- 您现在的位置：买卖IC网 > PDF目录68613 > TPS62110HPWP (TEXAS INSTRUMENTS INC) 1.5 A SWITCHING REGULATOR, 1100 kHz SWITCHING FREQ-MAX, PDSO16 PDF资料下载
参数资料
| 型号： | TPS62110HPWP |
| 厂商： | TEXAS INSTRUMENTS INC |
| 元件分类： | 稳压器 |
| 英文描述： | 1.5 A SWITCHING REGULATOR, 1100 kHz SWITCHING FREQ-MAX, PDSO16 |
| 封装： | GREEN, PLASTIC, DSO-16 |
| 文件页数： | 8/25页 |
| 文件大小： | 0K |
| 代理商： | TPS62110HPWP |
f
L
I
V
O
V
O
V
L
I
-
=
D
1
2
m
a x
m
a x
L
I
O
I
L
I
D
+
=
SLVSAO9B
– DECEMBER 2010 – REVISED FEBRUARY 2011
Table 2. Advantages and Disadvantages When Designing the Inductor and Output Capacitor
INFLUENCE ON STABILITY
ADVANTAGE
DISADVANTAGE
Less output voltage ripple
Increase Cout (
>22 F)
Uncritical
None
Less output voltage overshoot /
undershoot during load transient
Higher output voltage ripple
Critical
High output voltage overshoot /
Decrease Cout (
<22 F)
Increase inductor value
>6.8 H
None
undershoot during load
also
transient
Less gain and phase margin
Less inductor current ripple
More energy stored in the
inductor
→ higher voltage
overshoot during load transient
Higher dc output current possible if
Smaller current rise
→ higher
Increase L (
>6.8 H)
Uncritical
operated close to the current limit
voltage undershoot during load
transient
→ do not decrease the
value of Cout due to these
effects
Critical
High inductor current ripple
Small voltage overshoot / undershoot
especially at high input voltage
Decrease L (
<6.8 H)
Increase output capacitor value
>
during load transient
and low output voltage
22
F also
As it is shown in Table 2, the inductor value can be increased to higher values. For good performance, the
peak-to-peak inductor current ripple should be less than 30% of the maximum dc output current. Especially at
input voltages above 12 V, it makes sense to increase the inductor value to keep the inductor current ripple low.
In such applications, the inductor value can be increased to 10
H or 22 H. Values above 22 H should be
avoided to keep the voltage overshoot during load transient in an acceptable range.
After choosing the inductor value, two additional inductor parameters should be considered:
1. current rating of the inductor
2. dc resistance
The dc resistance of the inductance directly influences the efficiency of the converter. Therefore, an inductor with
lowest dc resistance should be selected for highest efficiency. To avoid saturation of the inductor, the inductor
should be rated at least for the maximum output current plus the inductor ripple current which is calculated as:
(3)
Where:
f = Switching frequency (1000 kHz typical)
L = Inductor value
ΔIL = Peak-to-peak inductor ripple current
IL(max) = Maximum inductor current
The highest inductor current occurs at maximum VI. A more conservative approach is to select the inductor
current rating just for the maximum switch current of the TPS62110, which is 2.4 A (typically). See Table 1 for
recommended inductors.
OUTPUT CAPACITOR SELECTION
A 22-
μF (typical) output capacitor is needed with a 6.8 μH inductor. For an output voltage greater than 5 V, a
33-
μF (minimum) output capacitor is required for stability. For best performance, a low ESR ceramic output
capacitor is needed.
The RMS ripple current is calculated as:
16
2010–2011, Texas Instruments Incorporated
Product Folder Link(s): TPS62110-HT
相关PDF资料 |
PDF描述 |
|---|---|
| TPS65001RUKT | 1.4 A SWITCHING REGULATOR, 2847 kHz SWITCHING FREQ-MAX, PQCC20 |
| TPS650003RTET | 1.4 A SWITCHING REGULATOR, 2847 kHz SWITCHING FREQ-MAX, PQCC16 |
| TPS650001RTET | 1.4 A SWITCHING REGULATOR, 2847 kHz SWITCHING FREQ-MAX, PQCC16 |
| TPS650061RUKT | 1.68 A SWITCHING REGULATOR, 2847 kHz SWITCHING FREQ-MAX, PQCC20 |
| TPS65000RTE | 1.4 A SWITCHING REGULATOR, 2847 kHz SWITCHING FREQ-MAX, PQCC16 |
相关代理商/技术参数 |
参数描述 |
|---|---|
| TPS62110MRSAREP | 功能描述:直流/直流开关调节器 Mil Enh 17V 1.5A Synch Step-Down Conv RoHS:否 制造商:International Rectifier 最大输入电压:21 V 开关频率:1.5 MHz 输出电压:0.5 V to 0.86 V 输出电流:4 A 输出端数量: 最大工作温度: 安装风格:SMD/SMT 封装 / 箱体:PQFN 4 x 5 |
| TPS62110QRSAREP | 功能描述:IC REG BUCK SYNC ADJ 1.5A 16QFN RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 开关稳压器 系列:- 标准包装:20 系列:SIMPLE SWITCHER® 类型:降压（降压） 输出类型:固定 输出数:1 输出电压:12V 输入电压:4 V ~ 60 V PWM 型:电压模式 频率 - 开关:52kHz 电流 - 输出:1A 同步整流器:无 工作温度:-40°C ~ 125°C 安装类型:通孔 封装/外壳:16-DIP（0.300"，7.62mm） 包装:管件 供应商设备封装:16-DIP 其它名称:*LM2575HVN-12LM2575HVN-12 |
| TPS62110QRSARQ1 | 功能描述:直流/直流开关转换器 AC Adj,1.5A,17V Vin Step-Down Converter RoHS:否 制造商:STMicroelectronics 最大输入电压:4.5 V 开关频率:1.5 MHz 输出电压:4.6 V 输出电流:250 mA 输出端数量:2 最大工作温度:+ 85 C 安装风格:SMD/SMT |
| TPS62110RSA | 制造商:Texas Instruments 功能描述: |
| TPS62110RSAR | 功能描述:直流/直流开关调节器 Adj 1.5-A 17-V Vin Step-Down Converter RoHS:否 制造商:International Rectifier 最大输入电压:21 V 开关频率:1.5 MHz 输出电压:0.5 V to 0.86 V 输出电流:4 A 输出端数量: 最大工作温度: 安装风格:SMD/SMT 封装 / 箱体:PQFN 4 x 5 |
发布紧急采购，3分钟左右您将得到回复。