- 您现在的位置：买卖IC网 > PDF目录69502 > TPS2311IPWR (TEXAS INSTRUMENTS INC) 2-CHANNEL POWER SUPPLY SUPPORT CKT, PDSO20 PDF资料下载
参数资料
| 型号： | TPS2311IPWR |
| 厂商： | TEXAS INSTRUMENTS INC |
| 元件分类： | 电源管理 |
| 英文描述： | 2-CHANNEL POWER SUPPLY SUPPORT CKT, PDSO20 |
| 封装： | PLASTIC, TSSOP-20 |
| 文件页数： | 8/24页 |
| 文件大小： | 644K |
| 代理商： | TPS2311IPWR |
www.ti.com
TIMER
OUTPUT-VOLTAGE SLEW-RATE CONTROL
dVs
dt
+
15 mA
C
gd
(1)
VREG CAPACITOR
GATE DRIVE CIRCUITRY
SLVS275G – FEBRUARY 2000 – REVISED NOVEMBER 2006
APPLICATION INFORMATION (continued)
Table 2. Some Available N-Channel MOSFETs
CURRENT RANGE
PART NUMBER
DESCRIPTION
MANUFACTURER
(A)
IRF7601
N-channel, rDS(on) = 0.035 , 4.6 A, Micro-8
International Rectifier
MTSF3N03HDR2
N-channel, rDS(on) = 0.040 , 4.6 A, Micro-8
ON Semiconductor
0 to 2
IRF7101
Dual N-channel, rDS(on) = 0.1 , 2.3 A, SO-8
International Rectifier
MMSF5N02HDR2
Dual N-channel, rDS(on) = 0.04 , 5 A, SO-8
ON Semiconductor
IRF7401
N-channel, rDS(on) = 0.022 , 7 A, SO-8
International Rectifier
MMSF5N02HDR2
N-channel, rDS(on) = 0.025 , 5 A, SO-8
ON Semiconductor
2 to 5
IRF7313
Dual N-channel, rDS(on) = 0.029 , 5.2 A, SO-8
International Rectifier
SI4410
N-channel, rDS(on) = 0.020 , 8 A, SO-8
Vishay Dale
IRLR3103
N-channel, rDS(on) = 0.019 , 29 A, d-Pak
International Rectifier
5 to 10
IRLR2703
N-channel, rDS(on) = 0.045 , 14 A, d-Pak
International Rectifier
For most applications, a minimum capacitance of 50 pF is recommended to prevent false triggering. This
capacitor should be connected between TIMER and ground. The presence of an overcurrent condition on either
channel of the TPS2310/11 causes a 50-
A current source to begin charging this capacitor. If the over-current
condition persists until the capacitor has been charged to approximately 0.5 V, the TPS2310/11 latches off all
channels and pulls the FAULT pin low. The timer capacitor can be made as large as desired to provide
additional time delay before registering a fault condition. The time delay is approximately:
dt(sec) = CTIMER(F) × 10,000().
When enabled, the TPS2310/11 controllers supply the gates of each external MOSFET transistor with a current
of approximately 15
A. The slew rate of the MOSFET source voltage is thus limited by the gate-to-drain
capacitance Cgd of the external MOSFET capacitor to a value approximating:
If a slower slew rate is desired, an additional capacitance can be connected between the gate of the external
MOSFET and ground.
The internal voltage regulator connected to VREG requires an external capacitor to ensure stability. A 0.1-
F or
0.22-
F ceramic capacitor is recommended.
The TPS2310/11 includes four separate features associated with each gate-drive terminal:
A charging current of approximately 15 A is applied to enable the external MOSFET transistor. This current
is generated by an internal charge pump that can develop a gate-to-source potential (referenced to DISCH1
or DISCH2) of 9 V–12 V. DISCH1 and DISCH2 must be connected to the respective external MOSFET
source terminals to ensure proper operation of this circuitry.
A discharge current of approximately 75 A is applied to disable the external MOSFET transistor. Once the
transistor gate voltage has dropped below approximately 1.5 V, this current is disabled and the UVLO
discharge driver is enabled instead. This feature allows the part to enter a low-current shutdown mode while
ensuring that the gates of the external MOSFET transistors remain at a low voltage.
During a UVLO condition, the gates of both MOSFET transistors are pulled down by internal PMOS
transistors. These transistors continue to operate even if IN1 and IN2 are both at 0 V. This circuitry also
helps hold the external MOSFET transistors off when power is suddenly applied to the system.
16
相关PDF资料 |
PDF描述 |
|---|---|
| TPS2310IPWG4 | 2-CHANNEL POWER SUPPLY SUPPORT CKT, PDSO20 |
| TPS2301IPWR | 2-CHANNEL POWER SUPPLY SUPPORT CKT, PDSO20 |
| TPS2311IPW | 2-CHANNEL POWER SUPPLY SUPPORT CKT, PDSO20 |
| TPS2321IDR | 2-CHANNEL POWER SUPPLY SUPPORT CKT, PDSO16 |
| TPS2321IPWG4 | 2-CHANNEL POWER SUPPLY SUPPORT CKT, PDSO16 |
相关代理商/技术参数 |
参数描述 |
|---|---|
| TPS2311IPWRG4 | 功能描述:热插拔功率分布 3-13V Dual w/Intrdpt Chl Circuit Breaking RoHS:否 制造商:Texas Instruments 产品:Controllers & Switches 电流限制: 电源电压-最大:7 V 电源电压-最小:- 0.3 V 工作温度范围: 功率耗散: 安装风格:SMD/SMT 封装 / 箱体:MSOP-8 封装:Tube |
| TPS2320ID | 功能描述:热插拔功率分布 3-13V Dual w/Ind Chl Circuit Breaking RoHS:否 制造商:Texas Instruments 产品:Controllers & Switches 电流限制: 电源电压-最大:7 V 电源电压-最小:- 0.3 V 工作温度范围: 功率耗散: 安装风格:SMD/SMT 封装 / 箱体:MSOP-8 封装:Tube |
| TPS2320IDG4 | 功能描述:热插拔功率分布 3-13V Dual w/Ind Chl Circuit Breaking RoHS:否 制造商:Texas Instruments 产品:Controllers & Switches 电流限制: 电源电压-最大:7 V 电源电压-最小:- 0.3 V 工作温度范围: 功率耗散: 安装风格:SMD/SMT 封装 / 箱体:MSOP-8 封装:Tube |
| TPS2320IDR | 功能描述:热插拔功率分布 3-13V Dual w/Ind Chl Circuit Breaking RoHS:否 制造商:Texas Instruments 产品:Controllers & Switches 电流限制: 电源电压-最大:7 V 电源电压-最小:- 0.3 V 工作温度范围: 功率耗散: 安装风格:SMD/SMT 封装 / 箱体:MSOP-8 封装:Tube |
| TPS2320IDRG4 | 功能描述:热插拔功率分布 3-13V Dual w/Ind Chl Circuit Breaking RoHS:否 制造商:Texas Instruments 产品:Controllers & Switches 电流限制: 电源电压-最大:7 V 电源电压-最小:- 0.3 V 工作温度范围: 功率耗散: 安装风格:SMD/SMT 封装 / 箱体:MSOP-8 封装:Tube |
发布紧急采购，3分钟左右您将得到回复。