- 您现在的位置：买卖IC网 > PDF目录69515 > TPS61040DRVTG4 (TEXAS INSTRUMENTS INC) 0.45 A SWITCHING REGULATOR, 1000 kHz SWITCHING FREQ-MAX, PDSO6 PDF资料下载
参数资料
| 型号： | TPS61040DRVTG4 |
| 厂商： | TEXAS INSTRUMENTS INC |
| 元件分类： | 稳压器 |
| 英文描述： | 0.45 A SWITCHING REGULATOR, 1000 kHz SWITCHING FREQ-MAX, PDSO6 |
| 封装： | 2 X 2 MM, 0.80 MM HEIGHT, GREEN, PLASTIC, SON-6 |
| 文件页数： | 4/27页 |
| 文件大小： | 779K |
| 代理商： | TPS61040DRVTG4 |
第1页第2页第3页当前第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页
DVout +
Iout
Cout
1
fS(Iout)
–
I
P
L
Vout ) Vd–Vin
) IP
ESR
SLVS413F – OCTOBER 2002 – REVISED DECEMBER 2010
www.ti.com
The larger the feedforward capacitor the worse the line regulation of the device. Therefore, when concern for line
regulation is paramount, the selected feedforward capacitor should be as small as possible. See the following
section for more information about line and load regulation.
LINE AND LOAD REGULATION
The line regulation of the TPS61040/41 depends on the voltage ripple on the feedback pin. Usually a 50 mV
peak-to-peak voltage ripple on the feedback pin FB gives good results.
Some applications require a very tight line regulation and can only allow a small change in output voltage over a
certain input voltage range. If no feedforward capacitor CFF is used across the upper resistor of the voltage
feedback divider, the device has the best line regulation. Without the feedforward capacitor the output voltage
ripple is higher because the TPS61040/41 shows output voltage bursts instead of single pulses on the switch pin
(SW), increasing the output voltage ripple. Increasing the output capacitor value reduces the output voltage
ripple.
If a larger output capacitor value is not an option, a feedforward capacitor CFF can be used as described in the
previous section. The use of a feedforward capacitor increases the amount of voltage ripple present on the
feedback pin (FB). The greater the voltage ripple on the feedback pin (
≥50 mV), the worse the line regulation.
There are two ways to improve the line regulation further:
1. Use a smaller inductor value to increase the switching frequency which will lower the output voltage ripple,
as well as the voltage ripple on the feedback pin.
2. Add a small capacitor from the feedback pin (FB) to ground to reduce the voltage ripple on the feedback pin
down to 50 mV again. As a starting point, the same capacitor value as selected for the feedforward capacitor
CFF can be used.
OUTPUT CAPACITOR SELECTION
For best output voltage filtering, a low ESR output capacitor is recommended. Ceramic capacitors have a low
ESR value but tantalum capacitors can be used as well, depending on the application.
Assuming the converter does not show double pulses or pulse bursts on the switch node (SW), the output
voltage ripple can be calculated as:
where:
L = Selected inductor value
Iout = Nominal load current
fS (Iout) = Switching frequency at the nominal load current as calculated previously
Vd = Rectifier diode forward voltage (typically 0.3 V)
Cout = Selected output capacitor
ESR = Output capacitor ESR value
(7)
See Table 5 and the typical applications section for choosing the output capacitor.
Table 5. Recommended Input and Output Capacitors
DEVICE
CAPACITOR
VOLTAGE RATING
COMPONENT SUPPLIER
COMMENTS
4.7 mF/X5R/0805
6.3 V
Tayo Yuden JMK212BY475MG
CIN/COUT
10 mF/X5R/0805
6.3 V
Tayo Yuden JMK212BJ106MG
CIN/COUT
TPS61040/41
1 mF/X7R/1206
25 V
Tayo Yuden TMK316BJ105KL
COUT
1 mF/X5R/1206
35 V
Tayo Yuden GMK316BJ105KL
COUT
4.7 mF/X5R/1210
25 V
Tayo Yuden TMK325BJ475MG
COUT
12
Copyright 2002–2010, Texas Instruments Incorporated
相关PDF资料 |
PDF描述 |
|---|---|
| TPS61041DRVR | 0.285 A SWITCHING REGULATOR, 1000 kHz SWITCHING FREQ-MAX, PDSO6 |
| TPS61059DRCTG4 | 1.8 A SWITCHING REGULATOR, 750 kHz SWITCHING FREQ-MAX, PDSO10 |
| TPS61070TDDCRQ1 | SWITCHING REGULATOR, PDSO6 |
| TPS61073DDCRG4 | 0.7 A BATTERY CHARGE CONTROLLER, 1440 kHz SWITCHING FREQ-MAX, PDSO6 |
| TPS61073DDC | 0.7 A BATTERY CHARGE CONTROLLER, 1440 kHz SWITCHING FREQ-MAX, PDSO6 |
相关代理商/技术参数 |
参数描述 |
|---|---|
| TPS61040EVM-001 | 功能描述:电源管理IC开发工具 TPS61040 Boost Conv Eval Mod RoHS:否 制造商:Maxim Integrated 产品:Evaluation Kits 类型:Battery Management 工具用于评估:MAX17710GB 输入电压: 输出电压:1.8 V |
| TPS61040EVM-002 | 功能描述:电源管理IC开发工具 TPS61040 Boost Conv Eval Mod RoHS:否 制造商:Maxim Integrated 产品:Evaluation Kits 类型:Battery Management 工具用于评估:MAX17710GB 输入电压: 输出电压:1.8 V |
| TPS61040-Q1 | 制造商:TI 制造商全称:Texas Instruments 功能描述:LOW POWER DC/DC BOOST CONVERTER IN SOT-23 PACKAGE |
| TPS61040QDBVRQ1 | 功能描述:LED照明驱动器 Auto Cat Low Pwr DC/DC Boost Cnvrtr RoHS:否 制造商:STMicroelectronics 输入电压:11.5 V to 23 V 工作频率: 最大电源电流:1.7 mA 输出电流: 最大工作温度: 安装风格:SMD/SMT 封装 / 箱体:SO-16N |
| TPS61041 | 制造商:TI 制造商全称:Texas Instruments 功能描述:LOW-POWER DC/DC BOOST CONVERTER IN SOT-23 AND SON PACKAGES |
发布紧急采购，3分钟左右您将得到回复。