- 您现在的位置：买卖IC网 > PDF目录98283 > TPS61045DRBTG4 (TEXAS INSTRUMENTS INC) 0.45 A SWITCHING REGULATOR, 1000 kHz SWITCHING FREQ-MAX, PDSO8 PDF资料下载
参数资料
| 型号： | TPS61045DRBTG4 |
| 厂商： | TEXAS INSTRUMENTS INC |
| 元件分类： | 稳压器 |
| 英文描述： | 0.45 A SWITCHING REGULATOR, 1000 kHz SWITCHING FREQ-MAX, PDSO8 |
| 封装： | 3 X 3 MM, GREEN, PLASTIC, SON-8 |
| 文件页数： | 3/21页 |
| 文件大小： | 582K |
| 代理商： | TPS61045DRBTG4 |
h
P
IN
load max
O
I
V
I
2
V
=
(
) (
)
2
L
2
400
h
P
IN
load max
O
I
P
IN
I
V
I
V
I
L
ns
V
=
+
300
100
2
IN
P
V
I
m A
ns
=
+
V
O(min) +
V
(FB)
R1
R2 )
1
V
O(max) +
V
(FB)
R1
R3 )
V
(FB)
R1
R2 )
1
V
O(step) +
19.6 mV
R1
R3
www.ti.com
SLVS440B – JANUARY 2003 – REVISED MARCH 2009
tf≤ 400 ns
with:
L = selected inductor value
h = expected converter efficiency (typically between 70% to 85%)
IP = peak current as described in the previous peak current control section.
The above formula contains the expected converter efficiency that allows calculating the expected maximum load
current the converter can support. The efficiency can be taken out of the efficiency graphs shown in Figures 2
and 3 or 80% can be used as a good estimation.
The selected inductor must have a saturation current which meets the maximum peak current of the converter as
calculated in the peak current control section. Use the maximum value for ILim (450mA) for this calculation.
Another important inductor parameter is the dc resistance. The lower the dc resistance, the higher the efficiency
of the converter. See Table 3 and the inductor selection section under typical applications.
Table 3. Possible Inductor Selection
INDUCTOR VALUE
COMPONENT SUPPLIER
COMMENTS
10 mH
Sumida CR32-100
High efficiency
10 mH
Sumida CDRH3D16-100
High efficiency
10 mH
Murata LQH43CN100K01
4.7 mH
Sumida CDRH3D16-4R7
Small solution size
4.7 mH
muRata LQH32CN4R7M51
Small solution size
SETTING THE OUTPUT VOLTAGE (see Figure 1)
When the converter is programmed to the minimum output voltage, the DAC output (DO) equals the reference
voltage of 1.233 V (typ). Therefore, only the feedback resistor network (R1) and (R2) determines the output
voltage under these conditions. This gives the minimum output voltage possible and can be calculated as:
The maximum output voltage is determined as the DAC output (DO) is set to 0 V:
The output voltage can be digitally programmed by pulling the CTRL pin low for a certain period of time as
described in the DIGITAL INTERFACE (CTRL) section. Pulling the signal applied to the CTRL pin low and again
high (for related timing see the ELECTRICAL CHARACTERISTICS) increases or decreases the DAC output DO
(pin 3) one-step where one step is typically 19.6 mV. A voltage step on DO of 19.6mV (typ) changes the output
voltage by one step and is calculated as:
The possible output voltage range is determined by selecting R1, R2 and R3. A possible larger output voltage
range gives a larger output voltage step size. The smaller the possible output voltage range, the smaller the
output voltage step size.
Copyright 2003–2009, Texas Instruments Incorporated
11
Product Folder Link(s): TPS61045
相关PDF资料 |
PDF描述 |
|---|---|
| TPS61045DRBR | 0.45 A SWITCHING REGULATOR, 1000 kHz SWITCHING FREQ-MAX, PDSO8 |
| TPS61080DRCR | 1 A SWITCHING REGULATOR, 1500 kHz SWITCHING FREQ-MAX, PDSO10 |
| TPS61081DRCTG4 | 1.3 A SWITCHING REGULATOR, 1500 kHz SWITCHING FREQ-MAX, PDSO10 |
| TPS61080DRCTG4 | 0.5 A SWITCHING REGULATOR, 1500 kHz SWITCHING FREQ-MAX, PDSO10 |
| TPS61093DSK | 1.5 A SWITCHING REGULATOR, 1400 kHz SWITCHING FREQ-MAX, PDSO10 |
相关代理商/技术参数 |
参数描述 |
|---|---|
| TPS61045EVM-231 | 功能描述:电源管理IC开发工具 TPS61045-231 Eval Mod RoHS:否 制造商:Maxim Integrated 产品:Evaluation Kits 类型:Battery Management 工具用于评估:MAX17710GB 输入电压: 输出电压:1.8 V |
| TPS61046EVM-682 | 功能描述:TPS61046 - DC/DC, Step Up 2, Non-Isolated Outputs Evaluation Board 制造商:texas instruments 系列:- 零件状态:有效 主要用途:DC/DC，步升 输出和类型:2，非隔离 功率 - 输出:- 电压 - 输出:12V，5 V ~ 28 V 电流 - 输出:100mA，20mA 电压 - 输入:1.8 V ~ 5.5 V 稳压器拓扑:升压 频率 - 开关:1MHz 板类型:完全填充 所含物品:板 使用的 IC/零件:TPS61046 标准包装:1 |
| TPS61046YFFR | 功能描述:LED 驱动器 IC 1 输出 DC DC 稳压器 升压（升压） 调光 1.2A（开关） 6-DSBGA 制造商:texas instruments 系列:- 包装:剪切带（CT） 零件状态:新产品 类型:DC DC 稳压器 拓扑:升压（升压） 内部开关:是 输出数:1 电压 - 供电（最低）:1.8V 电压 -?供电（最高）:5.5V 电压 - 输出:4.5 V ~ 28 V 电流 - 输出/通道:1.2A（开关） 频率:1.05MHz 调光:- 应用:- 工作温度:-40°C ~ 125°C （TJ） 安装类型:表面贴装 封装/外壳:6-UFBGA，DSBGA 供应商器件封装:6-DSBGA 标准包装:1 |
| TPS61046YFFT | 功能描述:LED 驱动器 IC 1 输出 DC DC 稳压器 升压（升压） 1.2A（开关） 6-DSBGA 制造商:texas instruments 系列:- 包装:剪切带（CT） 零件状态:有效 类型:DC DC 稳压器 拓扑:升压（升压） 内部开关:是 输出数:1 电压 - 供电（最低）:1.8V 电压 -?供电（最高）:5.5V 电压 - 输出:4.5 V ~ 28 V 电流 - 输出/通道:1.2A（开关） 频率:1.05MHz 调光:- 应用:- 工作温度:-40°C ~ 125°C （TJ） 安装类型:表面贴装 封装/外壳:6-UFBGA，DSBGA 供应商器件封装:6-DSBGA 标准包装:1 |
| TPS61050 | 制造商:TI 制造商全称:Texas Instruments 功能描述:1.2-A HIGH POWER WHITE LED DRIVER 2-MHz SYNCHRONOUS BOOST CONVERTER WITH I2C COMPATIBLE INTERFACE |
发布紧急采购，3分钟左右您将得到回复。