- 您现在的位置：买卖IC网 > PDF目录98184 > TC9401CPD VOLTAGE-FREQUENCY CONVERTER, 0.1 MHz, PDIP14 PDF资料下载
参数资料
| 型号： | TC9401CPD |
| 元件分类： | 模拟专用变换器 |
| 英文描述： | VOLTAGE-FREQUENCY CONVERTER, 0.1 MHz, PDIP14 |
| 封装： | PLASTIC, DIP-14 |
| 文件页数： | 26/28页 |
| 文件大小： | 545K |
| 代理商： | TC9401CPD |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页当前第26页第27页第28页
2007 Microchip Technology Inc.
DS21483D-page 7
TC9400/9401/9402
2.6
Pulse Freq Out
This output is an open-drain N-channel FET, which
provides a pulse waveform whose frequency is propor-
tional to the input voltage. This output requires a pull-
up resistor and interfaces directly with MOS, CMOS,
and TTL logic (see Figure 2-1).
2.7
Output Common
The sources of both the FREQ/2 OUT and the PULSE
FREQ OUT are connected to this pin. An output level
swing from the drain voltage to ground, or to the VSS
supply, may be obtained by connecting this pin to the
appropriate point.
2.8
Freq/2 Out
This output is an open-drain N-channel FET, which
provides a square-wave one-half the frequency of the
pulse frequency output. The FREQ/2 OUT output will
change state on the rising edge of PULSE FREQ OUT.
This output requires a pull-up resistor and interfaces
directly with MOS, CMOS, and TTL logic.
2.9
Threshold Detector Input
In the V/F mode, this input is connected to the AMPLI-
FIER OUT output (Pin 12) and triggers a 3 s pulse
when the input voltage passes through its threshold. In
the F/V mode, the input frequency is applied to this
input.
The nominal threshold of the detector is half way
between the power supplies, or (VDD + VSS)/2 ±400
mV. The TC9400’s charge balancing V/F technique is
not dependent on a precision comparator threshold,
because the threshold only sets the lower limit of the op
amp output. The op amp’s peak-to-peak output swing,
which determines the frequency, is only influenced by
external capacitors and by VREF.
2.10
Amplifier Out
This pin is the output stage of the operational amplifier.
During V/F operation, a negative going ramp signal is
available at this pin. In the F/V mode, a voltage
proportional to the frequency input is generated.
FIGURE 2-1:
Output Waveforms.
3ms
Typ.
1/f
FOUT
FOUT/2
Amp Out
VREF
0V
CREF
CINT
Note 1: To adjust FMIN, set VIN = 10 mV and adjust the 50 kΩ offset for 10 Hz output.
2: To adjust FMAX, set VIN = 10V and adjust RIN or VREF for 10 kHz output.
3: To increase FOUTMAX to 100 kHz, change CREF to 2 pF and CINT to 75 pF.
4: For high performance applications, use high stability components for RIN, CREF. VREF (metal film
resistors and glass capacitors). Also, separate output ground (Pin 9) from input ground (Pin 6).
相关PDF资料 |
PDF描述 |
|---|---|
| TC9400COD | VOLTAGE-FREQUENCY CONVERTER, 0.1 MHz, PDSO14 |
| TC9401EJD | VOLTAGE-FREQUENCY CONVERTER, 0.1 MHz, CDIP14 |
| TC9400CPD | VOLTAGE-FREQUENCY CONVERTER, 0.1 MHz, PDIP14 |
| TC9400EJDG | VOLTAGE-FREQUENCY CONVERTER, 0.1 MHz, CDIP14 |
| TC9400COD713 | VOLTAGE-FREQUENCY CONVERTER, 0.1 MHz, PDSO14 |
相关代理商/技术参数 |
参数描述 |
|---|---|
| TC9401EJD | 功能描述:电压频率转换及频率电压转换 V/F Converter RoHS:否 制造商:Texas Instruments 全标度频率:4000 KHz 线性误差:+/- 1 % FSR 电源电压-最大: 电源电压-最小: 最大工作温度:+ 85 C 最小工作温度:- 25 C 安装风格:Through Hole 封装 / 箱体:PDIP-14 封装:Tube |
| TC9402 | 制造商:TELCOM 制造商全称:TelCom Semiconductor, Inc 功能描述:VOLTAGE-TO-FREQUENCY/FREQUENCY-TO-VOLTAGE CONVERTERS |
| TC9402CPD | 功能描述:电压频率转换及频率电压转换 V/F Converter RoHS:否 制造商:Texas Instruments 全标度频率:4000 KHz 线性误差:+/- 1 % FSR 电源电压-最大: 电源电压-最小: 最大工作温度:+ 85 C 最小工作温度:- 25 C 安装风格:Through Hole 封装 / 箱体:PDIP-14 封装:Tube |
| TC9402CPD | 制造商:Microchip Technology Inc 功能描述:IC F/V-V/F CONVERTER |
| TC9402CPD | 制造商:Microchip Technology Inc 功能描述:V/F Converter |
发布紧急采购，3分钟左右您将得到回复。