- 您现在的位置：买卖IC网 > PDF目录98230 > TK83854DMG (TOKO INC) 1.5 A POWER FACTOR CONTROLLER, 118 kHz SWITCHING FREQ-MAX, PDIP16 PDF资料下载
参数资料
| 型号： | TK83854DMG |
| 厂商： | TOKO INC |
| 元件分类： | 稳压器 |
| 英文描述： | 1.5 A POWER FACTOR CONTROLLER, 118 kHz SWITCHING FREQ-MAX, PDIP16 |
| 封装： | PLASTIC, DIP-16 |
| 文件页数： | 2/12页 |
| 文件大小： | 105K |
| 代理商： | TK83854DMG |
Page 10
April 2001 TOKO, Inc.
TK83854D
used to calculate these resistors:
R
IAC = VPK(MAX) / 400 E - 6
= (260 VAC x 2 ) / 400 A
= 910 k
R
REF = RIAC / 4 = 220 k
where V
PK is the peak line voltage.
Line Current (I
SENSE/MULTOUT )
The voltage drop across the 0.25 W current-sense resistor
is applied to Pins 4 and 5 as shown. The current-sense
amplifier also operates with high low-frequency gain, but
unlike the voltage amplifier, it is set up to give the current-
control loop a very wide bandwidth. This enables the line
current to follow the line voltage as closely as possible. In
the present example, this amplifier has a zero at about 500
Hz, and a gain of about 18 dB thereafter.
RMS Line Voltage (V
RMS)
An important feature of the TK83854 preregulator is that it
can operate with a three-to-one range of input line voltages,
covering everything from low line in Japan (85 VAC) to
high line in Europe (255 VAC). This is done using line feed-
forward, which keeps the input power constant with varying
input voltage (assuming constant load power). To do this,
the multiplier divides the line current by the square of the
rms value of the line voltage. The voltage applied to Pin 8,
proportional to the average of the rectified line voltage (and
proportional to the RMS value), is squared in the TK83854,
and then used as a divisor by the multiplier block. The
multiplier output, at Pin 5, is a current that increases with
the current at Pin 6 and the voltage at Pin 7, and decreases
with the square of the voltage at pin 8.
PWM Frequency
The PWM oscillator frequency in Figure 1 is 100 kHz. This
value is determined by C
T at Pin 14 and RSET at Pin 12.
R
SET should be chosen first because it affects the maximum
value of I
OM according to the equation:
I
OM(MAX) = -3.75 V / RSET
This effectively sets a maximum PWM-controlled current.
APPLICATION INFORMATION (CONT.)
With R
SET = 15 k:
I
OM(MAX) = -3.75 V / 15 k = -250 A
It is also important to note that the multiplier output current
will never exceed twice IAC.
With the 3.9 k resistor from MULT
OUT to the 0.25 9 current
sense resistor, the maximum current in the current sense
resistor will be:
I
RCS(MAX) = (-IOM(MAX) x 3.9 k) / 0.25 = -3.9 A
Having selected R
SET, the current sense resistor, and the
resistor from MULT
OUT to the current sense resistor,
calculate C
T for the desired PWM oscillator frequency from
the equation:
C
T = 1.25 / (f OSC x RSET)
相关PDF资料 |
PDF描述 |
|---|---|
| TK83854MTL | 1.5 A POWER FACTOR CONTROLLER, 118 kHz SWITCHING FREQ-MAX, PDSO16 |
| TK84819JIMG | 1 A POWER FACTOR CONTROLLER WITH POST REGULATOR, CDIP20 |
| TK84819DIMG | 1 A POWER FACTOR CONTROLLER WITH POST REGULATOR, PDIP20 |
| TL1051FR-X | SPECIALTY CONSUMER CIRCUIT, PQFP44 |
| TL1051FR | SPECIALTY CONSUMER CIRCUIT, PQFP44 |
相关代理商/技术参数 |
参数描述 |
|---|---|
| TK83854MIMG | 制造商:TOKO 制造商全称:TOKO, Inc 功能描述:HIGH POWER FACTOR PREREGULATOR |
| TK83854MIMG/83854 | 制造商:TOKO 制造商全称:TOKO, Inc 功能描述:HIGH POWER FACTOR PREREGULATOR |
| TK83854MITL | 制造商:TOKO 制造商全称:TOKO, Inc 功能描述:HIGH POWER FACTOR PREREGULATOR |
| TK83854MITL/83854 | 制造商:TOKO 制造商全称:TOKO, Inc 功能描述:HIGH POWER FACTOR PREREGULATOR |
| TK-850/HG2 | 制造商:TESSERA TECHNOLOGY 功能描述: |
发布紧急采购，3分钟左右您将得到回复。