- 您现在的位置：买卖IC网 > PDF目录98246 > TLE6208-6G (INFINEON TECHNOLOGIES AG) BRUSH DC MOTOR CONTROLLER, 2 A, PDSO28 PDF资料下载
参数资料
| 型号： | TLE6208-6G |
| 厂商： | INFINEON TECHNOLOGIES AG |
| 元件分类： | 运动控制电子 |
| 英文描述： | BRUSH DC MOTOR CONTROLLER, 2 A, PDSO28 |
| 封装： | POWER, PLASTIC, DSO-28 |
| 文件页数： | 22/25页 |
| 文件大小： | 704K |
| 代理商： | TLE6208-6G |
TLE 6208-6 G
Data Sheet
6
2007-09-12
1.5
Circuit Description
Figure 2 shows a block schematic diagram of the module.
There are 6 halfbridge drivers on the right-hand side. An HS driver and an LS driver are
combined to form a halfbridge driver in each case.
The drivers communicate via the internal data bus with the logic and the other control
and monitoring functions: undervoltage (UV), overvoltage (OV), overtemperature (TSD),
charge pump and fault detect.
Two connection interfaces are provided for supply to the module: All power drivers are
connected to the supply voltage
V
S.
These are monitored by overvoltage and
undervoltage comparators with hysteresis, so that the correct function can be checked
in the application at any time.
The logic is supplied by the
V
CC voltage, typ. with 5 V. The VCC voltage uses an internally
generated Power-On Reset (POR) to initialize the module at power-on. The advantage
of this system is that information stored in the logic remains intact in the event of short-
term failures in the supply voltage
V
S. The system can therefore continue to operate
following
V
S undervoltage, without having to be reprogrammed. The “undervoltage”
information is stored, and can be read out via the interface. The same logically applies
for overvoltage. “Interference spikes” on
V
S are therefore effectively suppressed.
The situation is different in the case of undervoltage on the
V
CC connection pin. If this
occurs, then the internally stored data is deleted, and the output levels are switched to
high-impedance status (tristate). The module is initialized by
V
CC following restart
(Power-On Reset = POR).
The 16-bit wide programming word or control word (see Table 1) is read in via the DI
data input, and this is synchronized with the clock input CLK. The status word appears
synchronously at the DO data output (see Table 2).
The transmission cycle begins when the chip is selected with the CSN input (H to L). If
the CSN input changes from L to H then the word which has been read in becomes the
control word. The DO output switches to tristate status at this point, thereby releasing the
DO bus circuit for other uses.
The INH inhibit input can be used to cut off the complete module. This reduces the
current consumption to just a few
A, and results in the loss of any data stored. The
output levels are switched to tristate status. The module is reinitialized with the internally
generated POR (Power-On Reset) at restart.
This feature allows the use of this module in battery-operated applications (vehicle body
control applications).
Every driver block from DRV 1 to 6 contains a low-side driver and a high-side driver. The
output connections have been selected so that each HS driver and LS driver pair can be
combined to form a halfbridge by short-circuiting adjacent connections. The full flexibility
of the configuration can be achieved by dissecting the halfbridges into “quarter-bridges”.
Table 3 shows examples of possible applications.
相关PDF资料 |
PDF描述 |
|---|---|
| TLE6210G | 1-CHANNEL POWER SUPPLY MANAGEMENT CKT, PDSO20 |
| TLE6266G | SPECIALTY ANALOG CIRCUIT, PDSO28 |
| TLE6280GP | BRUSHLESS DC MOTOR CONTROLLER, PDSO36 |
| TLE6361G | SWITCHING REGULATOR, 425 kHz SWITCHING FREQ-MAX, PDSO36 |
| TLE6363G | DUAL SWITCHING CONTROLLER, 115 kHz SWITCHING FREQ-MAX, PDSO14 |
相关代理商/技术参数 |
参数描述 |
|---|---|
| TLE6208-6G_07 | 制造商:INFINEON 制造商全称:Infineon Technologies AG 功能描述:Hex-Half-Bridge / Double Six-Driver |
| TLE62086GNUMA1 | 制造商:Infineon Technologies AG 功能描述:IC MOTOR DRIVER SPI 28DSO |
| TLE62086GXUMA1 | 制造商:Infineon Technologies AG 功能描述:DC Motor Driver 28-Pin DSO 制造商:Infineon Technologies AG 功能描述:BODY BRIDGES - Tape and Reel |
| TLE6209R | 功能描述:IC H-BRIDGE 7A DC MOTOR PDSO-20 RoHS:是 类别:集成电路 (IC) >> PMIC - 电机和风扇控制器，驱动器 系列:- 标准包装:1 系列:- 应用:步进电机驱动器，1-2 相，2 相 评估套件:- 输出数:1 电流 - 输出:800mA 电压 - 负载:10 V ~ 28 V 电源电压:4.75 V ~ 5.25 V 工作温度:-20°C ~ 90°C 安装类型:表面贴装 封装/外壳:28-SOP + 2 翼片裸露焊盘 供应商设备封装:28-HSOPHC（15.2x7.9） 包装:剪切带 (CT) 其它名称:869-1268-1 |
| TLE6209R_07 | 制造商:INFINEON 制造商全称:Infineon Technologies AG 功能描述:7 A H-Bridge for DC-Motor Applications |
发布紧急采购，3分钟左右您将得到回复。