参数资料
型号: TLE7368-2E
厂商: Infineon Technologies
文件页数: 36/41页
文件大小: 0K
描述: IC PS SYSTEM MULTI VOLT PGDSO-36
标准包装: 1,000
应用: 电源,汽车应用
输入电压: 4.5 V ~ 45 V
输出数: 3
输出电压: 5V,3.3V,1.2V
工作温度: -40°C ~ 150°C
安装类型: 表面贴装
封装/外壳: 36-BSSOP(0.433",11.00mm 宽)裸露焊盘
供应商设备封装: PG-DSO-36
包装: 带卷 (TR)
其它名称: SP000768086
TLE73682EXUMA1
TLE7368
Application Information
This section intends to give hints for correct set up of the IC, i.e. to avoid misbehavior caused by the influence of
other PCB board circuits and shows also how to calculate external components, power loss, etc.
6.1
Choosing Components for the Buck Regulator
Stable operation of the Buck converter is ensured when choosing the external passive components according to
the characteristics given below:
?
?
?
Buck inductance: 18 μ H < L Buck < 220 μ H
Buck output capacitor: C Buck > 20 μ F
ESR of Buck output capacitor: ESR_ C Buck < 150 m ?
6.2
Setting up LDO1, LDO2
The linear regulators LDO1 and LDO2 need to be connected to appropriate output capacitors in order to keep the
regulation loop stable and avoid oscillations. The essential parameters of the output capacitor are the minimum
capacitance and the equivalent series resistance (ESR). The required ranges for each output are specified in
Chapter 4.4 ( Electrical Characteristics ). Tantalum capacitors as well as multi layer ceramic capacitors are
suitable for LDO1 and LDO2.
Table 1
LDO2 Output Voltage Configuration
No.
1
2
6.3
SEL_LDO2
GND
Q_LDO2
Setting up of LDO3
Q_LDO2
2.6 V
3.3 V
LDO3 consists of an integrated regulator which needs to be equipped with an external power transistor (NPN-
Type). Suitable NPN power transistors types are e.g. KSH 200 from Fairchild semiconductor or NJD 2873T4 from
ON semiconductor. The most important parameters to be checked when choosing the external transistor are the
‘current gain bandwidth product’ ( f T ), the ‘DC current gain’ (h FE ) and the thermal resistance of the package.
Darlington type transistors should not be used. For stability of the regulation loop a multi layer ceramic capacitor
of min. 4.7 μ F must be connected to the LDO3 output voltage (Emitter of the external power transistor). In order
to improve suppression load current steps an additional capacitor of tantalum type can be connected in parallel.
In case LDO3 voltage is not needed the external NPN transistor can be spared. For this configuration the pins
‘DRV_EXT’ and ‘FB_EXT’ should be directly connected to each other in order to ensure correct operation of
Reset 2. Also in this case a small ceramic capacitor of 220 nF connected from pin ‘FB_EXT’ to GND is
recommended in order to avoid oscillations of the regulation loop LDO3.
Data Sheet
36
Rev. 2.1, 2010-11-22
相关PDF资料
PDF描述
MAX5005ACUB+ IC REG USB LDO 150MA 10-UMAX
HSC15DREN CONN EDGECARD 30POS .100 EYELET
HSC15DREH CONN EDGECARD 30POS .100 EYELET
GCC31DRES CONN EDGECARD 62POS .100 EYELET
450USC560MEFCSN35X50 CAP ALUM 560UF 450V 20% SNAP-IN
相关代理商/技术参数
参数描述
TLE73682EXT 功能描述:直流/直流开关转换器 DC/DC RoHS:否 制造商:STMicroelectronics 最大输入电压:4.5 V 开关频率:1.5 MHz 输出电压:4.6 V 输出电流:250 mA 输出端数量:2 最大工作温度:+ 85 C 安装风格:SMD/SMT
TLE73682EXUMA1 制造商:Infineon Technologies AG 功能描述:Micro Controller Supply 36-Pin DSO 制造商:Infineon Technologies AG 功能描述:DC/DC CONVERTER - Tape and Reel 制造商:Infineon Technologies AG 功能描述:IC PS SYSTEM MULTI VOLT PGDSO-36
TLE7368-3E 功能描述:直流/直流开关转换器 DC/DC RoHS:否 制造商:STMicroelectronics 最大输入电压:4.5 V 开关频率:1.5 MHz 输出电压:4.6 V 输出电流:250 mA 输出端数量:2 最大工作温度:+ 85 C 安装风格:SMD/SMT
TLE73683EXT 功能描述:直流/直流开关转换器 DC/DC RoHS:否 制造商:STMicroelectronics 最大输入电压:4.5 V 开关频率:1.5 MHz 输出电压:4.6 V 输出电流:250 mA 输出端数量:2 最大工作温度:+ 85 C 安装风格:SMD/SMT
TLE73683EXUMA1 制造商:Infineon Technologies AG 功能描述:Micro Controller Supply 制造商:Infineon Technologies AG 功能描述:DC/DC CONVERTER - Tape and Reel 制造商:Infineon Technologies AG 功能描述:IC PS SYSTEM MULTI VOLT PGDSO-36