- 您现在的位置：买卖IC网 > PDF目录98282 > TPS54227DDA (TEXAS INSTRUMENTS INC) 4.7 A SWITCHING REGULATOR, 700 kHz SWITCHING FREQ-MAX, PDSO8 PDF资料下载
参数资料
| 型号： | TPS54227DDA |
| 厂商： | TEXAS INSTRUMENTS INC |
| 元件分类： | 稳压器 |
| 英文描述： | 4.7 A SWITCHING REGULATOR, 700 kHz SWITCHING FREQ-MAX, PDSO8 |
| 封装： | PLASTIC, MS-012BA, SOP-8 |
| 文件页数： | 17/19页 |
| 文件大小： | 323K |
| 代理商： | TPS54227DDA |
C6(nF) x V
C6(nF) x 0.765 x 1.1
REF
t
(ms) =
=
SS
I
( A)
2
SS
x 1.1
m
SLVSAU2
– MAY 2011
OVERVIEW
The TPS54227 is a 2-A synchronous step-down (buck) converter with two integrated N-channel MOSFETs. It
operates using D-CAP2
mode control. The fast transient response of D-CAP2 control reduces the output
capacitance required to meet a specific level of performance. Proprietary internal circuitry allows the use of low
ESR output capacitors including ceramic and special polymer types.
DETAILED DESCRIPTION
PWM Operation
The main control loop of the TPS54227 is an adaptive on-time pulse width modulation (PWM) controller that
supports a proprietary D-CAP2
mode control. D-CAP2 mode control combines constant on-time control with
an internal compensation circuit for pseudo-fixed frequency and low external component count configuration with
both low ESR and ceramic output capacitors. It is stable even with virtually no ripple at the output.
At the beginning of each cycle, the high-side MOSFET is turned on. This MOSFET is turned off after internal one
shot timer expires. This one shot is set by the converter input voltage, VIN, and the output voltage, VO, to
maintain a pseudo-fixed frequency over the input voltage range, hence it is called adaptive on-time control. The
one-shot timer is reset and the high-side MOSFET is turned on again when the feedback voltage falls below the
reference voltage. An internal ramp is added to reference voltage to simulate output ripple, eliminating the need
for ESR induced output ripple from D-CAP2
mode control.
PWM Frequency and Adaptive On-Time Control
TPS54227 uses an adaptive on-time control scheme and does not have a dedicated on board oscillator. The
TPS54227 runs with a pseudo-constant frequency of 700 kHz by using the input voltage and output voltage to
set the on-time one-shot timer. The on-time is inversely proportional to the input voltage and proportional to the
output voltage, therefore, when the duty ratio is VOUT/VIN, the frequency is constant.
Soft Start and Pre-Biased Soft Start
The soft start function is adjustable. When the EN pin becomes high, 2-
μA current begins charging the capacitor
which is connected from the SS pin to GND. Smooth control of the output voltage is maintained during start up.
The equation for the slow start time is shown in Equation 1. VFB voltage is 0.765 V and SS pin source current is
2
μA.
(1)
The TPS54227 contains a unique circuit to prevent current from being pulled from the output during startup if the
output is pre-biased. When the soft-start commands a voltage higher than the pre-bias level (internal soft start
becomes greater than feedback voltage VFB), the controller slowly activates synchronous rectification by starting
the first low side FET gate driver pulses with a narrow on-time. It then increments that on-time on a
cycle-by-cycle basis until it coincides with the time dictated by (1-D), where D is the duty cycle of the converter.
This scheme prevents the initial sinking of the pre-bias output, and ensure that the out voltage (VO) starts and
ramps up smoothly into regulation and the control loop is given time to transition from pre-biased start-up to
normal mode operation.
Current Protection
The output overcurrent protection (OCP) is implemented using a cycle-by-cycle valley detect control circuit. The
switch current is monitored by measuring the low-side FET switch voltage between the SW pin and GND. This
voltage is proportional to the switch current. To improve accuracy, the voltage sensing is temperature
compensated.
During the on time of the high-side FET switch, the switch current increases at a linear rate determined by Vin,
Vout, the on-time and the output inductor value. During the on time of the low-side FET switch, this current
decreases linearly. The average value of the switch current is the load current IOUT. The TPS54227 constantly
monitors the low-side FET switch voltage, which is proportional to the switch current, during the low-side on-time.
If the measured voltage is above the voltage proportional to the current limit, an internal counter is incremented
per each SW cycle and the converter maintains the low-side switch on until the measured voltage is below the
voltage corresponding to the current limit at which time the switching cycle is terminated and a new switching
Copyright
2011, Texas Instruments Incorporated
7
相关PDF资料 |
PDF描述 |
|---|---|
| TPS54233DG4 | 2 A SWITCHING REGULATOR, 390 kHz SWITCHING FREQ-MAX, PDSO8 |
| TPS54240QDGQRQ1 | 2.5 A SWITCHING REGULATOR, 2500 kHz SWITCHING FREQ-MAX, PDSO10 |
| TPS54260DGQR | SWITCHING REGULATOR, 2500 kHz SWITCHING FREQ-MAX, PDSO10 |
| TPS54260QDGQRQ1 | 2.5 A SWITCHING REGULATOR, 2500 kHz SWITCHING FREQ-MAX, PDSO10 |
| TPS5430MDDAREPG4 | 8.5 A SWITCHING REGULATOR, 600 kHz SWITCHING FREQ-MAX, PDSO8 |
相关代理商/技术参数 |
参数描述 |
|---|---|
| TPS54227DDAR | 功能描述:直流/直流开关调节器 4.5-18Vin,2A Sync Step Down Cnvrtr RoHS:否 制造商:International Rectifier 最大输入电压:21 V 开关频率:1.5 MHz 输出电压:0.5 V to 0.86 V 输出电流:4 A 输出端数量: 最大工作温度: 安装风格:SMD/SMT 封装 / 箱体:PQFN 4 x 5 |
| TPS54227DRCR | 制造商:Texas Instruments 功能描述:IC REG BUCK SYNC ADJ 2A 10SON 制造商:Texas Instruments 功能描述:2A Single Sync DC/DC converter |
| TPS54227DRCT | 制造商:Texas Instruments 功能描述:2A SINGLE SYNC DC/DC CONVERTER - Tape and Reel 制造商:Texas Instruments 功能描述:2A SINGLE SYNC DC/DC CONVERTER - Cut TR (SOS) 制造商:Texas Instruments 功能描述:IC REG BUCK SYNC ADJ 2A 10SON 制造商:Texas Instruments 功能描述:IC SYNC STEP DOWN 700KHZ SO 制造商:Texas Instruments 功能描述:IC, SYNC STEP DOWN, 700KHZ, SON-10 制造商:Texas Instruments 功能描述:Voltage Regulators - Switching Regulators 4.5-18Vin,2A Sync SD Cnvrtr 制造商:Texas Instruments 功能描述:IC, SYNC STEP DOWN, 700KHZ, SON-10, Primary Input Voltage:18V, No. of Outputs:1, 制造商:Texas Instruments 功能描述:2A Single Sync DC/DC converter |
| TPS54227EVM-686 | 功能描述:电源管理IC开发工具 TPS54227 Eval Mod RoHS:否 制造商:Maxim Integrated 产品:Evaluation Kits 类型:Battery Management 工具用于评估:MAX17710GB 输入电压: 输出电压:1.8 V |
| TPS54228 | 制造商:TI 制造商全称:Texas Instruments 功能描述:4.5V to 18V Input, 2-A Synchronous Step-Down SWIFT |
发布紧急采购，3分钟左右您将得到回复。