- 您现在的位置：买卖IC网 > PDF目录69514 > TPS61027QDRCRQ1 (TEXAS INSTRUMENTS INC) BATTERY CHARGE CONTROLLER, PDSO10 PDF资料下载
参数资料
| 型号： | TPS61027QDRCRQ1 |
| 厂商： | TEXAS INSTRUMENTS INC |
| 元件分类： | 稳压器 |
| 英文描述： | BATTERY CHARGE CONTROLLER, PDSO10 |
| 封装： | 3 X 3 MM, GREEN, PLASTIC, SON-10 |
| 文件页数： | 5/27页 |
| 文件大小： | 0K |
| 代理商： | TPS61027QDRCRQ1 |
第1页第2页第3页第4页当前第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页
0
0.05
0.1
0.15
0.2
0.25
0.3
0.35
0
0.5
1
1.5
2
2.5
3
3.5
4
4.5
5
VBAT = 5 V
VBAT = 3.6 V
VBAT = 2.4 V
VBAT = 1.8 V
VBAT = 1.2 V
VO Output Voltage V
Precharge
Current
A
TPS61025-Q1
TPS61027-Q1
www.ti.com
SLVSA31 – NOVEMBER 2009
Undervoltage Lockout
An undervoltage lockout function prevents device start-up if the supply voltage on VBAT is lower than
approximately 0.8 V. When in operation and the battery is being discharged, the device automatically enters the
shutdown mode if the voltage on VBAT drops below approximately 0.8 V. This undervoltage lockout function is
implemented in order to prevent the malfunctioning of the converter.
Softstart and Short Circuit Protection
When the device enables, the internal startup cycle starts with the first step, the precharge phase. During
precharge, the rectifying switch is turned on until the output capacitor is charged to a value close to the input
voltage. The rectifying switch is current limited during that phase. The current limit increases with the output
voltage. This circuit also limits the output current under short circuit conditions at the output. Figure 20 shows the
typical precharge current vs output voltage for specific input voltages:
Figure 20. Precharge and Short Circuit Current
After charging the output capacitor to the input voltage, the device starts switching. If the input voltage is below
1.4 V the device works with a fixed duty cycle of 50% until the output voltage reaches 1.4 V. After that the duty
cycle is set depending on the input output voltage ratio. Until the output voltage reaches its nominal value, the
boost switch current limit is set to 40% of its nominal value to avoid high peak currents at the battery during
startup. As soon as the output voltage is reached, the regulator takes control and the switch current limit is set
back to 100%.
Power Save Mode
The PS pin can be used to select different operation modes. To enable power save, PS must be set low. Power
save mode is used to improve efficiency at light load. In power save mode the converter only operates when the
output voltage trips below a set threshold voltage. It ramps up the output voltage with one or several pulses and
goes again into power save mode once the output voltage exceeds the set threshold voltage. This power save
mode can be disabled by setting the PS to VBAT. In down conversion mode, power save mode is always active
and the device cannot be forced into fixed frequency operation at light loads.
Low Battery Detector Circuit—LBI/LBO
The low-battery detector circuit is typically used to supervise the battery voltage and to generate an error flag
when the battery voltage drops below a user-set threshold voltage. The function is active only when the device is
enabled. When the device is disabled, the LBO pin is high-impedance. The switching threshold is 500 mV at LBI.
During normal operation, LBO stays at high impedance when the voltage, applied at LBI, is above the threshold.
It is active low when the voltage at LBI goes below 500 mV.
Copyright 2009, Texas Instruments Incorporated
13
Product Folder Link(s) :TPS61029-Q1
相关PDF资料 |
PDF描述 |
|---|---|
| TPS61032PWPG4 | 4.5 A BATTERY CHARGE CONTROLLER, 700 kHz SWITCHING FREQ-MAX, PDSO16 |
| TPS61031PWPRG4 | 4.5 A BATTERY CHARGE CONTROLLER, 700 kHz SWITCHING FREQ-MAX, PDSO16 |
| TPS61030RSAR | 4.5 A BATTERY CHARGE CONTROLLER, 700 kHz SWITCHING FREQ-MAX, PQCC16 |
| TPS61041DRV | 0.285 A SWITCHING REGULATOR, 1000 kHz SWITCHING FREQ-MAX, PDSO6 |
| TPS61040DBVRG4 | 0.45 A SWITCHING REGULATOR, 1000 kHz SWITCHING FREQ-MAX, PDSO5 |
相关代理商/技术参数 |
参数描述 |
|---|---|
| TPS61028 | 制造商:TI 制造商全称:Texas Instruments 功能描述:96% EFFICIENT SYNCHRONOUS BOOST CONVERTER |
| TPS61028DRC | 制造商:TI 制造商全称:Texas Instruments 功能描述:96% EFFICIENT SYNCHRONOUS BOOST CONVERTER |
| TPS61028DRCR | 功能描述:直流/直流开关调节器 Adj 800mA Switch Boost Converter RoHS:否 制造商:International Rectifier 最大输入电压:21 V 开关频率:1.5 MHz 输出电压:0.5 V to 0.86 V 输出电流:4 A 输出端数量: 最大工作温度: 安装风格:SMD/SMT 封装 / 箱体:PQFN 4 x 5 |
| TPS61028DRCR | 制造商:Texas Instruments 功能描述:DC/DC CONVERTER IC 制造商:Texas Instruments 功能描述:IC, SYNC BOOST CONVERTER, SON-10 |
| TPS61028DRCRG4 | 功能描述:直流/直流开关调节器 Adj 800mA Switch Boost Converter RoHS:否 制造商:International Rectifier 最大输入电压:21 V 开关频率:1.5 MHz 输出电压:0.5 V to 0.86 V 输出电流:4 A 输出端数量: 最大工作温度: 安装风格:SMD/SMT 封装 / 箱体:PQFN 4 x 5 |
发布紧急采购，3分钟左右您将得到回复。