参数资料
型号: THS7001CPWPR
厂商: TEXAS INSTRUMENTS INC
元件分类: 模拟信号调理
英文描述: SPECIALTY ANALOG CIRCUIT, PDSO20
封装: GREEN, PLASTIC, HTSSOP-20
文件页数: 16/41页
文件大小: 1203K
代理商: THS7001CPWPR
THS7001, THS7002
70MHz PROGRAMMABLEGAIN AMPLIFIERS
SLOS214C OCTOBER 1998 REVISED MARCH 2007
23
POST OFFICE BOX 655303
DALLAS, TEXAS 75265
APPLICATION INFORMATION
shutdown control
There are two shutdown pins which control the shutdown for each half of the THS7002 and one shutdown pin
for the THS7001. When the shutdown pins signals are low, the THS7001 and THS7002 is active. But, when a
shutdown pin is high (+5 V), a preamplifier and the respective PGA section is turned off. Just like the Gain
controls, the shutdown logic is not latched and should always have a signal applied to them. A 3.3-k
resistor
to ground is usually applied to ensure a fixed logic state. A simplified circuit can be seen in Figure 60.
+VCC
To Internal
Bias Circuitry
Control
VCC
DGND
53 k
Gain
Figure 60. Simplified THS7001 and THS7002 Shutdown Circuit
One aspect of the shutdown feature, which is often over-looked, is that the PGA section will still have an output
while in shutdown mode. This is due to the internally fixed RF and RG resistors. This effect is true for any amplifier
connected as an inverter. The internal circuitry may be powered down and in a high-impedance state, but the
resistors are always there. This will then allow the input signal current to flow through these resistors and into
the output. The equivalent resistance of RF and RG is approximately 3 k. To minimize this effect, a shunt
resistor to ground may be utilized, This will act as a classic voltage divider and will reduce the feed-through
voltage seen at the PGA output. The drawback to this is the increased load on the PGA while in the active state.
driving a capacitive load
Driving capacitive loads with high-performance amplifiers is not a problem as long as certain precautions are
taken. The first is to realize that the THS7001 and THS7002 has been internally compensated to maximize its
bandwidth and slew rate performance. When an amplifier is compensated in this manner, capacitive loading
directly on the output will decrease the device’s phase margin leading to high frequency ringing or oscillations.
Therefore, for capacitive loads of greater than 10 pF, it is recommended that a resistor be placed in series with
the output of the amplifier, as shown in Figure 61. A minimum value of 20
should work well for most
applications. For example, in 75-
transmission systems, setting the series resistor value to 75 both isolates
any capacitance loading and provides the proper line impedance matching at the source end.
相关PDF资料
PDF描述
TL4050B41QDBZRQ1 2-OUTPUT TWO TERM VOLTAGE REFERENCE, 4.096 V, PDSO3
TLV2772QPWG4 DUAL OP-AMP, 2700 uV OFFSET-MAX, 4.8 MHz BAND WIDTH, PDSO8
TLV2772QPWRG4 DUAL OP-AMP, 2700 uV OFFSET-MAX, 4.8 MHz BAND WIDTH, PDSO8
TL032CPSRG4 DUAL OP-AMP, 4500 uV OFFSET-MAX, 1 MHz BAND WIDTH, PDSO8
TLV2264AQDG4 QUAD OP-AMP, 1500 uV OFFSET-MAX, 0.67 MHz BAND WIDTH, PDSO14
相关代理商/技术参数
参数描述
THS7001CPWPRG4 功能描述:特殊用途放大器 70-MHz Hi-Spd Prog Gain Amplifier RoHS:否 制造商:Texas Instruments 通道数量:Single 共模抑制比(最小值): 输入补偿电压: 工作电源电压:3 V to 5.5 V 电源电流:5 mA 最大功率耗散: 最大工作温度:+ 70 C 最小工作温度:- 40 C 安装风格:SMD/SMT 封装 / 箱体:QFN-20 封装:Reel
THS7001EVM 功能描述:放大器 IC 开发工具 THS7001 Hi-Spd Amp Eval Mod RoHS:否 制造商:International Rectifier 产品:Demonstration Boards 类型:Power Amplifiers 工具用于评估:IR4302 工作电源电压:13 V to 23 V
THS7001IPWP 功能描述:特殊用途放大器 70-MHz Hi-Spd Prog Gain Amplifier RoHS:否 制造商:Texas Instruments 通道数量:Single 共模抑制比(最小值): 输入补偿电压: 工作电源电压:3 V to 5.5 V 电源电流:5 mA 最大功率耗散: 最大工作温度:+ 70 C 最小工作温度:- 40 C 安装风格:SMD/SMT 封装 / 箱体:QFN-20 封装:Reel
THS7001IPWPG4 功能描述:特殊用途放大器 70-MHz Hi-Spd Prog Gain Amplifier RoHS:否 制造商:Texas Instruments 通道数量:Single 共模抑制比(最小值): 输入补偿电压: 工作电源电压:3 V to 5.5 V 电源电流:5 mA 最大功率耗散: 最大工作温度:+ 70 C 最小工作温度:- 40 C 安装风格:SMD/SMT 封装 / 箱体:QFN-20 封装:Reel
THS7001IPWPR 功能描述:运算放大器 - 运放 70 MHz Hi Spd Prog Gain Amplifier RoHS:否 制造商:STMicroelectronics 通道数量:4 共模抑制比(最小值):63 dB 输入补偿电压:1 mV 输入偏流(最大值):10 pA 工作电源电压:2.7 V to 5.5 V 安装风格:SMD/SMT 封装 / 箱体:QFN-16 转换速度:0.89 V/us 关闭:No 输出电流:55 mA 最大工作温度:+ 125 C 封装:Reel