参数资料
型号: TLE7368-3E
厂商: Infineon Technologies
文件页数: 34/41页
文件大小: 0K
描述: IC PS SYSTEM MULTI VOLT PGDSO-36
标准包装: 1,000
应用: 电源,汽车应用
输入电压: 4.5 V ~ 45 V
输出数: 3
输出电压: 5V,3.3V,1.3V
工作温度: -40°C ~ 150°C
安装类型: 表面贴装
封装/外壳: 36-BSSOP(0.433",11.00mm 宽)裸露焊盘
供应商设备封装: PG-DSO-36
包装: 带卷 (TR)
其它名称: SP000794336
TLE73683EFUMA1
TLE73683EXUMA1
TLE7368
Detailed Internal Circuits Description
input WDI. A valid trigger signal is a falling edge from V WDI,high to V WDI,low . After receiving a valid trigger signal within
the "Open Window" the watchdog immediately terminates the "Open Window" and enters the "Closed Window"
state. The "Closed Window" has a fixed duration t WD,W . During normal operation a trigger signal should not be
applied during the "Closed Window. After the "Closed Window" time t WD,W an the watchdog returns back to the
"Open Window" state. Within the "Open Window", a valid trigger signal must be applied to the watchdog input WDI.
In normal operation, the watchdog continues to cycle between the "Open Window" and "Closed Window" state. If
reset signal RO_2 is asserted and transitions to a low state, then the watchdog needs to be reinitialized as
described in the Initialization section. The watchdog output WDO stays high as long as the watchdog input WDI
is triggered correctly.
Valid Trigger Signal:
Please refer to Figure 9 .
Watchdog input WDI is periodically sampled with a period of T WD . A valid trigger signal is a falling edge from
V WDI,high to V WDI,low . To improve immunity against noise or glitches on the WDI input, at least two high samples
followed two low samples are required for a valid trigger signal. For example, if the first three samples (two HGH
one LOW) of the trigger pulse at pin WDI are inside the closed window and only the fourth sample (the second
LOW sample) is taken in the open window then the watchdog output WDO will remain High.
Invalid Triggering:
Please refer to Figure 8 and Figure 9 .
No trigger signal detected during the "Open Window" or a trigger signal detected during the "Closed Window", is
considered invalid triggering. Watchdog output WDO switches to low for a duration of t WD,W immediately after no
valid trigger during the "Open Window" or immediately if a trigger signal is detected during the "Closed Window".
Fault Operation:
If a capacitor failure on the watchdog timing pin RT causes a short circuit to GND, then the internal oscillator stops
operating. Without oscillator operation there is no time reference for the watchdog so it does not know when the
"Closed Window" period has ended. Thus, every second trigger signal on watchdog input WDI generates a
watchdog failure causing WDO to switch from high to low. An open circuit at pin RT also causes WDO to switch
from high to low.
Figure 9
Window Watchdog Input Signal Validation
Data Sheet
34
Rev. 2.1, 2010-11-22
相关PDF资料
PDF描述
TLV1117LV25DCYT IC REG LDO 2.5V 1A SOT223-4
TLV431BH6TA IC VREF SHUNT ADJ SC-70-6
TLV70018QDDCRQ1 IC REG LDO 1.8V .2A SOT23-5
TLV70430DBVT IC REG LDO 3V .15A SOT23-5
TLV803ZDBZT IC VOLT SUPERVISR 2.25V SOT23-3
相关代理商/技术参数
参数描述
TLE73683EXT 功能描述:直流/直流开关转换器 DC/DC RoHS:否 制造商:STMicroelectronics 最大输入电压:4.5 V 开关频率:1.5 MHz 输出电压:4.6 V 输出电流:250 mA 输出端数量:2 最大工作温度:+ 85 C 安装风格:SMD/SMT
TLE73683EXUMA1 制造商:Infineon Technologies AG 功能描述:Micro Controller Supply 制造商:Infineon Technologies AG 功能描述:DC/DC CONVERTER - Tape and Reel 制造商:Infineon Technologies AG 功能描述:IC PS SYSTEM MULTI VOLT PGDSO-36
TLE7368E 功能描述:直流/直流开关转换器 DC/DC CONVERTER RoHS:否 制造商:STMicroelectronics 最大输入电压:4.5 V 开关频率:1.5 MHz 输出电压:4.6 V 输出电流:250 mA 输出端数量:2 最大工作温度:+ 85 C 安装风格:SMD/SMT
TLE7368EXUMA1 制造商:Infineon Technologies AG 功能描述:Micro Controller Supply 36-Pin DSO 制造商:Infineon Technologies AG 功能描述:DC/DC CONVERTER - Tape and Reel 制造商:Infineon Technologies AG 功能描述:IC PS SYSTEM MULTI VOLT PGDSO-36
TLE7368G 功能描述:直流/直流开关转换器 Next Gen Micro Controller Supply RoHS:否 制造商:STMicroelectronics 最大输入电压:4.5 V 开关频率:1.5 MHz 输出电压:4.6 V 输出电流:250 mA 输出端数量:2 最大工作温度:+ 85 C 安装风格:SMD/SMT