- 您现在的位置：买卖IC网 > PDF目录98278 > TPL9202PWP (TEXAS INSTRUMENTS INC) 8-CHANNEL POWER SUPPLY SUPPORT CKT, PDSO20 PDF资料下载
参数资料
| 型号： | TPL9202PWP |
| 厂商： | TEXAS INSTRUMENTS INC |
| 元件分类： | 电源管理 |
| 英文描述： | 8-CHANNEL POWER SUPPLY SUPPORT CKT, PDSO20 |
| 封装： | GREEN, PLASTIC, HTSSOP-20 |
| 文件页数： | 13/18页 |
| 文件大小： | 432K |
| 代理商： | TPL9202PWP |
www.ti.com
DETAILED DESCRIPTION
8-CHANNEL RELAY DRIVER
WITH INTEGRATED 5-V LDO AND BROWN-OUT DETECTION
SLIS124D – JUNE 2006 – REVISED FEBRUARY 2008
The 5-V regulator is powered from VIN, and the regulated output is within 5 V ± 5% over the operating conditions.
The open-drain power-on reset (RST) pin remains low until the regulator exceeds the set threshold, and the timer
value set by the capacitor on the reset delay (RDELAY) pin expires. If both of these conditions are satisfied, RST is
asserted high. This signifies to the microcontroller that serial communications can be initiated to the TPL9202.
The serial communications is an 8-bit format, with data transfer synchronized using a serial clock from the
microcontroller. A single register controls all the outputs (one bit per output). The default value is zero (OFF). If
an output requires pulse width modulation (PWM) function, the register must be updated at a rate faster than the
desired PWM frequency. OUT1 can be controlled by serial input from the microcontroller or with the dedicated
enable (EN1) pin. If EN1 is pulled low or left open, the serial input through the shift register controls OUT1. If
EN1 is pulled high, OUT1 always is turned on, and the serial input for OUT1 is ignored.
The brown-out (BO) input is a resistor divided from the input supply and is used to determine if the supply
voltage drops to undesired levels. If the input drops below the programmed value, BO_OUTZ is pulled low, and
all outputs are disabled. Once the input supply line returns to the minimum desired level, the outputs are enabled
to the previous programmed states.
If RST is asserted, all outputs are turned OFF internally, and the input register is reset to all zeroes. The
microcontroller must write to the register to turn the outputs ON again.
4
Copyright 2006–2008, Texas Instruments Incorporated
Product Folder Link(s): TPL9202
相关PDF资料 |
PDF描述 |
|---|---|
| TPL9202PWPR | 8-CHANNEL POWER SUPPLY SUPPORT CKT, PDSO20 |
| TPS2001CDGNR | SPECIALTY ANALOG CIRCUIT, PDSO8 |
| TPS2000CDGN | SPECIALTY ANALOG CIRCUIT, PDSO8 |
| TPS2010APWPR | 1-CHANNEL POWER SUPPLY SUPPORT CKT, PDSO14 |
| TPS2012APWPG4 | 1-CHANNEL POWER SUPPLY SUPPORT CKT, PDSO14 |
相关代理商/技术参数 |
参数描述 |
|---|---|
| TPL9202PWPG4 | 功能描述:外围驱动器与原件 - PCI 8Ch Relay Drvr RoHS:否 制造商:PLX Technology 工作电源电压: 最大工作温度: 安装风格:SMD/SMT 封装 / 箱体:FCBGA-1156 封装:Tray |
| TPL9202PWPR | 功能描述:外围驱动器与原件 - PCI 8-Ch Relay Dr with Integrated 5V LDO RoHS:否 制造商:PLX Technology 工作电源电压: 最大工作温度: 安装风格:SMD/SMT 封装 / 箱体:FCBGA-1156 封装:Tray |
| TPL9202PWPRG4 | 功能描述:外围驱动器与原件 - PCI 8Ch Relay Drvr RoHS:否 制造商:PLX Technology 工作电源电压: 最大工作温度: 安装风格:SMD/SMT 封装 / 箱体:FCBGA-1156 封装:Tray |
| TPL-BA | 功能描述:保险丝 TELPOWER FUSE RoHS:否 制造商:Littelfuse 产品:Surface Mount Fuses 电流额定值:0.5 A 电压额定值:600 V 保险丝类型:Fast Acting 保险丝大小/组:Nano 尺寸:12.1 mm L x 4.5 mm W 安装风格: 端接类型:SMD/SMT 系列:485 |
| TPL-BASI1 | 制造商:Cooper Bussmann 功能描述:TELPOWER FUSE KIT - Bulk |
发布紧急采购，3分钟左右您将得到回复。