- 您现在的位置：买卖IC网 > PDF目录14374 > TPS62236DRYR (Texas Instruments)IC REG BUCK SYNC 1.85V 0.5A 6SON PDF资料下载
参数资料
| 型号： | TPS62236DRYR |
| 厂商： | Texas Instruments |
| 文件页数： | 21/35页 |
| 文件大小： | 0K |
| 描述： | IC REG BUCK SYNC 1.85V 0.5A 6SON |
| 标准包装： | 5,000 |
| 类型： | 降压（降压） |
| 输出类型： | 固定 |
| 输出数： | 1 |
| 输出电压： | 1.85V |
| 输入电压： | 2.05 V ~ 6 V |
| PWM 型： | 电压模式 |
| 频率 - 开关： | 2MHz |
| 电流 - 输出： | 500mA |
| 同步整流器： | 是 |
| 工作温度： | -40°C ~ 85°C |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 6-UFDFN |
| 包装： | 带卷 (TR) |
| 供应商设备封装： | 6-SON（1.45x1） |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页当前第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页第32页第33页第34页第35页
TPS62230, TPS62231, TPS62232, TPS62233, TPS62234, TPS62235, TPS62236
TPS62237, TPS62238, TPS62239, TPS622310, TPS622311, TPS622312
TPS622313, TPS622314, TPS622315, TPS622316, TPS622317, TPS622318
SLVS941E – APRIL 2009 – REVISED DECEMBER 2010
FORCED PWM MODE
Pulling the MODE pin high forces the converter to operate in a continuous conduction PWM mode even at light
load currents. The advantage is that the converter operates with a quasi fixed frequency that allows simple
filtering of the switching frequency for noise-sensitive applications. In this mode, the efficiency is lower compared
to the power-save mode during light loads.
For additional flexibility, it is possible to switch from power-save mode to forced PWM mode during operation.
This allows efficient power management by adjusting the operation of the converter to the specific system
requirements.
100% DUTY CYCLE LOW DROPOUT OPERATION
The device starts to enter 100% duty cycle mode once the input voltage comes close to the nominal output
voltage. In order to maintain the output voltage, the High Side switch is turned on 100% for one or more cycles.
With further decreasing V IN the High Side MOSFET switch is turned on completely. In this case the converter
offers a low input-to-output voltage difference. This is particularly useful in battery-powered applications to
achieve longest operation time by taking full advantage of the whole battery voltage range.
The minimum input voltage to maintain regulation depends on the load current and output voltage, and can be
calculated as:
V IN min = V OUT max + I OUT max ′ ( R DS(on) max+ R L
)
(4)
With:
I OUT max = maximum output current plus inductor ripple current
R DS(on) max = maximum P-channel switch RDSon.
R L = DC resistance of the inductor
V OUT max = nominal output voltage plus maximum output voltage tolerance
UNDER VOLTAGE LOCKOUT
The under voltage lockout circuit prevents the device from misoperation at low input voltages. It prevents the
converter from turning on the switch or rectifier MOSFET under undefined conditions. The TPS6223X devices
have a UVLO threshold set to 1.8V (typical). Fully functional operation is permitted for input voltage down to the
falling UVLO threshold level. The converter starts operation again once the input voltage trips the rising UVLO
threshold level.
SOFT START
The TPS6223X has an internal soft-start circuit that controls the ramp up of the output voltage and limits the
inrush current during start-up. This limits input voltage drops when a battery or a high-impedance power source
is connected to the input of the converter.
The soft-start system generates a monotonic ramp up of the output voltage and reaches the nominal output
voltage typically 100 μ s after EN pin was pulled high.
Should the output voltage not have reached its target value by this time, such as in the case of heavy load, the
converter then operates in a current limit mode set by its switch current limits.
TPS6223X is able to start into a pre-biased output capacitor. The converter starts with the applied bias voltage
and ramps the output voltage to its nominal value.
ENABLE / SHUTDOWN
The device starts operation when EN is set high and starts up with the soft start as previously described. For
proper operation, the EN pin must be terminated and must not be left floating.
Pulling the EN pin low forces the device into shutdown, with a shutdown quiescent current of typically 0.1 μ A. In
this mode, the P and N-channel MOSFETs are turned off, the internal resistor feedback divider is disconnected,
and the entire internal-control circuitry is switched off.
Copyright ? 2009–2010, Texas Instruments Incorporated
21
相关PDF资料 |
PDF描述 |
|---|---|
| MC33063APE4 | IC REG BUCK BOOST INV ADJ 8DIP |
| LNT2G221MSEC | CAP ALUM 220UF 400V 20% SCREW |
| GSA14DTAS | CONN EDGECARD 28POS R/A .125 SLD |
| MAX6805US28D1+T | IC RESET MPU LOW PWR SOT143-4 |
| MCP1603T-150I/OS | IC REG BUCK SYNC 1.5V TSOT23-5 |
相关代理商/技术参数 |
参数描述 |
|---|---|
| TPS62236DRYT | 功能描述:直流/直流开关转换器 3MHz,500mA Step- Down Converter RoHS:否 制造商:STMicroelectronics 最大输入电压:4.5 V 开关频率:1.5 MHz 输出电压:4.6 V 输出电流:250 mA 输出端数量:2 最大工作温度:+ 85 C 安装风格:SMD/SMT |
| TPS62236EVM-574 | 功能描述:电源管理IC开发工具 TPS62236 Eval Mod RoHS:否 制造商:Maxim Integrated 产品:Evaluation Kits 类型:Battery Management 工具用于评估:MAX17710GB 输入电压: 输出电压:1.8 V |
| TPS62237DRYR | 功能描述:直流/直流开关转换器 3MHz,500mA Step- Down Converter RoHS:否 制造商:STMicroelectronics 最大输入电压:4.5 V 开关频率:1.5 MHz 输出电压:4.6 V 输出电流:250 mA 输出端数量:2 最大工作温度:+ 85 C 安装风格:SMD/SMT |
| TPS62237DRYT | 功能描述:直流/直流开关调节器 3MHz,500mA Step- Down Converter RoHS:否 制造商:International Rectifier 最大输入电压:21 V 开关频率:1.5 MHz 输出电压:0.5 V to 0.86 V 输出电流:4 A 输出端数量: 最大工作温度: 安装风格:SMD/SMT 封装 / 箱体:PQFN 4 x 5 |
| TPS62238DRYR | 功能描述:直流/直流开关转换器 3MHz 500mA Step- Down Converter RoHS:否 制造商:STMicroelectronics 最大输入电压:4.5 V 开关频率:1.5 MHz 输出电压:4.6 V 输出电流:250 mA 输出端数量:2 最大工作温度:+ 85 C 安装风格:SMD/SMT |
发布紧急采购，3分钟左右您将得到回复。