
C8051F310/1/2/3/4/5/6/7
36
Rev. 1.7
3.
Global DC Electrical Characteristics
Table 3.1. Global DC Electrical Characteristics
–40°C to +85°C, 25 MHz System Clock unless otherwise specified.
Parameter
Conditions
Min
Typ
Max
Units
Digital Supply Voltage
VRST
1
3.0
3.6
V
Digital Supply RAM Data Retention
Voltage
—1.5
—
V
Specified Operating Temperature
Range
–40
—
+85
°C
SYSCLK (system clock frequency)
02
—25
MHz
Tsysl (SYSCLK low time)
18
—
ns
Tsysh (SYSCLK high time)
18
—
ns
Digital Supply Current—CPU Active (Normal Mode, fetching instructions from Flash)
VDD = 3.0 V, F = 25 MHz
—
7.8
8.6
mA
VDD = 3.0 V, F = 1 MHz
—
0.38
—
mA
VDD = 3.0 V, F = 80 kHz
—
31
—
A
VDD = 3.6 V, F = 25 MHz
—
10.7
12.1
mA
F = 25 MHz
—
67
—
%/V
F = 1 MHz
—
62
—
%/V
VDD = 3.0 V, F < 15 MHz, T = 25 C
—
0.39
—
mA/MHz
VDD = 3.0 V, F > 15 MHz, T = 25 C
—
0.21
—
mA/MHz
VDD = 3.6 V, F < 15 MHz, T = 25 C
—
0.55
—
mA/MHz
VDD = 3.6 V, F > 15 MHz, T = 25 C
—
0.27
—
mA/MHz
Notes:
1.
2.
SYSCLK must be at least 32 kHz to enable debugging.
3.
Based on device characterization data, not production tested.
4.
Active and Inactive IDD at voltages and frequencies other than those specified can be calculated
using the IDD Supply Sensitivity. For example, if the VDD is 3.3 V instead of 3.0 V at 25 MHz: IDD =
7.8 mA typical at 3.0 V and f = 25 MHz. From this, IDD = 7.8 mA + 0.67 x (3.3 V – 3.0 V) = 8 mA at
3.3 V and f = 25 MHz.
5.
IDD can be estimated for frequencies < 15 MHz by multiplying the frequency of interest by the fre-
quency sensitivity number for that range. When using these numbers to estimate IDD for > 15 MHz,
the estimate should be the current at 25 MHz minus the difference in current indicated by the fre-
quency sensitivity number. For example:
VDD = 3.0 V; F = 20 MHz, IDD = 7.8 mA – (25 MHz – 20 MHz) x 0.21 mA/MHz = 6.75 mA.
6.
Idle IDD can be estimated for frequencies < 1 MHz by multiplying the frequency of interest by the
frequency sensitivity number for that range. When using these numbers to estimate Idle IDD for > 1
MHz, the estimate should be the current at 25 MHz minus the difference in current indicated by the
frequency sensitivity number. For example:
VDD = 3.0 V; F = 5 MHz, Idle IDD = 4.8 mA – (25 MHz – 5 MHz) x 0.15 mA/MHz = 1.8 mA.