WITH A BUILT-IN 8-TIMES OVER SAMPLING DIGITAL FILTER / DIGITALATTENUATOR |
| TC9400N | 制造商:TOSHIBA 制造商全称:Toshiba Semiconductor 功能描述:SIGMA-DELTA MODULATION SYSTEM DA CONVERTER WITH A BUILT-IN 8-TIMES OVER SAMPLING DIGITAL FILTER / DIGITALATTENUATOR |
发布紧急采购，3分钟左右您将得到回复。