- 您现在的位置：买卖IC网 > PDF目录68613 > TPS62060DSGT (TEXAS INSTRUMENTS INC) 1.6 A SWITCHING REGULATOR, 3400 kHz SWITCHING FREQ-MAX, PDSO8 PDF资料下载
参数资料
| 型号： | TPS62060DSGT |
| 厂商： | TEXAS INSTRUMENTS INC |
| 元件分类： | 稳压器 |
| 英文描述： | 1.6 A SWITCHING REGULATOR, 3400 kHz SWITCHING FREQ-MAX, PDSO8 |
| 封装： | 2 X 2 MM, 0.75 MM HEIGHT, GREEN, PLASTIC, WSON-8 |
| 文件页数： | 6/26页 |
| 文件大小： | 1109K |
| 代理商： | TPS62060DSGT |
SLVSA95A
– MARCH 2010 – REVISED JANUARY 2011
The condition of the MODE pin can be changed during operation and allows efficient power management by
adjusting the operation mode of the converter to the specific system requirements.
ENABLE
The device is enabled by setting EN pin to high. At first, the internal reference is activated and the internal
analog circuits are settled. Afterwards, the soft start is activated and the output voltage is ramped up. The output
voltages reaches 95% of its nominal value within tSTARTof typically 500 s after the device has been enabled. The
EN input can be used to control power sequencing in a system with various DC/DC converters. The EN pin can
be connected to the output of another converter, to drive the EN pin high and getting a sequencing of supply
rails. With EN = GND, the device enters shutdown mode. In this mode, all circuits are disabled and the SW pin is
connected to PGND via an internal resistor to discharge the output.
SOFT START
The TPS62060 has an internal soft start circuit that controls the ramp up of the output voltage. Once the
converter is enabled and the input voltage is above the undervoltage lockout threshold VUVLOthe output voltage
ramps up from 5% to 95% of its nominal value within tRamp of typ. 250s.
This limits the inrush current in the converter during start up and prevents possible input voltage drops when a
battery or high impedance power source is used.
During soft start, the switch current limit is reduced to 1/3 of its nominal value ILIMF until the output voltage
reaches 1/3 of its nominal value. Once the output voltage trips this threshold, the device operates with its
nominal current limit ILIMF.
INTERNAL CURRENT LIMIT / FOLD-BACK CURRENT LIMIT FOR SHORT-CIRCUIT PROTECTION
During normal operation the High-Side and Low-Side MOSFET switches are protected by its current limits ILIMF.
Once the High-Side MOSFET switch reaches its current limit, it is turned off and the Low-Side MOSFET switch is
turned on. The High-Side MOSFET switch can only turn on again, once the current in the Low -Side MOSFET
switch decreases below its current limit ILIMF. The device is capable to provide peak inductor currents up to its
internal current limit ILIMF..
As soon as the switch current limits are hit and the output voltage falls below 1/3 of the nominal output voltage
due to overload or short circuit condition, the foldback current limit is enabled. In this case the switch current limit
is reduced to 1/3 of the nominal value ILIMF.
Due to the short-circuit protection is enabled during start-up, the device does not deliver more than 1/3 of its
nominal current limit ILIMF until the output voltage exceeds 1/3 of the nominal output voltage. This needs to be
considered when a load is connected to the output of the converter, which acts as a current sink.
CLOCK DITHERING
In order to reduce the noise level of switch frequency harmonics in the higher RF bands, the TPS62060 family
has a built-in clock-dithering circuit. The oscillator frequency is slightly modulated with a sub clock causing a
clock dither of typ. 6ns.
THERMAL SHUTDOWN
As soon as the junction temperature, TJ, exceeds 150°C (typical) the device goes into thermal shutdown. In this
mode, the High-Side and Low-Side MOSFETs are turned off. The device continues its operation when the
junction temperature falls below the thermal shutdown hysteresis.
14
2010–2011, Texas Instruments Incorporated
相关PDF资料 |
PDF描述 |
|---|---|
| TPS62063DSGT | 1.6 A SWITCHING REGULATOR, 3400 kHz SWITCHING FREQ-MAX, PDSO8 |
| TPS62110HPWP | 1.5 A SWITCHING REGULATOR, 1100 kHz SWITCHING FREQ-MAX, PDSO16 |
| TPS65001RUKT | 1.4 A SWITCHING REGULATOR, 2847 kHz SWITCHING FREQ-MAX, PQCC20 |
| TPS650003RTET | 1.4 A SWITCHING REGULATOR, 2847 kHz SWITCHING FREQ-MAX, PQCC16 |
| TPS650001RTET | 1.4 A SWITCHING REGULATOR, 2847 kHz SWITCHING FREQ-MAX, PQCC16 |
相关代理商/技术参数 |
参数描述 |
|---|---|
| TPS62060DSGT | 制造商:Texas Instruments 功能描述:STEP DOWN DC/DC CONVERTER IC |
| TPS62060EVM-663 | 功能描述:电源管理IC开发工具 TPS62060EVM-663 Eval Mod RoHS:否 制造商:Maxim Integrated 产品:Evaluation Kits 类型:Battery Management 工具用于评估:MAX17710GB 输入电压: 输出电压:1.8 V |
| TPS62061DSGR | 功能描述:直流/直流开关转换器 3MHz,1.6A Step-Down Converter RoHS:否 制造商:STMicroelectronics 最大输入电压:4.5 V 开关频率:1.5 MHz 输出电压:4.6 V 输出电流:250 mA 输出端数量:2 最大工作温度:+ 85 C 安装风格:SMD/SMT |
| TPS62061DSGT | 功能描述:直流/直流开关转换器 3MHz,1.6A Step-Down Converter RoHS:否 制造商:STMicroelectronics 最大输入电压:4.5 V 开关频率:1.5 MHz 输出电压:4.6 V 输出电流:250 mA 输出端数量:2 最大工作温度:+ 85 C 安装风格:SMD/SMT |
| TPS62063DSGR | 功能描述:直流/直流开关转换器 3MHz,1.6A Step-Down Converter RoHS:否 制造商:STMicroelectronics 最大输入电压:4.5 V 开关频率:1.5 MHz 输出电压:4.6 V 输出电流:250 mA 输出端数量:2 最大工作温度:+ 85 C 安装风格:SMD/SMT |
发布紧急采购，3分钟左右您将得到回复。