- 您现在的位置：买卖IC网 > PDF目录231088 > TPS61026DRCTG4 (TEXAS INSTRUMENTS INC) 2.1 A SWITCHING REGULATOR, 720 kHz SWITCHING FREQ-MAX, PDSO10 PDF资料下载
参数资料
| 型号： | TPS61026DRCTG4 |
| 厂商： | TEXAS INSTRUMENTS INC |
| 元件分类： | 稳压器 |
| 英文描述： | 2.1 A SWITCHING REGULATOR, 720 kHz SWITCHING FREQ-MAX, PDSO10 |
| 封装： | 3 X 3 MM, GREEN, PLASTIC, SON-10 |
| 文件页数： | 7/29页 |
| 文件大小： | 746K |
| 代理商： | TPS61026DRCTG4 |
第1页第2页第3页第4页第5页第6页当前第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页
www.ti.com
APPLICATION INFORMATION
DESIGN PROCEDURE
PROGRAMMING THE OUTPUT VOLTAGE
R3 + R4
V
O
V
FB
* 1 + 180 kW
V
O
500 mV *
1
(1)
C
parR3 +
20 pF
200 kW
R4
* 1
(2)
SW
C1
Power
Supply
L1
R1
R2
VBAT
VOUT
FB
C2
C3
LBO
PGND
LBI
PS
EN
GND
TPS61020
VCC
Boost Output
Control Output
R3
R4
R5
PROGRAMMING THE LBI/LBO THRESHOLD VOLTAGE
SLVS451D – SEPTEMBER 2003 – REVISED FEBRUARY 2006
The TPS6102x dc/dc converters are intended for systems powered by a single up to triple cell Alkaline, NiCd,
NiMH battery with a typical terminal voltage between 0.9 V and 6.5 V. They can also be used in systems
powered by one-cell Li-Ion or Li-Polymer with a typical voltage between 2.5 V and 4.2 V. Additionally, any other
voltage source with a typical output voltage between 0.9 V and 6.5 V can power systems where the TPS6102x is
used.
The output voltage of the TPS61020 dc/dc converter can be adjusted with an external resistor divider. The typical
value of the voltage at the FB pin is 500 mV. The maximum recommended value for the output voltage is 5.5 V.
The current through the resistive divider should be about 100 times greater than the current into the FB pin. The
typical current into the FB pin is 0.01 A, and the voltage across R4 is typically 500 mV. Based on those two
values, the recommended value for R4 should be lower than 500 k
, in order to set the divider current at 1 A or
higher. Because of internal compensation circuitry the value for this resistor should be in the range of 200 k
.
From that, the value of resistor R3, depending on the needed output voltage (VO), can be calculated using
If as an example, an output voltage of 3.3 V is needed, a 1.0-M
resistor should be chosen for R3. If for any
reason the value for R4 is chosen significantly lower than 200 k
additional capacitance in parallel to R3 is
recommended, in case the device shows instable regulation of the output voltage. The required capacitance
value can be easily calculated using Equation 2:
Figure 22. Typical Application Circuit for Adjustable Output Voltage Option
The current through the resistive divider should be about 100 times greater than the current into the LBI pin. The
typical current into the LBI pin is 0.01 A, and the voltage across R2 is equal to the LBI voltage threshold that is
generated on-chip, which has a value of 500 mV. The recommended value for R2 is therefore in the range of 500
k
. From that, the value of resistor R1, depending on the desired minimum battery voltage VBAT, can be
calculated using Equation 3.
Copyright 2003–2006, Texas Instruments Incorporated
15
相关PDF资料 |
PDF描述 |
|---|---|
| TC151B5012EOA713 | 0.25 A SWITCHING REGULATOR, 50 kHz SWITCHING FREQ-MAX, PDSO8 |
| TC151B5714EOA723 | 0.25 A SWITCHING REGULATOR, 50 kHz SWITCHING FREQ-MAX, PDSO8 |
| TC151B5219EOA723 | 0.25 A SWITCHING REGULATOR, 50 kHz SWITCHING FREQ-MAX, PDSO8 |
| TC151B2025EOA713 | 0.25 A SWITCHING REGULATOR, 50 kHz SWITCHING FREQ-MAX, PDSO8 |
| TC151B2025EOA723 | 0.25 A SWITCHING REGULATOR, 50 kHz SWITCHING FREQ-MAX, PDSO8 |
相关代理商/技术参数 |
参数描述 |
|---|---|
| TPS61027 | 制造商:TI 制造商全称:Texas Instruments 功能描述:96% EFFICIENT SYNCHRONOUS BOOST CONVERTER WITH 1.5-A SWITCH |
| TPS61027DRC | 制造商:TI 制造商全称:Texas Instruments 功能描述:96% EFFICIENT SYNCHRONOUS BOOST CONVERTER WITH 1.5-A SWITCH |
| TPS61027DRCR | 功能描述:直流/直流开关调节器 5-V Otp 1.5-A Swit Boost Converter RoHS:否 制造商:International Rectifier 最大输入电压:21 V 开关频率:1.5 MHz 输出电压:0.5 V to 0.86 V 输出电流:4 A 输出端数量: 最大工作温度: 安装风格:SMD/SMT 封装 / 箱体:PQFN 4 x 5 |
| TPS61027DRCR | 制造商:Texas Instruments 功能描述:DC/DC Converter IC |
| TPS61027DRCRG4 | 功能描述:直流/直流开关调节器 5-V Otp 1.5-A Swit Boost Converter RoHS:否 制造商:International Rectifier 最大输入电压:21 V 开关频率:1.5 MHz 输出电压:0.5 V to 0.86 V 输出电流:4 A 输出端数量: 最大工作温度: 安装风格:SMD/SMT 封装 / 箱体:PQFN 4 x 5 |
发布紧急采购，3分钟左右您将得到回复。