- 您现在的位置：买卖IC网 > PDF目录85413 > TDA4854/V2 (NXP SEMICONDUCTORS) HORIZ/VERT DEFLECTION IC, PDIP32 PDF资料下载
参数资料
| 型号： | TDA4854/V2 |
| 厂商： | NXP SEMICONDUCTORS |
| 元件分类： | 偏转 |
| 英文描述： | HORIZ/VERT DEFLECTION IC, PDIP32 |
| 封装： | PLASTIC, SDIP-32 |
| 文件页数： | 6/63页 |
| 文件大小： | 318K |
| 代理商： | TDA4854/V2 |
第1页第2页第3页第4页第5页当前第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页第32页第33页第34页第35页第36页第37页第38页第39页第40页第41页第42页第43页第44页第45页第46页第47页第48页第49页第50页第51页第52页第53页第54页第55页第56页第57页第58页第59页第60页第61页第62页第63页
1999 Jul 13
14
Philips Semiconductors
Product specication
I2C-bus autosync deection controllers for
PC/TV monitors
TDA4853; TDA4854
For supply voltages below 8.3 V the internal I2C-bus will
not generate an acknowledge and the IC is in standby
mode. This is because the internal protection circuit has
generated a reset signal for the soft start
register SOFTST. Above 8.3 V data is accepted and all
registers can be loaded. If the register SOFTST has
received a set from the I2C-bus, the internal soft start
procedure is released, which activates all mentioned
outputs.
If during normal operation the supply voltage has dropped
below 8.1 V, the protection mode is activated and
HUNLOCK (pin 17) changes to the protection status and is
floating. This can be detected by the microcontroller.
This protection mode has been implemented in order to
protect the deflection stages and the picture tube during
start-up, shut-down and fault conditions. This protection
mode can be activated as shown in Table 3.
Table 3
Activation of protection mode
When the protection mode is active, several pins of the
TDA4853; TDA4854 are forced into a defined state:
HDRV (horizontal driver output) is floating
BDRV (B+ control driver output) is floating
HUNLOCK (indicates, that the frequency-to-voltage
converter is out of lock) is floating (HIGH via external
pull-up resistor)
CLBL provides a continuous blanking signal
VOUT1 and VOUT2 (vertical outputs) are floating
The capacitor at HPLL2 is discharged.
If the soft start procedure is activated via the I2C-bus, all of
these actions will be performed in a well defined sequence
(see Figs 25 and 26).
ACTIVATION
RESET
Low supply voltage at
pin 10
increase supply voltage;
reload registers;
soft start via I2C-bus
Power dip, below 8.1 V
reload registers;
soft start via I2C-bus
X-ray protection (pin 2)
triggered, XSEL (pin 9) is
open-circuit or connected
to ground
reload registers;
soft start via I2C-bus
X-ray protection (pin 2)
triggered, XSEL (pin 9)
connected to VCC via an
external resistor
switch VCC off and on
again, reload registers;
soft start via I2C-bus
HPLL2 (pin 30) externally
pulled to ground
release pin 30
相关PDF资料 |
PDF描述 |
|---|---|
| TDA4854NB | HORIZ/VERT DEFLECTION IC, PDIP32 |
| TDA7052A/N2 | 1 CHANNEL(S), VOLUME CONTROL CIRCUIT, PDIP8 |
| TDA7052AT/N2 | 1 CHANNEL(S), VOLUME CONTROL CIRCUIT, PDSO8 |
| TDA9178/N1 | SPECIALTY CONSUMER CIRCUIT, PDIP24 |
| TDA9178N | SPECIALTY CONSUMER CIRCUIT, PDIP24 |
相关代理商/技术参数 |
参数描述 |
|---|---|
| TDA4855 | 制造商:PHILIPS 制造商全称:NXP Semiconductors 功能描述:Autosync Deflection Controller ASDC |
| TDA4856 | 制造商:Phil 功能描述:Semiconductor |
| TDA4857 | 制造商:PHILIPS 制造商全称:NXP Semiconductors 功能描述:I2C-bus autosync deflection controller for PC monitors |
| TDA4857PS | 制造商:NXP Semiconductors 功能描述:HORIZ/VERT DEFLECTION IC, PDIP32 |
| TDA4858 | 制造商:NXP Semiconductors 功能描述:Video/TV Circuit, Video DEFLECTION Circuit, 32 Pin, Plastic, SDIP |
发布紧急采购，3分钟左右您将得到回复。