- 您现在的位置：买卖IC网 > PDF目录69511 > TPS54350PWPR (TEXAS INSTRUMENTS INC) 6.5 A SWITCHING REGULATOR, 700 kHz SWITCHING FREQ-MAX, PDSO16 PDF资料下载
参数资料
| 型号： | TPS54350PWPR |
| 厂商： | TEXAS INSTRUMENTS INC |
| 元件分类： | 稳压器 |
| 英文描述： | 6.5 A SWITCHING REGULATOR, 700 kHz SWITCHING FREQ-MAX, PDSO16 |
| 封装： | GREEN, PLASTIC, HTSSOP-16 |
| 文件页数： | 30/32页 |
| 文件大小： | 762K |
| 代理商： | TPS54350PWPR |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页当前第30页第31页第32页
TPS54350
SLVS456C OCTOBER 2003 REVISED OCTOBER 2004
www.ti.com
7
320 k
125 k
R1
R2
Input Voltage Supply
1 k
Figure 1. Circuit Using External UVLO Function
The equations for selecting the UVLO resistors are:
R1
+
VIN(start)
1k
W
1.24 V
* 1kW
VIN(stop)
+
(R1
) 1kW)
1.02 V
1k
W
For applications which require an undervoltage lock out
(UVLO) threshold greater than 4.49 V, external resistors
may be implemented, see Figure 1, to adjust the start
voltage threshold. For example, an application needing an
UVLO start voltage of approximately 7.8 V using the
equation (1), R1 is calculated to the nearest standard
resistor value of 5.36 k
. Using equation (2), the input
voltage stop threshold is calculated as 6.48 V.
Enable (ENA) and Internal Slow Start
Once the ENA pin voltage exceeds 0.5 V, the TPS54350
starts operation. The TPS54350 has an internal digital
slow start that ramps the reference voltage to its final value
in 1150 switching cycles. The internal slow start time (10%
90%) is approximated by the following expression:
T
SS_INTERNAL(ms) +
1.15k
s(kHz)
Once the TPS54350 device is in normal regulation, the
ENA pin is high. If the ENA pin is pulled below the stop
threshold of 0.5 V, switching stops and the internal slow
start resets. If an application requires the TPS54350 to be
disabled, use open drain or open collector output logic to
interface to the ENA pin (see Figure 2). The ENA pin has
an internal pullup current source. Do not use external
pullup resistors.
5
A
Disabled
Enabled
RSS
CSS
Figure 2. Interfacing to the ENA Pin
Extending Slow Start Time
In applications that use large values of output capacitance
there may be a need to extend the slow start time to
prevent the startup current from tripping the current limit.
The current limit circuit is designed to disable the high side
MOSFET and reset the internal voltage reference for a
short amount of time when the high side MOSFET current
exceeds the current limit threshold. If the output
capacitance and load current cause the startup current to
exceed the current limit threshold, the power supply output
will not reach the desied output voltage. To extend the slow
start time and to reduce the startup current, an external
resistor and capcitor can be added to the ENA pin. The
slow start capacitance is calculated using the following
equation:
CSS(F) = 5.55e3 Tss(ms)
The RSS resistor must be 2 k and the slow start capacitor
must be less than 0.47
F.
Switching Frequency (RT)
The TPS54350 has an internal oscillator that operates at
twice the PWM switching frequency. The internal oscillator
frequency is controlled by the RT pin. Grounding the RT
pin sets the PWM switching frequency to a default
frequency of 250 kHz. Floating the RT pin sets the PWM
switching frequency to 500 kHz.
Connecting a resistor from RT to AGND sets the frequency
according to the following equation (also see Figure 30).
RT(k
W) +
46000
s(kHz)–35.9
The RT pin controls the SYNC pin functions. If the RT pin
is floating or grounded, SYNC is an output. If the switching
frequency has been programmed using a resistor from RT
to AGND, then SYNC functions as an input.
The internal voltage ramp charging current increases
linearly with the set frequency and keeps the feed forward
modulator constant (Km = 8) regardless of the frequency
set point.
(1)
(2)
(3)
(4)
相关PDF资料 |
PDF描述 |
|---|---|
| TPS54350PWP | 6.5 A SWITCHING REGULATOR, 700 kHz SWITCHING FREQ-MAX, PDSO16 |
| TPS54355PWPRG4 | 6.5 A SWITCHING REGULATOR, 600 kHz SWITCHING FREQ-MAX, PDSO16 |
| TPS54353PWPR | 6.5 A SWITCHING REGULATOR, 600 kHz SWITCHING FREQ-MAX, PDSO16 |
| TPS54356PWPG4 | 6.5 A SWITCHING REGULATOR, 600 kHz SWITCHING FREQ-MAX, PDSO16 |
| TPS54356PWPR | 6.5 A SWITCHING REGULATOR, 600 kHz SWITCHING FREQ-MAX, PDSO16 |
相关代理商/技术参数 |
参数描述 |
|---|---|
| TPS54350PWPRG4 | 功能描述:开关变换器、稳压器与控制器 4.5 to 20V Inp 3A Step-Down Converter RoHS:否 制造商:Texas Instruments 输出电压:1.2 V to 10 V 输出电流:300 mA 输出功率: 输入电压:3 V to 17 V 开关频率:1 MHz 工作温度范围: 安装风格:SMD/SMT 封装 / 箱体:WSON-8 封装:Reel |
| TPS54352 | 制造商:TI 制造商全称:Texas Instruments 功能描述:4.5V TO 20 V INPUT 3-A OUTPUT SYNCHRONOUS PWM SWITCHER WITH INTEGRATED FET |
| TPS54352-EP | 制造商:TI 制造商全称:Texas Instruments 功能描述:4.5-V TO 20-V INPUT, 3-A OUTPUT SYNCHRONOUS PWM SWITCHES |
| TPS54352MPWPREP | 制造商:TI 制造商全称:Texas Instruments 功能描述:4.5-V TO 20-V INPUT, 3-A OUTPUT SYNCHRONOUS PWM SWITCHES |
| TPS54352PWP | 功能描述:直流/直流开关调节器 4.5 to 20V Inp 3-A Synch PWM Switch RoHS:否 制造商:International Rectifier 最大输入电压:21 V 开关频率:1.5 MHz 输出电压:0.5 V to 0.86 V 输出电流:4 A 输出端数量: 最大工作温度: 安装风格:SMD/SMT 封装 / 箱体:PQFN 4 x 5 |
发布紧急采购，3分钟左右您将得到回复。