参数资料
型号: TPS62101DR
厂商: TEXAS INSTRUMENTS INC
元件分类: 稳压器
英文描述: 1.6 A SWITCHING REGULATOR, 750 kHz SWITCHING FREQ-MAX, PDSO8
封装: GREEN, SOIC-8
文件页数: 27/27页
文件大小: 537K
代理商: TPS62101DR
TPS62100, TPS62101, TPS62102, TPS62103
MULTIMODE LOW POWER BUCK CONVERTER
SLUS446B – MAY 2000 – REVISED DECEMBER 2000
9
POST OFFICE BOX 655303
DALLAS, TEXAS 75265
APPLICATION INFORMATION
shutdown and synchronization
The TPS6210x family incorporates a dual function shutdown and synchronization pin. Pulsing the SD/SYNC
pin higher than 1 V forces the internal oscillator to reset, allowing synchronization to an external signal source.
It is recommended that the part not be synchronized higher than two times its nominal operating frequency. The
reason for this is that synchronizing to a higher frequency causes the internal saw-tooth voltage to have less
amplitude. Since this is the signal that is compared to the error-amplifier output to determine the duty cycle, the
reduction in amplitude causes a corresponding increase in PWM gain as well as increased susceptibility to
noise. Doubling the operating frequency through synchronization effectively cuts the saw-tooth amplitude in
half, doubling the PWM gain.
Bringing the SD/SYNC pin high and holding it for more than 20
s forces the chip to enter a shutdown state.
This causes almost all sections of the chip to enter a dormant state to conserve power. Bringing this pin low
again allows the chip to resume operation, starting with a full soft-start cycle.
This pin must not be allowed to float, since there are no internal pulldown resistors. Floating this pin could cause
the device to operate erratically.
error amplifier
The internal error amplifier has a unity gain frequency of 3 MHz (typ). When designing a compensation network
for this chip, the response of the error amplifier may be a limiting consideration. This is especially true with the
1-MHz and 2-MHz switching frequencies. The phase and gain characteristics of the error amplifier are shown
in Figure 1.
Due to the method of sensing voltage thresholds in the variable-frequency mode, it is recommended that the
compensation loop use integral compensation (no dc path from the COMP pin to the FB pin) if the chip is allowed
to automatically switch between constant- and variable-frequency modes of operation. The reason for this is
to avoid dc offsets creeping into the sense point and changing the nominal output voltage in the
variable-frequency mode.
相关PDF资料
PDF描述
TPS62650YFFT 1.7 A SWITCHING REGULATOR, 6600 kHz SWITCHING FREQ-MAX, BGA9
TPS62651YFFT 1.7 A SWITCHING REGULATOR, 6600 kHz SWITCHING FREQ-MAX, BGA9
TPS62651YFF 1.7 A SWITCHING REGULATOR, 6600 kHz SWITCHING FREQ-MAX, BGA9
TPS62651YFFR 1.7 A SWITCHING REGULATOR, 6600 kHz SWITCHING FREQ-MAX, BGA9
TPS62650YFFR 1.7 A SWITCHING REGULATOR, 6600 kHz SWITCHING FREQ-MAX, BGA9
相关代理商/技术参数
参数描述
TPS62101DRG4 功能描述:直流/直流开关调节器 Multimd 600kHz Sync Sync Buck Converter RoHS:否 制造商:International Rectifier 最大输入电压:21 V 开关频率:1.5 MHz 输出电压:0.5 V to 0.86 V 输出电流:4 A 输出端数量: 最大工作温度: 安装风格:SMD/SMT 封装 / 箱体:PQFN 4 x 5
TPS62102D 功能描述:直流/直流开关调节器 Multimode 1MHz Sync Sync Buck Converter RoHS:否 制造商:International Rectifier 最大输入电压:21 V 开关频率:1.5 MHz 输出电压:0.5 V to 0.86 V 输出电流:4 A 输出端数量: 最大工作温度: 安装风格:SMD/SMT 封装 / 箱体:PQFN 4 x 5
TPS62102DG4 功能描述:直流/直流开关调节器 Multimode 1MHz Synch Buck Converter RoHS:否 制造商:International Rectifier 最大输入电压:21 V 开关频率:1.5 MHz 输出电压:0.5 V to 0.86 V 输出电流:4 A 输出端数量: 最大工作温度: 安装风格:SMD/SMT 封装 / 箱体:PQFN 4 x 5
TPS62102DR 功能描述:开关变换器、稳压器与控制器 Multimode 1MHz Sync Sync Buck Converter RoHS:否 制造商:Texas Instruments 输出电压:1.2 V to 10 V 输出电流:300 mA 输出功率: 输入电压:3 V to 17 V 开关频率:1 MHz 工作温度范围: 安装风格:SMD/SMT 封装 / 箱体:WSON-8 封装:Reel
TPS62102DRG4 功能描述:开关变换器、稳压器与控制器 Multimode 1MHz Sync Sync Buck Converter RoHS:否 制造商:Texas Instruments 输出电压:1.2 V to 10 V 输出电流:300 mA 输出功率: 输入电压:3 V to 17 V 开关频率:1 MHz 工作温度范围: 安装风格:SMD/SMT 封装 / 箱体:WSON-8 封装:Reel