- 您现在的位置：买卖IC网 > PDF目录98230 > TK83361MTL (ASAHI KASEI POWER DEVICES CORP) AUDIO SINGLE CHIP RECEIVER, PDSO16 PDF资料下载
参数资料
| 型号： | TK83361MTL |
| 厂商： | ASAHI KASEI POWER DEVICES CORP |
| 元件分类： | 接收器 |
| 英文描述： | AUDIO SINGLE CHIP RECEIVER, PDSO16 |
| 封装： | SOP-16 |
| 文件页数： | 3/15页 |
| 文件大小： | 155K |
| 代理商： | TK83361MTL |
December 2000 TOKO, Inc.
Page 11
TK83361M
APPLICATIONS INFORMATION (CONT.)
(1) Using an External Oscillator Source
The circuit composition using an external OSC source is
shown in Fig. 4. When using an external OSC source
instead of the internal OSC, the local level must be injected
into Pin 1 by capacitor coupling.
In this case, Pin 2 must be open.
The local OSC operates as an emitter follower for a multi-
plier by opening Pin 2 and injecting into Pin 1.
Figure 4: External Injection
(2) For 3rd Overtone mode
In general, a crystal oscillator can oscillate in the fundamen-
tal mode and overtone mode. For example, it is easy for a
30MHz-overtone crystal to oscillate at 10MHz, fundamental
mode. The reason is because the impedance of the funda-
mental mode is the same as the impedance of the overtone.
Therefore, it is necessary for the circuit to select the
overtone frequency by using a tuning coil.
How to oscillate a general 3rd overtone oscillator is ex-
plained. In the case of an overtone mode of 30MHz and
higher, using a crystal oscillator, we recommend the circuit
in Fig. 5 to suppress the fundamental mode oscillation.
tor. It is easy to increase the drive current by connecting
resistor R
e between Pin 2 and GND. Being short of drive
current, it makes g
m increase to increase the drive current
by connecting external resistor R
e. In that case, the amount
of drive current increase, Ie, is shown in Eq.(1).
Figure 5: Overtone Mode Circuit
In order to oscillate at the 3rd overtone frequency, the values
of C
2, C3 and L (Fig.5) are selected. Fig.6 shows a 2-port
impedance response of the C
2~C3~L loop network.
Regarding the condition of oscillation, the impedance char-
acteristic is capacitive at the vacinity of the overtone fre-
quency. It is reactive at the vicinity of the fundamental
frequency.
The condition of oscillation is as follows:
f
OSC is between fa and fb,
3 x f
OSC is fb and higher. Please see Fig.6
Figure 6: 2-port
Impedance Response of Resonance Network
Where:
f
a: series resonant freq.
f
b: parallel resonant freq.
f
OSC: fundamental mode freq.
3 x f
OSC:
3rd order overtone freq.
The following explains how to decide the circuit constants of
the overtone-crystal-oscillation fundamental circuit.
As the operating frequency increases the oscillation ampli-
tude decreases because of a shortage of g
m of the oscilla-
fOSC
3 X fOSC
fa
fb
-j
+j
Reac
ta
n
c
e
Equations of 3rd order overtone oscillation are shown below.
The series value of the equivalent capacitance at the 3rd
order overtone freq. of this network, which is decided in the
above -mentioned, and the capacitance of C
1 must be equal
to load capacitance C
L.
Being short of negative resistance of the circuit, increase
the transistor’s bias current by decreasing R
e. It is able to
decide the OSC level for minute adjusting R
e. Please refer
the most suitable OSC level range to 12dB SINAD sensitiv-
ity versus local OSC input signal level in TYPICAL PER-
FORMANCE CHARACTERISTICS. The saturating range
is the most suitable OSC level range. It is comparatively
easy to decide the circuit constant by examining it with a
network analyzer.
~
1
2
open
50
0.01
RF
IF
50
VCC
1
2
X’tal
C2
C3
Re
L
C1
Ie =
VCC VBE
=
Re
VCC 0.7
(1)
Re
fb =fa 1+
C2
C3
2
π LxC2
1
fa =
(2)
,
相关PDF资料 |
PDF描述 |
|---|---|
| TK83854DTL | 1.5 A POWER FACTOR CONTROLLER, 118 kHz SWITCHING FREQ-MAX, PDIP16 |
| TK83854DMG | 1.5 A POWER FACTOR CONTROLLER, 118 kHz SWITCHING FREQ-MAX, PDIP16 |
| TK83854MTL | 1.5 A POWER FACTOR CONTROLLER, 118 kHz SWITCHING FREQ-MAX, PDSO16 |
| TK84819JIMG | 1 A POWER FACTOR CONTROLLER WITH POST REGULATOR, CDIP20 |
| TK84819DIMG | 1 A POWER FACTOR CONTROLLER WITH POST REGULATOR, PDIP20 |
相关代理商/技术参数 |
参数描述 |
|---|---|
| TK83361MTL/83361 | 制造商:TOKO 制造商全称:TOKO, Inc 功能描述:NARROW BAND FM IF IC |
| TK83361MTL-G | 制造商:TOKO Inc 功能描述: |
| TK83854 | 制造商:TOKO 制造商全称:TOKO, Inc 功能描述:HIGH POWER FACTOR PREREGULATOR |
| TK83854DIMG | 制造商:TOKO 制造商全称:TOKO, Inc 功能描述:HIGH POWER FACTOR PREREGULATOR |
| TK83854DIMG/83854 | 制造商:TOKO 制造商全称:TOKO, Inc 功能描述:HIGH POWER FACTOR PREREGULATOR |
发布紧急采购，3分钟左右您将得到回复。