- 您现在的位置：买卖IC网 > PDF目录98273 > TPA321DR (TEXAS INSTRUMENTS INC) 0.7 W, 1 CHANNEL, AUDIO AMPLIFIER, PDSO8 PDF资料下载
参数资料
| 型号： | TPA321DR |
| 厂商： | TEXAS INSTRUMENTS INC |
| 元件分类： | 音频／视频放大 |
| 英文描述： | 0.7 W, 1 CHANNEL, AUDIO AMPLIFIER, PDSO8 |
| 封装： | GREEN, PLASTIC, MS-012AA, SOIC-8 |
| 文件页数： | 10/29页 |
| 文件大小： | 773K |
| 代理商： | TPA321DR |
第1页第2页第3页第4页第5页第6页第7页第8页第9页当前第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页
www.ti.com
3 dB
fc
fc +
1
2p R
I
C
I
(8)
C
I +
1
2p R
I
fc
(9)
Power Supply Decoupling, CS
Midrail Bypass Capacitor, CB
10
C
B
250 k
v
1
R
F )
R
I
C
I
(10)
TPA321
SLOS312C – JUNE 2000 – REVISED JUNE 2004
The value of CI is important to consider as it directly affects the bass (low-frequency) performance of the circuit.
Consider the example where RI is 10 k and the specification calls for a flat bass response down to 40 Hz.
Equation 8 is reconfigured as Equation 9.
In this example, CI is 0.40 F, so one would likely choose a value in the range of 0.47 F to 1 F. A further
consideration for this capacitor is the leakage path from the input source through the input network (RI, CI) and
the feedback resistor (RF) to the load. This leakage current creates a dc offset voltage at the input to the amplifier
that reduces useful headroom, especially in high gain applications. For this reason a low-leakage tantalum or
ceramic capacitor is the best choice. When polarized capacitors are used, the positive side of the capacitor
should face the amplifier input in most applications, as the dc level there is held at VDD/2, which is likely higher
than the source dc level. It is important to confirm the capacitor polarity in the application.
The TPA321 is a high-performance CMOS audio amplifier that requires adequate power supply decoupling to
ensure the output total harmonic distortion (THD) is as low as possible. Power supply decoupling also prevents
oscillations for long lead lengths between the amplifier and the speaker. The optimum decoupling is achieved by
using two capacitors of different types that target different types of noise on the power supply leads. For higher
frequency transients, spikes, or digital hash on the line, a good low equivalent-series-resistance (ESR) ceramic
capacitor, typically 0.1 F, placed as close as possible to the device VDD lead, works best. For filtering
lower-frequency noise signals, a larger aluminum electrolytic capacitor of 10 F or greater placed near the audio
power amplifier is recommended.
The midrail bypass capacitor, CB, is the most critical capacitor and serves several important functions. During
start-up or recovery from shutdown mode, CB determines the rate at which the amplifier starts up. The second
function is to reduce noise produced by the power supply caused by coupling into the output drive signal. This
noise is from the midrail generation circuit internal to the amplifier, which appears as degraded PSRR and THD +
N. The capacitor is fed from a 250-k
source inside the amplifier. To keep the start-up pop as low as possible,
the relationship shown in Equation 10 should be maintained, which insures the input capacitor is fully charged
before the bypass capacitor is fully charged and the amplifier starts up.
As an example, consider a circuit where CB is 2.2 F, CI is 0.47 F, RF is 50 k, and RI is 10 k. Inserting these
values into the Equation 10 we get:
18.2
≤ 35.5
which satisfies the rule. Bypass capacitor, CB, values of 2.2-F to 1-F ceramic or tantalum low-ESR capacitors
are recommended for the best THD and noise performance.
18
相关PDF资料 |
PDF描述 |
|---|---|
| TPA321D | 0.7 W, 1 CHANNEL, AUDIO AMPLIFIER, PDSO8 |
| TPA321DRG4 | 0.7 W, 1 CHANNEL, AUDIO AMPLIFIER, PDSO8 |
| TPA321DG4 | 0.7 W, 1 CHANNEL, AUDIO AMPLIFIER, PDSO8 |
| TPA321DGNRG4 | 0.7 W, 1 CHANNEL, AUDIO AMPLIFIER, PDSO8 |
| TPA321DGNG4 | 0.7 W, 1 CHANNEL, AUDIO AMPLIFIER, PDSO8 |
相关代理商/技术参数 |
参数描述 |
|---|---|
| TPA321DRG4 | 功能描述:音频放大器 350-mW Low-Voltage w/diff inputs RoHS:否 制造商:STMicroelectronics 产品:General Purpose Audio Amplifiers 输出类型:Digital 输出功率: THD + 噪声: 工作电源电压:3.3 V 电源电流: 最大功率耗散: 最大工作温度: 安装风格:SMD/SMT 封装 / 箱体:TQFP-64 封装:Reel |
| TPA321EVM | 功能描述:音频 IC 开发工具 TPA321 Eval Mod RoHS:否 制造商:Texas Instruments 产品:Evaluation Kits 类型:Audio Amplifiers 工具用于评估:TAS5614L 工作电源电压:12 V to 38 V |
| TPA3221DDV | 功能描述:HIGH POWER AMPLIFIER 制造商:texas instruments 系列:- 包装:管件 零件状态:在售 类型:D 类 电压 - 电源:7 V ~ 32 V 安装类型:表面贴装 工作温度:0°C ~ 70°C 供应商器件封装:44-HTSSOP 封装/外壳:44-TSSOP（0.240"，6.10mm 宽）裸露焊盘 标准包装:35 |
| TPA3244DDWR | 功能描述:IC AMP AUDIO CLASS D 44-HTSSOP 制造商:texas instruments 系列:- 包装:剪切带（CT） 零件状态:在售 类型:D 类 输出类型:2 通道（立体声） 不同负载时的最大输出功率 x 通道数:60W x 2 @ 8 欧姆 电压 - 电源:12 V ~ 31.5 V 特性:消除爆音，短路保护 安装类型:表面贴装 工作温度:最高 750.2°F（399°C） 供应商器件封装:44-HTSSOP 封装/外壳:44-TSSOP（0.240"，6.10mm 宽）裸露焊盘 标准包装:1 |
| TPA3244EVM | 功能描述:EVAL BOARD FOR TPA3244 制造商:texas instruments 系列:PurePath? 零件状态:在售 放大器类型:D 类 输出类型:2 通道（立体声） 不同负载时的最大输出功率 x 通道数:100W x 2 @ 4 欧姆 电压 - 电源:14 V ~ 31.5 V 板类型:完全填充 使用的 IC/零件:TPA3244 所含物品:板 标准包装:1 |
发布紧急采购，3分钟左右您将得到回复。