- 您现在的位置：买卖IC网 > PDF目录69510 > TPS53125PW (TEXAS INSTRUMENTS INC) DUAL SWITCHING CONTROLLER, 350 kHz SWITCHING FREQ-MAX, PDSO24 PDF资料下载
参数资料
| 型号： | TPS53125PW |
| 厂商： | TEXAS INSTRUMENTS INC |
| 元件分类： | 稳压器 |
| 英文描述： | DUAL SWITCHING CONTROLLER, 350 kHz SWITCHING FREQ-MAX, PDSO24 |
| 封装： | GREEN, PLASTIC, TSSOP-24 |
| 文件页数： | 2/27页 |
| 文件大小： | 791K |
| 代理商： | TPS53125PW |
第1页当前第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页
V
=
TRIP
(V-V )
IN
O
2
1
L
f
SW
V
O
V
IN
RDS(ON)
I
-
OCL
(
)
R
(k )=
TRIP
W
V
(mV)
TRIP
I
( A)
TRIP
m
SLVS947B – OCTOBER 2009 – REVISED JANUARY 2010
www.ti.com
Output Discharge Control
TPS53125 discharges the outputs when ENx is low, or the controller is turned off by the protection functions
(OVP, UVP, UVLO, and thermal shutdown). The device discharges output using an internal 40-
MOSFET which
is connected to VOx and PGNDx. The external low-side MOSFET is not turned on during the output discharge
operation to avoid the possibility of causing negative voltage at the output. This discharge ensures that on start
the regulated voltage always initializes from 0 V.
Over Current Limit
TPS53125 has cycle-by-cycle over current limit feature. The over current limits the inductor valley current by
monitoring the voltage drop across the low-side MOSFET RDS(ON) during the low-side driver on-time. If the
inductor current is larger than the over current limit (OCL), the TPS53125 delays the start of the next switching
cycle until the sensed inductor current falls below the OCL current. MOSFET RDS(ON) current sensing is used to
provide an accuracy and cost effective solution without external devices. To program the OCL, the TRIP pin
should be connected to GND through a trip voltage setting resistor, according to the following equations.
(1)
(2)
The trip voltage should be between 30 mV to 300 mV over all operational temperature, including the
4000-ppm/°C temperature slope compensation for the temperature dependency of the RDS(ON).
If the load current exceeds the over current limit, the voltage will begin to drop. If the over current conditions
continues the output voltage will fall below the under voltage protection threshold and the TPS53125 will shut
down.
In an over current condition, the current to the load exceeds the current to the output capacitor; thus the output
voltage tends to fall off. Eventually, it will end up with crossing the under voltage protection threshold and
shutdown.
Over/Under Voltage Protection
TPS53125 monitors a resistor divided feedback voltage to detect over and under voltage. If the feedback voltage
is higher than 115% of the reference voltage, the OVP comparator output goes high and the circuit latches the
high-side MOSFET driver OFF and the low-side MOSFET driver ON.
When the feedback voltage is lower than 70% of the reference voltage, the UVP comparator output goes high
and an internal UVP delay counter begins counting. After 30
μs, TPS53125 latches OFF both top and bottom
MOSFET drivers. This function is enabled approximately 1.7 x TSS after power-on. The OVP and UVP latch off is
reset when EN goes low level.
UVLO Protection
TPS53125 has V5FILT under voltage lock out protection (UVLO) that monitors the voltage of V5FILT pin.
When the V5FILT voltage is lower than UVLO threshold voltage, the device is shut off. All output drivers are OFF
and output discharge is ON. The UVLO is non-latch protection.
Thermal Shutdown
The TPS53125 includes an over temperature protection shut-down feature. If the TPS53125 die temperature
exceeds the OTP threshold (typically 150°C), both the high-side and low-side drivers are shut off, the output
voltage discharge function is enabled and then the device is shut off until the die temperature drops. Thermal
shutdown is a non-latch protection.
10
Copyright 2009–2010, Texas Instruments Incorporated
Product Folder Link(s): TPS53125
相关PDF资料 |
PDF描述 |
|---|---|
| TPS53125PWR | DUAL SWITCHING CONTROLLER, 350 kHz SWITCHING FREQ-MAX, PDSO24 |
| TPS53126PWR | 0.17 A DUAL SWITCHING CONTROLLER, 700 kHz SWITCHING FREQ-MAX, PDSO24 |
| TPS53126RGET | 0.17 A DUAL SWITCHING CONTROLLER, 700 kHz SWITCHING FREQ-MAX, PQCC24 |
| TPS53126PW | 0.17 A DUAL SWITCHING CONTROLLER, 700 kHz SWITCHING FREQ-MAX, PDSO24 |
| TPS53129PWR | DUAL SWITCHING CONTROLLER, 700 kHz SWITCHING FREQ-MAX, PDSO24 |
相关代理商/技术参数 |
参数描述 |
|---|---|
| TPS53125PWR | 功能描述:DC/DC 开关控制器 Dual Synch Step-Down Controller RoHS:否 制造商:Texas Instruments 输入电压:6 V to 100 V 开关频率: 输出电压:1.215 V to 80 V 输出电流:3.5 A 输出端数量:1 最大工作温度:+ 125 C 安装风格: 封装 / 箱体:CPAK |
| TPS53125RGER | 功能描述:DC/DC 开关控制器 Dual Synch Step-Down Controller RoHS:否 制造商:Texas Instruments 输入电压:6 V to 100 V 开关频率: 输出电压:1.215 V to 80 V 输出电流:3.5 A 输出端数量:1 最大工作温度:+ 125 C 安装风格: 封装 / 箱体:CPAK |
| TPS53125RGET | 功能描述:DC/DC 开关控制器 Dual Synch Step-Down Controller RoHS:否 制造商:Texas Instruments 输入电压:6 V to 100 V 开关频率: 输出电压:1.215 V to 80 V 输出电流:3.5 A 输出端数量:1 最大工作温度:+ 125 C 安装风格: 封装 / 箱体:CPAK |
| TPS53126 | 制造商:TI 制造商全称:Texas Instruments 功能描述:DUAL SYNCHRONOUS STEP-DOWN CONTROLLER FOR LOW VOLTAGE POWER RAILS |
| TPS53126EVM-600 | 功能描述:电源管理IC开发工具 TPS53126 Eval Mod RoHS:否 制造商:Maxim Integrated 产品:Evaluation Kits 类型:Battery Management 工具用于评估:MAX17710GB 输入电压: 输出电压:1.8 V |
发布紧急采购，3分钟左右您将得到回复。