- 您现在的位置：买卖IC网 > PDF目录98190 > TDA2030AV (STMICROELECTRONICS) 18 W, 1 CHANNEL, AUDIO AMPLIFIER, PZFM5 PDF资料下载
参数资料
| 型号： | TDA2030AV |
| 厂商： | STMICROELECTRONICS |
| 元件分类： | 音频／视频放大 |
| 英文描述： | 18 W, 1 CHANNEL, AUDIO AMPLIFIER, PZFM5 |
| 封装： | PENTAWATT-5 |
| 文件页数： | 3/15页 |
| 文件大小： | 1403K |
| 代理商： | TDA2030AV |
MUSICAL INSTRUMENTS AMPLIFIERS
Another important field of application for active
systems is music.
In this area the use of several medium power
amplifiers is more convenient than a single high
power amplifier, and it is also more realiable.
A typical example (see Figure 21) consist of four
amplifiers each driving a low-cost, 12 inch loud-
speaker. This application can supply 80 to
160WRMS.
Figure 21 : High Power Active Box
for Musical Instrument
TRANSIENT INTERMODULATION DISTOR-
TION (TIM)
Transient intermodulation distortion is an unfortu-
nate phenomen associated with negative-feedback
amplifiers. When a feedback amplifier receives an
input signal which rises very steeply, i.e. contains
high-frequency components, the feedback can ar-
rive too late so that the amplifiers overloads and a
burst of intermodulation distortion will be produced
as in Figure 22. Since transients occur frequently
in music this obviously a problem for the designer
of audio amplifiers. Unfortunately, heavy negative
feedback is frequency used to reduce the total
harmonic distortion of an amplifier, which tends to
aggravate the transient intermodulation (TIM situ-
ation. The best known method for the measurement
of TIM consists of feeding sine waves superim-
posed onto square waves, into the amplifier under
test. The output spectrum is then examined using
a spectrum analyser and compared to the input.
This method suffers from serious disadvantages :
the accuracy is limited, the measurement is a rather
delicate operation and an expensive spectrum an-
alyser is essential. A new approach (see Technical
Note 143) applied by SGS-THOMSON to mono-
lithic amplifiers measurement is fast cheap-it re-
quires nothing more sophisticated than an
oscilloscope - and sensitive - and it can be used
down to the values as low as 0.002% in high power
amplifiers.
Figure 22 : Overshoot Phenomenon in Feedback
Amplifiers
The "inverting-sawtooh" method of measurement
is based on the response of an amplifier to a 20kHz
sawtooth waveform. The amplifier has no difficulty
following the slow ramp but it cannot follow the fast
edge. The output will follow the upper line in Fig-
ure 23 cutting of the shaded area and thus increas-
ing the mean level. If this output signal is filtered to
remove the sawtooth, direct voltage remains which
indicates the amount of TIM distortion, although it
is difficult to measure because it is indistinguish-
able from the DC offset of the amplifier. This prob-
lem is neatly avoided in the IS-TIM method by
periodically inverting the sawtooth waveform at a
low audio frequency as shown in Figure 24.
Figure 23 : 20kHz Sawtooth Waveform
Figure 24 : Inverting Sawtooth Waveform
TDA2030A
11/15
相关PDF资料 |
PDF描述 |
|---|---|
| TDA2030H | 18 W, 1 CHANNEL, AUDIO AMPLIFIER, PZFM5 |
| TDA2030V | 18 W, 1 CHANNEL, AUDIO AMPLIFIER, PZFM5 |
| TDA2040V | 22 W, 1 CHANNEL, AUDIO AMPLIFIER, PZFM5 |
| TDA2052H | 60 W, 1 CHANNEL, AUDIO AMPLIFIER, PZFM7 |
| TDA2052V | 60 W, 1 CHANNEL, AUDIO AMPLIFIER, PZFM7 |
相关代理商/技术参数 |
参数描述 |
|---|---|
| TDA2030AV | 制造商:STMicroelectronics 功能描述:IC AUDIO AMP 18W |
| TDA2030H | 功能描述:音频放大器 14W Hi-Fi Audio Amp RoHS:否 制造商:STMicroelectronics 产品:General Purpose Audio Amplifiers 输出类型:Digital 输出功率: THD + 噪声: 工作电源电压:3.3 V 电源电流: 最大功率耗散: 最大工作温度: 安装风格:SMD/SMT 封装 / 箱体:TQFP-64 封装:Reel |
| TDA2030H | 制造商:STMicroelectronics 功能描述:IC AUDIO AMP 14W |
| TDA2030L-TA5-T | 制造商:UTC-IC 制造商全称:UTC-IC 功能描述:14W HI-FI AUDIO AMPLIFIER |
| TDA2030L-TB5-T | 制造商:UTC-IC 制造商全称:UTC-IC 功能描述:14W HI-FI AUDIO AMPLIFIER |
发布紧急采购，3分钟左右您将得到回复。