参数资料
型号: TPS61000DGST
厂商: TEXAS INSTRUMENTS INC
元件分类: 稳压器
英文描述: 1.3 A SWITCHING REGULATOR, 840 kHz SWITCHING FREQ-MAX, PDSO10
封装: PLASTIC, MSOP-10
文件页数: 9/25页
文件大小: 456K
代理商: TPS61000DGST
TPS61000, TPS61001, TPS61002, TPS61003, TPS61004, TPS61005, TPS61006, TPS61007
SINGLE- AND DUAL-CELL BOOST CONVERTER WITH START-UP INTO FULL LOAD
SLVS279C – MARCH 2000 – REVISED APRIL 2003
17
POST OFFICE BOX 655303
DALLAS, TEXAS 75265
APPLICATION INFORMATION
An additional ripple of 30 mV is the result of using a tantalum capacitor with a low ESR of 300 m
. The total ripple
is the sum of the ripple caused by the capacitance and the ripple caused by the ESR of the capacitor. In this
example, the total ripple is 45 mV. It is possible to improve the design by enlarging the capacitor or using smaller
capacitors in parallel to reduce the ESR or by using better capacitors with lower ESR, like ceramics. For exam-
ple, a 10-
F ceramic capacitor with an ESR of 50 m is used on the evaluation module (EVM). Tradeoffs have to
be made between performance and costs of the converter circuit.
A 10-
F input capacitor is recommended to improve transient behavior of the regulator. A ceramic capacitor or a
tantalum capacitor with a 100-nF ceramic capacitor in parallel placed close to the IC is recommended.
rectifier selection
The rectifier diode has a major impact on the overall converter efficiency. Standard diodes are not suitable for
low-voltage switched mode power supplies. A Schottky diode with low forward voltage and fast reverse recovery
should be used as a rectifier to minimize overall losses of the dc-dc converter. The maximum current rating of the
diode must be high enough for the application. The maximum diode current is equal to the maximum current in
the inductor that was calculated in equation 3. The maximum reverse voltage is the output voltage. The chosen
diode should therefore have a reverse voltage rating higher than the output voltage.
Table 2. Recommended Diodes
VENDOR
PART NUMBER
Motorola Surface Mount
MBRM120LT3
MBR0520LT1
Motorola Axial Lead
1N1517
ROHM
RB520S-30
RB160L–40
The typical forward voltage of those diodes is in the range of 0.35 to 0.45 V assuming a peak diode current of
600 mA.
compensation of the control loop
An R/C/C network must be connected to the COMP pin in order to stabilize the control loop of the converter. Both
the pole generated by the inductor L1 and the zero caused by the ESR and capacitance of the output capacitor
must be compensated. The network shown in Figure 19 satisfies these requirements.
CC2
33 nF
CC1
100 pF
RC
10 k
COMP
Figure 19. Compensation of the Control Loop
相关PDF资料
PDF描述
TPS61007DGSRG4 1.3 A SWITCHING REGULATOR, 840 kHz SWITCHING FREQ-MAX, PDSO10
TPS61002DGST 1.3 A SWITCHING REGULATOR, 840 kHz SWITCHING FREQ-MAX, PDSO10
TPS61001DGST 1.3 A SWITCHING REGULATOR, 840 kHz SWITCHING FREQ-MAX, PDSO10
TPS61004DGSRG4 1.3 A SWITCHING REGULATOR, 840 kHz SWITCHING FREQ-MAX, PDSO10
TPS61004DGST 1.3 A SWITCHING REGULATOR, 840 kHz SWITCHING FREQ-MAX, PDSO10
相关代理商/技术参数
参数描述
TPS61000EVM-156 功能描述:电源管理IC开发工具 Low Input Vltg Boost Conv RoHS:否 制造商:Maxim Integrated 产品:Evaluation Kits 类型:Battery Management 工具用于评估:MAX17710GB 输入电压: 输出电压:1.8 V
TPS61001 制造商:TI 制造商全称:Texas Instruments 功能描述:SINGLE-CELL BOOST CONVERTER WITH START-UP INTO FULL LOAD
TPS61001DGS 功能描述:开关变换器、稳压器与控制器 1.5V 100mA Boost RoHS:否 制造商:Texas Instruments 输出电压:1.2 V to 10 V 输出电流:300 mA 输出功率: 输入电压:3 V to 17 V 开关频率:1 MHz 工作温度范围: 安装风格:SMD/SMT 封装 / 箱体:WSON-8 封装:Reel
TPS61001DGSG4 功能描述:开关变换器、稳压器与控制器 Lo-In Voltage Boost Converter RoHS:否 制造商:Texas Instruments 输出电压:1.2 V to 10 V 输出电流:300 mA 输出功率: 输入电压:3 V to 17 V 开关频率:1 MHz 工作温度范围: 安装风格:SMD/SMT 封装 / 箱体:WSON-8 封装:Reel
TPS61001DGSR 功能描述:开关变换器、稳压器与控制器 Lo-In Voltage Boost Converter RoHS:否 制造商:Texas Instruments 输出电压:1.2 V to 10 V 输出电流:300 mA 输出功率: 输入电压:3 V to 17 V 开关频率:1 MHz 工作温度范围: 安装风格:SMD/SMT 封装 / 箱体:WSON-8 封装:Reel